Poulan 173282, PPR1742STC owner manual To Level Mower Housing, FRONT-TO-BACK Adjustment See Figs

Page 19

SERVICE AND ADJUSTMENTS

TO LEVEL MOWER HOUSING

Adjust the mower while tractor is parked on level ground or driveway. Make sure tires are properly inflated (See “PROD- UCT SPECIFICATIONS” section of this manual). If tires are over or underinflated, you will not properly adjust your mower.

SIDE-TO-SIDE ADJUSTMENT (See Figs. 19 and 20)

•Raise mower to its highest position.

•At the midpoint of both sides of mower, measure height from bottom edge of mower to ground. Distance “A” on both sides of mower should be the same or within 1/4" of each other.

•If adjustment is necessary, make adjustment on one side of mower only.

•To raise one side of mower, tighten lift link adjustment nut on that side.

•To lower one side of mower, loosen lift link adjustment nut on that side.

NOTE: Each full turn of adjustment nut will change mower height about 1/8".

•Recheck measurements after adjusting.

BOTTOM EDGE

 

BOTTOM EDGE

OF MOWER TO

 

OF MOWER TO

GROUND

 

GROUND

A

GROUND LINE

A

FIG. 19

SUSPENSION

ARM

LIFT LINK

ADJUSTMENT NUT

FIG. 20

FRONT-TO-BACK ADJUSTMENT (See Figs. 21 and 22)

IMPORTANT: DECK MUST BE LEVEL SIDE-TO-SIDE. IF THE FOLLOWING FRONT-TO-BACK ADJUSTMENT IS NECESSARY, BE SURE TO ADJUST BOTH FRONT LINKS EQUALLY SO MOWER WILL STAY LEVEL SIDE-TO- SIDE.

To obtain the best cutting results, the mower housing should be adjusted so that the front is approximately 1/8" to 1/2" lower than the rear when the mower is in its highest position.

Check adjustment on right side of tractor. Measure distance “D” directly in front and behind the mandrel at bottom edge of mower housing as shown.

•Before making any necessary adjustments, check that both front links are equal in length. Both links should be approximately 10-3/8".

•If links are not equal in length, adjust one link to same length as other link.

•To lower front of mower loosen nut “E” on both front links an equal number of turns.

•When distance “D” is 1/8" to 1/2" lower at front than rear, tighten nuts “F” against trunnion on both front links.

•To raise front of mower, loosen nut “F” from trunnion on both front links. Tighten nut “E” on both front links an equal number of turns.

•When distance “D” is 1/8" to 1/2" lower at front than rear, tighten nut “F” against trunnion on both front links.

•Recheck side-to-side adjustment.

MANDREL

“D”

“D”

FIG. 21

BOTH FRONT LINKS MUST BE EQUAL IN LENGTH

NUT “F”

NUT “E”

TRUNNION

FRONT LINKS

FIG. 22

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents PPR1742STC Safe Operation Practices for Ride-On Mowers Safety RulesTable of Contents Customer Responsibilities Product SpecificationsContents of Hardware Pack Unpack Carton Tools Required for AssemblyHOW to SET UP Your Tractor Before Removing Tractor from SkidInstall Seat See Fig Check Deck Levelness To SET UP Your Mower for MulchingTo Convert to Bagging or Discharging Check Tire PressureLight Battery Reverse Forward FastSee Safety Rules Section Engine on Engine OFF OIL Pressure Lights onKnow Your Tractor HOW to USE Your Tractor ADD Gasoline Before Starting the EngineTo Transport Towing Carts and Other AttachmentsTo Start Engine See Fig Mowing TipsMulching Mowing Tips General Recommendations Lubrication ChartBefore Each USE Tractor Lubrication EngineBelts Transaxle CoolingSpark Plugs CleaningAIR Filter See Fig MufflerTo Remove Mower See Fig To Install MowerFRONT-TO-BACK Adjustment See Figs To Level Mower HousingTo Replace Motion Drive Belt See Fig To Adjust Brake See FigBelt Installation To Replace Mower Blade Drive Belt See FigFront Wheel TOE-IN/CAMBER Transaxle Gear Shift Lever Neutral Adjustment See FigTo Adjust Steering Wheel Alignment To Start Engine with a Weak Battery See FigInterlocks and Relays Replacing Battery See FigsTo Remove Hood and Grill Assembly See Fig To Replace Headlight BulbFinal Setting To Adjust Throttle Control Cable See FigTo Adjust Carburetor See Fig Preliminary SettingCylinders OtherFuel System Engine OILTroubleshooting Points OFF Tractor - Model Number PPR1742STC Schematic2122 Electrical170243 163968140401 170217Chassis and Enclosures 172108 169830169061 168337X012 Dash P/LDrive 169592 14243273800500 169372X428Steering Assembly 160367 121472X Wheel Steering169832 16351817000616 Seat Assembly71110616 171852173282 DecalsWheels and Tires 170856Engine 73510400 148875 Control Th/ch 36 Lh Flag169837 17060620Mower Deck 73800600 7476061672140506 132274Mower Lift Tractor Model Number PPR1742STC167253 159460 Wire Asm Inner/Sprg W/plunger LT169484 Page Limited Warranty Service Sighting Guide Suggested Guide for Sighting Slopes for Safe OperationParts and Service

PPR1742STC, 173282 specifications

The Poulan 173282, PPR1742STC is a standout model in the world of lawn and garden equipment, designed to deliver exceptional performance and ease of use. As a versatile mower, it caters to both residential and commercial landscaping needs, making it a popular choice among homeowners and professional landscapers alike.

One of the main features of the Poulan 173282 is its powerful engine. Equipped with a reliable four-stroke engine, it provides ample power to tackle various types of grass and terrain. The engine is designed for fuel efficiency, thereby reducing operational costs while ensuring consistent performance. The integrated starting system offers easy ignition, saving time and effort for the user.

The cutting deck of the PPR1742STC is another highlight. Its 42-inch deck allows for a wide cutting path, enabling faster mowing times and less overlapping. The deck is constructed from durable materials that withstand the rigors of outdoor use, ensuring longevity. Furthermore, the adjustable cutting height feature allows users to customize the grass length according to their preferences, giving them the flexibility to achieve the perfect lawn.

Technologically, the Poulan 173282 incorporates a user-friendly control panel that simplifies operation. With easy-to-reach controls for speed adjustment and blade engagement, users can navigate various mowing conditions with ease. The model also features ergonomic handles designed for comfort, reducing fatigue during extended use.

Safety is a priority in the design of the PPR1742STC. It includes features such as a safety switch that prevents accidental starts and guards that protect users from debris. These safety elements are crucial for ensuring a secure mowing experience.

In terms of versatility, this mower is compatible with various attachments. It can be equipped with baggers, mulchers, and other accessories, allowing users to customize their mowing experience based on specific needs. This adaptability makes it a valuable tool for tackling diverse landscaping tasks.

Overall, the Poulan 173282, PPR1742STC combines robust performance, innovative technology, and user-oriented features. Its durable construction, powerful engine, and safety mechanisms make it a reliable choice for anyone looking to maintain their lawn effectively. Whether for personal use or professional landscaping, this mower stands out as a durable and efficient solution for grass management.
Top Page Image Contents