Poulan PPR1742STC Tools Required for Assembly, Before Removing Tractor from Skid, Unpack Carton

Page 6

ASSEMBLY

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Standard wrench sizes are listed.

(2)

1/2" wrenches

Utility knife

(2)

9/16" wrench

Tire pressure gauge

Phillips screwdriver

When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel).

TO REMOVE TRACTOR FROM CARTON

UNPACK CARTON

•Remove all accessible loose parts and parts cartons from carton.

•Cut, from top to bottom, along lines on all four corners of carton, and lay panels flat.

•Check for any additional loose parts or cartons and remove.

BEFORE REMOVING TRACTOR FROM SKID

ATTACH STEERING WHEEL (See Fig. 1)

ASSEMBLE EXTENSION SHAFT AND BOOT

•Slide extension shaft onto lower steering shaft. Align mounting holes in extension and lower shafts and install 5/16 hex bolt and locknut. Tighten securely.

•Place tabs of steering boot over tab slots in dash and push down to secure.

INSTALL STEERING WHEEL

•Position front wheels of the tractor so they are pointing straight forward.

•Remove steering wheel adapter from steering wheel and slide adapter onto steering shaft extension.

•Position steering wheel so cross bars are horizontal (left to right) and slide inside boot and onto adapter.

•Assemble large flat washer, 3/8 lock washer, 3/8 hex bolt and tighten securely.

•Snap steering wheel insert into center of steering wheel.

•Remove protective materials from tractor hood and grill.

IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO ROLL OFF SKID.

 

INSERT

 

3/8 HEX BOLT

 

3/8 LOCK WASHER

 

LARGE FLAT

 

WASHER

STEERING

 

WHEEL

 

 

STEERING

 

BOOT

 

TABS

 

EXTENSION

ADAPTER

SHAFT

 

 

5/16 HEX

 

BOLT

5/16

 

LOCKNUT

 

 

TAB

LOWER

SLOTS

STEERING

 

SHAFT

 

FIG. 1

HOW TO SET UP YOUR TRACTOR

CHECK BATTERY (See Fig. 2)

•Lift seat pan to raised position and open battery box door.

•If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in CUSTOMER RESPONSIBILITIES section of this manual for charging instructions).

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents PPR1742STC Safety Rules Safe Operation Practices for Ride-On MowersTable of Contents Product Specifications Customer ResponsibilitiesContents of Hardware Pack Before Removing Tractor from Skid Tools Required for AssemblyHOW to SET UP Your Tractor Unpack CartonInstall Seat See Fig Check Tire Pressure To SET UP Your Mower for MulchingTo Convert to Bagging or Discharging Check Deck LevelnessEngine on Engine OFF OIL Pressure Lights on Battery Reverse Forward FastSee Safety Rules Section LightKnow Your Tractor HOW to USE Your Tractor Towing Carts and Other Attachments Before Starting the EngineTo Transport ADD GasolineMowing Tips To Start Engine See FigMulching Mowing Tips Lubrication Chart General RecommendationsBefore Each USE Tractor Transaxle Cooling EngineBelts LubricationMuffler CleaningAIR Filter See Fig Spark PlugsTo Install Mower To Remove Mower See FigTo Level Mower Housing FRONT-TO-BACK Adjustment See FigsTo Replace Mower Blade Drive Belt See Fig To Adjust Brake See FigBelt Installation To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig Transaxle Gear Shift Lever Neutral Adjustment See FigTo Adjust Steering Wheel Alignment Front Wheel TOE-IN/CAMBERTo Replace Headlight Bulb Replacing Battery See FigsTo Remove Hood and Grill Assembly See Fig Interlocks and RelaysPreliminary Setting To Adjust Throttle Control Cable See FigTo Adjust Carburetor See Fig Final SettingEngine OIL OtherFuel System CylindersTroubleshooting Points OFF Schematic Tractor - Model Number PPR1742STCElectrical 2122170217 163968140401 170243Chassis and Enclosures 168337X012 Dash P/L 169830169061 172108Drive 169372X428 14243273800500 169592Steering Assembly 163518 121472X Wheel Steering169832 160367171852 Seat Assembly71110616 17000616170856 DecalsWheels and Tires 173282Engine 17060620 148875 Control Th/ch 36 Lh Flag169837 73510400Mower Deck 132274 7476061672140506 73800600Tractor Model Number PPR1742STC Mower Lift159460 Wire Asm Inner/Sprg W/plunger LT 167253169484 Page Limited Warranty Service Suggested Guide for Sighting Slopes for Safe Operation Sighting GuideParts and Service

PPR1742STC, 173282 specifications

The Poulan 173282, PPR1742STC is a standout model in the world of lawn and garden equipment, designed to deliver exceptional performance and ease of use. As a versatile mower, it caters to both residential and commercial landscaping needs, making it a popular choice among homeowners and professional landscapers alike.

One of the main features of the Poulan 173282 is its powerful engine. Equipped with a reliable four-stroke engine, it provides ample power to tackle various types of grass and terrain. The engine is designed for fuel efficiency, thereby reducing operational costs while ensuring consistent performance. The integrated starting system offers easy ignition, saving time and effort for the user.

The cutting deck of the PPR1742STC is another highlight. Its 42-inch deck allows for a wide cutting path, enabling faster mowing times and less overlapping. The deck is constructed from durable materials that withstand the rigors of outdoor use, ensuring longevity. Furthermore, the adjustable cutting height feature allows users to customize the grass length according to their preferences, giving them the flexibility to achieve the perfect lawn.

Technologically, the Poulan 173282 incorporates a user-friendly control panel that simplifies operation. With easy-to-reach controls for speed adjustment and blade engagement, users can navigate various mowing conditions with ease. The model also features ergonomic handles designed for comfort, reducing fatigue during extended use.

Safety is a priority in the design of the PPR1742STC. It includes features such as a safety switch that prevents accidental starts and guards that protect users from debris. These safety elements are crucial for ensuring a secure mowing experience.

In terms of versatility, this mower is compatible with various attachments. It can be equipped with baggers, mulchers, and other accessories, allowing users to customize their mowing experience based on specific needs. This adaptability makes it a valuable tool for tackling diverse landscaping tasks.

Overall, the Poulan 173282, PPR1742STC combines robust performance, innovative technology, and user-oriented features. Its durable construction, powerful engine, and safety mechanisms make it a reliable choice for anyone looking to maintain their lawn effectively. Whether for personal use or professional landscaping, this mower stands out as a durable and efficient solution for grass management.
Top Page Image Contents