Poulan PPH20K46 Check Tire Pressure, Check Deck Levelness, Check for Proper Position of ALL Belts

Page 6

ASSEMBLY

NOTE: You may now roll your tractor off the skid. Follow the instructions below to remove the tractor from the skid.

WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

TO ROLL TRACTOR OFF SKID (See Operation section for location and function of controls)

Raise attachment lift lever to its highest position.

Releaseparkingbrakebydepressingclutch/brakepedal.

Place freewheel control in "transmission disengaged" position (See “TO TRANSPORT” in the Operation section of this manual).

Roll tractor forward off skid.

Remove banding holding the deflector shield up against tractor.

Continue with the instructions that follow.

CHECK TIRE PRESSURE

The tires on your tractor were overinflated at the factory for shipping purposes. Correct tire pressure is important for best cutting performance.

Reduce tire pressure to PSI shown on tires.

CHECK DECK LEVELNESS

For best cutting results, mower housing should be prop- erly leveled. See “TO LEVEL MOWER HOUSING” in the Service and Adjustments section of this manual.

CHECK FOR PROPER POSITION OF ALL BELTS

See the figures that are shown for replacing motion and mower blade drive belts in the Service and Adjustments section of this manual. Verify that the belts are routed correctly.

CHECK BRAKE SYSTEM

After you learn how to operate your tractor, check to see that the brake is operating properly. See “TO CHECK BRAKE” in the Service and Adjustments section of this manual.

CHECKLIST

BEFORE YOU OPERATE YOUR NEW TRACTOR, WE WISH TO ASSURE THAT YOU RECEIVE THE BEST PERFORMANCE AND SATISFACTION FROM THIS QUALITY PRODUCT.

PLEASE REVIEW THE FOLLOWING CHECKLIST:

All assembly instructions have been completed.

No remaining loose parts in carton.

Battery is properly prepared and charged.

Seat is adjusted comfortably and tightened securely.

All tires are properly inflated. (For shipping purposes, the tires were overinflated at the factory).

Be sure mower deck is properly leveled side-to-side/ front-to-rear for best cutting results. (Tires must be properly inflated for leveling).

Check mower and drive belts. Be sure they are routed properly around pulleys and inside all belt keepers.

Check wiring. See that all connections are still secure and wires are properly clamped.

Before driving tractor, be sure freewheel control is in “transmission engaged” position (see “TO TRANS- PORT” in the Operation section of this manual).

WHILE LEARNING HOW TO USE YOUR TRACTOR, PAY EXTRA ATTENTION TO THE FOLLOWING IMPORTANT ITEMS:

Engine oil is at proper level.

Fuel tank is filled with fresh, clean, regular unleaded gasoline.

Become familiar with all controls, their location and function. Operate them before you start the engine.

Be sure brake system is in safe operating condition.

Be sure Operator Presence System and Reverse Op- eration System (ROS) are working properly (See the Operation and Maintenance sections in this manual).

It is important to purge the transmission before operat- ing your tractor for the first time. Follow proper starting and transmission purging instructions (See “TO START ENGINE” and “PURGE TRANSMISSION” in the Opera- tion section of this manual).

6

Image 6
Contents PPH20K46 ModelGeneral Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceGeneral Service IV. TowingTable of Contents Unassembled Parts AssemblyTools Required for Assembly To Remove Tractor from CartonCheck for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor H ETo USE Throttle Control D See Fig HOW to USE Your TractorTo SET Parking Brake See Fig Stopping See FigTo USE Cruise Control J See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Operate MowerTo Operate on Hills Before Starting the EngineReverse Operation System ROS To Transport See FigsTo Start Engine See Fig Service REMINDER/HOUR MeterADD Gasoline Automatic Transmission Warm UPMowing Tips Purge TransmissionRunning Maintenance Lubrication ChartBlade Care BatteryTractor Blade Removal See FigEngine Muffler CleaningEngine OIL Filter Spark PlugsService and Adjustments To Install Mower See FigTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower Turn nut right Turn nut left To raise mower To lower mowerTo Replace Motion Drive Belt See Fig Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Check BrakeFront Wheel TOE-IN/CAMBER To Start Engine with a Weak Battery See FigReplacing Battery See Fig To Remove Wheel for Repairs See FigTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbFuel System StorageOther Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Suggested Guide for Sighting Slopes for Safe Operation Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés Dépannage DE Guide Correction Cause ProblèmeLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage MoteurTracteur Reglages ET Revision Starter DU Commande LA Régler PourGAZ DES Commande LA DE Câble LE Régler Pour Carburateur LE Régler PourAvant Fig la Voir Batterie LA ReplacerFig la Voir Tionsrapa RÉ LES Pour Roues LES Enlever PourFig la Voir Réglages ET RévisionFig la Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl Pour Courroie Acer Rempl Pour27 .Fig Tondeuse LA Niveau LE Ajuster Pour28 .Fig 26 .Fig21 .Fig 24 .Fig23 .Fig 20 .Fig19 .Fig Fig VoirTondeuse LA Enlever Pour Réglages OU SionsEntretien Fig La Voir Coupe DE Plateau DU Lavage DE Raccord’ALLUMAGE Bougie ’AIR Tamis LE Nettoyer Moteur DE D’HUILE FiltreAIR À Filtre Sionmistrans LA DE Moteur FluidePneus Fig la Voir Lame LA EnleverLames DES Entretien Frein DU FonctionnementLubrification DE Tableau Recommandations LESGénérales Utilisation Chaque AvantTransmission LA Purger UtilisationTondre DE Conseils 12 .Fig’ENTRETIEN/HOROMÈTRE Indicateur Moteur LE Démarrer Pour’ESSENCE Réservoir LE Remplir QuetimaautoMoteur LE Démarrer DE Avant 11 et 3 .Fig les VoirMAR EN Fonctionnement DE Système Tondeuse LA Utiliser Pour Fig la Voir J Vitesse DE Régulateur LE Utiliser CommentTondeuse DE Lames LES Arrêter Pour Jauge DE Roues LES Régler PourReculer Pour ET Avancer Pour GAZ DES Commande LA Utiliser PourFig la Voir Mentnetionsta DE Frein LE Engager Pour MoteurUtilisation ’EMBRAYAGE Montage Desmancom des fonction la etTionsec la Voir Rouler Faisant LE EN TE LE Pour Exigés Outils LES Montées NON PiécesTracteur Votre DE Getamon Fig la Voir Batterie LA VérifierSommaire Client DU ResponsabilitésProduit DE Spécifications Enfants EntretienRemorquage Général EntretienGénéral Fonctionnement PentesLES Dans Fonctionnement Tracteurs des sécurité toute en l’utilisation pour ConseilsAvertissement

PPH20K46 specifications

The Poulan PPH20K46 is a robust and versatile riding lawn mower designed for homeowners with larger gardens or properties that require efficient mowing. This powerful machine features an ergonomic design and advanced technologies that make lawn care simpler and more enjoyable.

At the heart of the Poulan PPH20K46 is its 46-inch cutting deck, which allows for a wide cutting path, reducing the number of passes needed to complete the mowing task. This feature is ideal for covering large areas quickly while maintaining an even and precise cut. The cutting height can be easily adjusted, providing versatility in lawn care. Users can select from different cutting heights, ensuring optimal results whether the grass is tall or short.

Powered by a reliable 20 horsepower Briggs & Stratton engine, the PPH20K46 delivers ample power to tackle dense grass and tough terrain. The engine is designed for durability and efficiency, ensuring that you spend less time on maintenance and more time enjoying your beautifully manicured lawn. Additionally, the electric start feature adds convenience, allowing users to start the mower with the simple push of a button.

One of the standout characteristics of the Poulan PPH20K46 is its hydrostatic transmission. This technology allows for smooth and seamless operation without the need for shifting gears. Users can easily adjust their speed on the fly, making maneuvering around obstacles or tight corners a breeze. The fully adjustable seat and steering wheel offer customizable comfort, enabling users to find the perfect position for optimal control and visibility.

For those who value cleanliness in lawn care, the mower is equipped with a washout port on the deck. This allows for easy cleaning after mowing, ensuring that grass clippings do not accumulate and impact the performance of the cutting deck.

In terms of aesthetics, the PPH20K46 offers a sleek design that is both functional and appealing. The bright yellow color is not only distinctive but also enhances visibility, ensuring that the mower is easily seen while in use.

Overall, the Poulan PPH20K46 combines power, efficiency, and comfort, making it an excellent choice for homeowners looking to maintain their lawns effortlessly. With its array of features and technology, it stands out as a reliable companion for any lawn care regimen. Whether you are tackling large swaths of grass or navigating intricate landscaping, the PPH20K46 is engineered to meet the demands of modern mowing.