Jensen Tools XA275, XA250 Testing, Reconnect Battery, Test Speaker Connections, Test Power Wiring

Page 10

XA2125, XA275, XA250

Testing

Before you finish the installation, you should do the following tests to make sure the wiring is correct and everything is operating properly.

Reconnect Battery

When wiring is complete, reconnect the battery negative terminal.

–

Test Speaker Connections

These tests make sure the speakers are connected right. If speakers don’t play at all, one (or both) speaker wires may be disconnected. If the wrong speaker plays (you hear left speaker when you expect right speaker) make sure you connected the wires correctly.

Test Power Wiring

1.Turn on the receiver but do not turn up the volume. The amplifier power light should come on. If not, check the REM and +12V wires.

2.Turn up the receiver volume slightly. All speakers should operate. If not, check wiring connections at amplifier and speakers.

6236 XA2CH_E.p65

5/7/01, 2:07 PM

Image 10

Contents XA2125 Contents Disconnect Battery FeaturesInstallation Supplies and Tools NeededRouting Wires Location and MountingWiring PowerConnecting other Amps Input WiringInputs, RCA Output, Remote Level Control Speakers Speaker Wiring OptionsRemote Level Control XA2125 SubwoofersSpeakers + Subwoofer Bridged SubwooferCrossover X-OVER Indicators and ControlsPower / Protect Light BassTest Power Wiring TestingReconnect Battery Test Speaker ConnectionsTroubleshooting Problem Possible Cause Corrective ActionXA2125 SpecificationsSpecifications subject to change without notice XA275Limited One Year Warranty- USA and Canada How You Can Get Service