Poulan PPH20K46 manual HOW to USE Your Tractor, To SET Parking Brake See Fig, Stopping See Fig

Page 9

OPERATION

The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your tractor or performing any adjustments or repairs. We recommend standard safety glasses or a wide vision safety mask worn over spectacles.

HOW TO USE YOUR TRACTOR

TO SET PARKING BRAKE (See Fig. 4)

Your tractor is equipped with an operator presence sens- ing switch. When engine is running, any attempt by the operator to leave the seat without first setting the parking brake will shut off the engine.

Depress brake pedal (B) all the way down and hold.

Pull parking brake lever (C) up and hold, release pres- sure from brake pedal (B), then release parking brake lever. Pedal should remain in brake position. Make sure parking brake will hold tractor secure.

C

B

Fig. 4

Turn ignition key (F) to “STOP” position and remove key. Always remove key when leaving tractor to prevent unauthorized use.

Never use the choke to stop the engine.

IMPORTANT: LEAVING THE IGNITION SWITCH IN ANY POSITION OTHER THAN "STOP" WILL CAUSE THE BATTERY TO BE DISCHARGED, (DEAD).

NOTE: Under certain conditions when tractor is standing idle with the engine running, hot engine exhaust gases may cause “browning” of grass. To eliminate this possibility, al- ways stop engine when stopping tractor on grass areas.

CAUTION: Always stop tractor com- pletely, as described above, and set parking brake before leaving the opera- tor's position.

TO USE THROTTLE CONTROL (D) (See Fig. 6)

Always operate engine at full speed (fast).

Operating engine at less than full speed (fast) reduces the engine's operating efficiency.

Full speed (fast) offers the best mower performance.

STOPPING (See Fig. 5)

MOWER BLADES -

To stop mower blades, place attachment clutch control in the “DISENGAGED” position ().

 

 

 

 

(

 

) ATTACHMENT

( ) ATTACHMENT

 

 

 

 

CLUTCH LEVER

CLUTCH LEVER

 

 

“DISENGAGED”

“ENGAGED”

 

 

 

 

Fig. 6

GROUND DRIVE -

To stop ground drive, depress brake pedal into full “BRAKE” position.

IMPORTANT: FORWARD AND REVERSE DRIVE PEDALS RETURN TO NEUTRAL POSITION WHEN NOT DEPRESSED.

ENGINE -

Move throttle control (D) between half and full speed (fast) position.

NOTE: Failure to move throttle control between half and full

 

speed (fast) position, before stopping may cause engine

 

to “backfire”.

9

 

D

F

Fig. 6

TO MOVE FORWARD AND BACKWARD (See Fig. 7)

The direction and speed of movement is controlled by the forward and reverse drive pedals.

Start tractor and release parking brake.

Slowly depress forward (K) or reverse (L) drive pedal to begin movement. Ground speed increases the further down the pedal is depressed.

K

J

L

Fig. 7

Image 9
Contents Model PPH20K46Safe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationGeneral Service ServiceIII. Children IV. TowingTable of Contents Tools Required for Assembly AssemblyUnassembled Parts To Remove Tractor from CartonCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation H E Know Your TractorTo SET Parking Brake See Fig HOW to USE Your TractorTo USE Throttle Control D See Fig Stopping See FigTo Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigTo USE Cruise Control J See Fig To Operate MowerReverse Operation System ROS Before Starting the EngineTo Operate on Hills To Transport See FigsADD Gasoline Service REMINDER/HOUR MeterTo Start Engine See Fig Automatic Transmission Warm UPMowing Tips Purge TransmissionRunning Lubrication Chart MaintenanceTractor BatteryBlade Care Blade Removal See FigEngine Engine OIL Filter CleaningMuffler Spark PlugsService and Adjustments To Install Mower See FigTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G Turn nut right Turn nut left To raise mower To lower mower To Level MowerTo Replace Mower Blade Drive Belt See Fig Belt InstallationTo Replace Motion Drive Belt See Fig To Check BrakeReplacing Battery See Fig To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbOther StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine dies when Suggested Guide for Sighting Slopes for Safe Operation Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés Correction Cause Problème Dépannage DE GuideLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage MoteurTracteur GAZ DES Commande LA DE Câble LE Régler Pour Starter DU Commande LA Régler PourReglages ET Revision Carburateur LE Régler PourFig la Voir Tionsrapa Fig la Voir Batterie LA ReplacerAvant RÉ LES Pour Roues LES Enlever PourFig la Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl Pour Réglages ET RévisionFig la Voir Courroie Acer Rempl Pour28 .Fig Tondeuse LA Niveau LE Ajuster Pour27 .Fig 26 .Fig23 .Fig 24 .Fig21 .Fig 20 .FigTondeuse LA Enlever Pour Fig Voir19 .Fig Réglages OU SionsEntretien Fig La Voir Coupe DE Plateau DU Lavage DE Raccord’ALLUMAGE Bougie AIR À Filtre Moteur DE D’HUILE Filtre’AIR Tamis LE Nettoyer Sionmistrans LA DE Moteur FluideLames DES Entretien Fig la Voir Lame LA EnleverPneus Frein DU FonctionnementGénérales Recommandations LESLubrification DE Tableau Utilisation Chaque AvantTondre DE Conseils UtilisationTransmission LA Purger 12 .Fig’ESSENCE Réservoir LE Remplir Moteur LE Démarrer Pour’ENTRETIEN/HOROMÈTRE Indicateur QuetimaautoMoteur LE Démarrer DE Avant 11 et 3 .Fig les VoirMAR EN Fonctionnement DE Système Tondeuse DE Lames LES Arrêter Pour Fig la Voir J Vitesse DE Régulateur LE Utiliser CommentTondeuse LA Utiliser Pour Jauge DE Roues LES Régler PourFig la Voir Mentnetionsta DE Frein LE Engager Pour GAZ DES Commande LA Utiliser PourReculer Pour ET Avancer Pour MoteurUtilisation ’EMBRAYAGE Montage Desmancom des fonction la etTionsec la Voir Rouler Faisant LE EN TE Tracteur Votre DE Getamon Montées NON PiécesLE Pour Exigés Outils LES Fig la Voir Batterie LA VérifierSommaire Client DU ResponsabilitésProduit DE Spécifications Remorquage EntretienEnfants Général EntretienLES Dans Fonctionnement PentesGénéral Fonctionnement Tracteurs des sécurité toute en l’utilisation pour ConseilsAvertissement

PPH20K46 specifications

The Poulan PPH20K46 is a robust and versatile riding lawn mower designed for homeowners with larger gardens or properties that require efficient mowing. This powerful machine features an ergonomic design and advanced technologies that make lawn care simpler and more enjoyable.

At the heart of the Poulan PPH20K46 is its 46-inch cutting deck, which allows for a wide cutting path, reducing the number of passes needed to complete the mowing task. This feature is ideal for covering large areas quickly while maintaining an even and precise cut. The cutting height can be easily adjusted, providing versatility in lawn care. Users can select from different cutting heights, ensuring optimal results whether the grass is tall or short.

Powered by a reliable 20 horsepower Briggs & Stratton engine, the PPH20K46 delivers ample power to tackle dense grass and tough terrain. The engine is designed for durability and efficiency, ensuring that you spend less time on maintenance and more time enjoying your beautifully manicured lawn. Additionally, the electric start feature adds convenience, allowing users to start the mower with the simple push of a button.

One of the standout characteristics of the Poulan PPH20K46 is its hydrostatic transmission. This technology allows for smooth and seamless operation without the need for shifting gears. Users can easily adjust their speed on the fly, making maneuvering around obstacles or tight corners a breeze. The fully adjustable seat and steering wheel offer customizable comfort, enabling users to find the perfect position for optimal control and visibility.

For those who value cleanliness in lawn care, the mower is equipped with a washout port on the deck. This allows for easy cleaning after mowing, ensuring that grass clippings do not accumulate and impact the performance of the cutting deck.

In terms of aesthetics, the PPH20K46 offers a sleek design that is both functional and appealing. The bright yellow color is not only distinctive but also enhances visibility, ensuring that the mower is easily seen while in use.

Overall, the Poulan PPH20K46 combines power, efficiency, and comfort, making it an excellent choice for homeowners looking to maintain their lawns effortlessly. With its array of features and technology, it stands out as a reliable companion for any lawn care regimen. Whether you are tackling large swaths of grass or navigating intricate landscaping, the PPH20K46 is engineered to meet the demands of modern mowing.