Poulan PD25PH48STD owner manual Purge Transmission, Mowing Tips, Automatic Transmission Warm UP

Page 15

OPERATION

AUTOMATIC TRANSMISSION WARM UP

•Before driving the unit in cold weather, the transmission should be warmed up as follows:

•Be sure the tractor is on level ground.

•Release the parking brake and let the brake slowly return to operating position.

•Allow one minute for transmission to warm up.This can be done during the engine warm up period.

•The attachments can be used during the engine warm- up period after the transmission has been warmed up and may require the choke control be pulled out slightly.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjustments section of this manual.

PURGE TRANSMISSION

CAUTION: Never engage or disengage freewheel lever while the engine is run-

ning.

To ensure proper operation and performance, it is recom- mended that the transmission be purged before operating tractor for the first time. This procedure will remove any trapped air inside the transmission which may have de- veloped during shipping of your tractor.

IMPORTANT: SHOULD YOUR TRANSMISSION REQUIRE REMOVAL FOR SERVICE OR REPLACEMENT, IT SHOULD BE PURGED AFTER REINSTALLATION BEFORE OPERATING THE TRACTOR.

•Place tractor safely on level surface with engine off and parking brake set.

•Disengage transmission by placing freewheel control in freewheeling position (See “TO TRANSPORT” in this section of manual).

•Sitting in the tractor seat, start engine. After the en- gine is running, move throttle control to slow position. Disengage parking brake

•Depress forward drive pedal to full forward position, hold for five (5) seconds and release pedal. Depress reverse drive pedal to full reverse position, hold for five

(5) seconds and release pedal. Repeat this procedure three (3) times.

NOTE: During this procedure there will be no movement of drive wheels. The air is being removed from hydraulic drive system.

•Shut- off engine and set parking brake.

•Engage transmission by placing freewheel control in driving position (See “TO TRANSPORT” in this section of manual).

•Sitting in the tractor seat, start engine. After the engine is running, move throttle control to half (1/2) speed. Disengage parking brake.

•Drive tractor forward for approximately five feet then backwards for five feet. Repeat this driving procedure three times.

•Your tractor is now purged and now ready for normal operation.

MOWING TIPS

•Mower should be properly leveled for best mowing per- formance. See “TO LEVEL MOWER HOUSING” in the Service and Adjustments section of this manual.

•The left hand side of mower should be used for trim- ming.

•Drive so that clippings are discharged onto the area that has been cut. Have the cut area to the right of the machine. This will result in a more even distribution of clippings and more uniform cutting.

•When mowing large areas, start by turning to the right so that clippings will discharge away from shrubs, fences, driveways, etc. After one or two rounds, mow in the opposite direction making left hand turns until finished (See Fig. 12).

00272

FIG. 12

•If grass is extremely tall, it should be mowed twice to reduce load and possible fire hazard from dried clip- pings. Make first cut relatively high; the second to the desired height.

•Do not mow grass when it is wet. Wet grass will plug mower and leave undesirable clumps. Allow grass to dry before mowing.

•Always operate engine at full throttle when mow- ing to assure better mowing performance and proper discharge of material. Regulate ground speed by se- lecting a low enough gear to give the mower cutting performance as well as the quality of cut desired.

•When operating attachments, select a ground speed that will suit the terrain and give best performance of the attachment being used.

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents PD25PH48STD Safety Rules Safety Rules Table of Contents Mower Unassembled PartsSteering Wheel Gauge Wheels Seat Nose RollerTo Remove Tractor from Carton AssemblyTools Required for Assembly HOW to SET UP Your TractorAssemble Gauge Wheels to Mower Deck See Fig Install Seat See FigTo Attach Nose Roller See Fig Install Mower and Drive Belt See FigsCheck Brake System Check Tire PressureCheck Mower Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To Transport See Figs To Adjust Gauge Wheels See FigTo Operate Mower See Fig To Operate on HillsADD Gasoline Before Starting the EngineTowing Carts and Other ATTACH- Ments Check Engine OIL LevelPurge Transmission Mowing TipsAutomatic Transmission Warm UP Before Each USE MaintenanceLubrication Chart General RecommendationsTractor Engine Cleaning Service and Adjustments To Install MowerTo Remove Mower See Fig FRONT-TO-BACK Adjustment See Figs To Level Mower HousingTo Replace Mower Blade Secondary Drive Belt See Fig To Replace Mower Drive BeltTo Check and Adjust Brake See Fig Transmission REMOVAL/REPLACEMENTTo Replace Motion Drive Belt See Fig Front Wheel TOE-IN/CAMBER To Adjust Steering Wheel ALIGN- MentTo Start Engine with a Weak Battery See Fig Replacing Battery See FigTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsWith attachment clutch Limited Warranty Suggested Guide for Sighting Slopes for Safe Operation For Service or Replacement Parts Parts and Service

PD25PH48STD specifications

The Poulan PD25PH48STD is a lawn tractor designed to offer homeowners an efficient and reliable mowing experience. With its robust engine and user-friendly features, this model ensures a seamless lawn maintenance process that meets the needs of various yard sizes.

One of the standout features of the PD25PH48STD is its powerful 25 HP Briggs & Stratton engine. This engine provides ample power to tackle tough grass and uneven terrain, ensuring a consistent cut with every pass. Coupled with an automatic transmission, the tractor offers smooth operation and effortless speed control, allowing users to choose the right pace for their mowing tasks.

The PD25PH48STD sports a 48-inch cutting deck, which enables it to cover more ground in less time. This deck is equipped with reinforced blades designed for optimum cutting efficiency, delivering a clean and even finish. The adjustable cutting height feature allows users to customize the grass length, adapting to various landscaping needs or seasonal changes.

Another important aspect of the Poulan PD25PH48STD is its ergonomic design. The operator's seat is comfortable and adjustable, ensuring that users can find their ideal driving position for long mowing sessions. The easy-to-reach controls enhance user experience, allowing for intuitive operation without the need to stretch or fumble.

In terms of durability, the PD25PH48STD is constructed with high-quality materials that are designed to withstand the rigors of outdoor use. The sturdy frame and robust components ensure that the tractor can handle tough tasks year after year. Moreover, the tractor’s maintenance-friendly design simplifies routine checks and repairs, ensuring that it stays in peak condition with minimal effort.

The Poulan PD25PH48STD also embraces modern technology with features like a large fuel tank that extends mowing time between refuels and easy-to-read gauges that provide vital information at a glance.

In summary, the Poulan PD25PH48STD lawn tractor combines power, efficiency, and user-friendly features to create a reliable mowing solution for homeowners. With its strong engine, spacious cutting deck, and ergonomic design, it not only makes lawn care easier but also enhances the overall mowing experience, making it a worthy investment for any yard maintenance enthusiast.
Top Page Image Contents