Poulan PD22PH48STA owner manual Before Starting the Engine, Check Engine OIL Level, ADD Gasoline

Page 13

OPERATION

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

•The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

•Check engine oil with tractor on level ground.

•Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

•For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Customer Responsibilities section of this manual).

•To change engine oil, see the Customer Responsibilities section in this manual.

ADD GASOLINE

•Fill fuel tank. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW 32°F(0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

WARNING: Experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

CAUTION: Fill to bottom of gas tank filler neck. Do not overfill. Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

TO START ENGINE (See Fig. 5)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Be sure freewheel control is in the transmission engaged position.

•Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

•Place motion control lever in neutral (N) position.

•Move attachment clutch to “DISENGAGED” position.

•Move throttle control to choke position.

NOTE: Before starting, read the warm and cold starting procedures below.

•Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the choke position and retry.

WARM WEATHER STARTING (50° F and above)

•When engine starts, move the throttle control to the fast position.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING ( 50° F AND BELOW)

•When engine starts, allow engine to run with the throttle control in the choke position until the engine runs roughly, then move throttle control to fast position. This may require an engine warm-up period from several seconds to several minutes, depending on the tempera- ture.

AUTOMATIC TRANSMISSION WARM UP

•Before driving the unit in cold weather, the transmission should be warmed up as follows:

•Be sure the tractor is on level ground.

•Place the motion control lever in neutral. Release

the parking brake and let the clutch/brake s l o w l y return to operating position.

•Allow one minute for transmission to warm up. This can be done during the engine warm up period.

•The attachments can also be used during the engine warm-up period after the transmission has been warmed up.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjustments section of this manual.

PURGE TRANSMISSION

CAUTION: Never engage or disengage freewheel lever while the engine is run- ning.

To ensure proper operation and performance, it is recom- mended that the transmission be purged before operating tractor for the first time. This procedure will remove any trapped air inside the transmission which may have devel- oped during shipping of your tractor.

IMPORTANT: SHOULD YOUR TRANSMISSION REQUIRE REMOVAL FOR SERVICE OR REPLACEMENT, IT SHOULD BE PURGED AFTER REINSTALLATION BEFORE OPERATING THE TRACTOR.

•Place tractor safely on level surface with engine off and parking brake set.

•Disengage transmission by placing freewheel control in freewheeling position (See “TO TRANSPORT” in this section of manual).

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents PR17H42STC Safe Operation Practices for Ride-On Mowers Safety RulesBecome ALERT!!! Your Safety is IN- Volved Table of Contents Steering Wheel Seat Unassembled PartsSlope Sheet Tools Required for Assembly AssemblyHOW to SET UP Your Tractor To Remove Tractor from CartonInstall Seat See Fig Check Tire Pressure To SET UP Your Mower for MulchingCheck Deck Levelness To Convert to Bagging or DischargingOperation Know Your Tractor To Adjust Mower Cutting Height See Fig Stopping See Fig HOW to USE Your TractorTo SET Parking Brake See Fig To USE Throttle Control See FigTo Operate Mower See Fig To Adjust Gauge Wheels See FigTo Operate on Hills To Transport See FigsCheck Engine OIL Level Before Starting the EngineADD Gasoline To Start Engine See FigMulching Mowing Tips Mowing TipsCustomer Responsibilities Lubrication ChartGeneral Recommendations Before Each USETractor Engine Muffler CleaningSpark Plugs To Install Mower See Fig Service and AdjustmentsTo Level Mower Housing To Remove Mower See FigTo Replace Mower Blade Drive Belt See Fig Belt InstallationBelt Removal Transmission REMOVAL/REPLACEMENT To Adjust Brake See FigTransaxle Motion Control Lever Neutral ADJUSTMENTSee Fig To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig To Adjust Steering Wheel AlignmentReplacing Battery See Figs Front Wheel TOE-IN/CAMBERInterlocks and Relays To Replace Headlight BulbTo Replace Fuse Other StorageFuel System Engine OILTroubleshooting Points OFF Tractor - Model Number PR17H42STC Schematic2122 ElectricalKEY Part Description Chassis 174619 Drive 175578 175765175461 175556Steering Assembly 177876 175121175146 175118Seat Assembly Wheels and Tires Decals178206 178219Optional Equipment EngineSpark Arrester 8113170551 Control Th/ch Flag 143 159 144 150 145 148 146 142 147 Mower Deck147 142 149175746 17490612175747 157109X421Mower Lift 159460 Wire Asm Inner/Sprg W/plunger LT Service Notes Service Notes Limited Warranty Sighting Guide Suggested Guide for Sighting Slopes for Safe OperationParts and Service

PD22PH48STA specifications

The Poulan PD22PH48STA is a versatile and efficient lawn tractor designed for homeowners who seek a reliable solution for maintaining their lawns. With a powerful engine and user-friendly features, it has quickly become a popular choice for residential lawn care. This lawn tractor boasts a 22 horsepower, 725cc Kohler engine that delivers ample power for tackling various mowing conditions. This engine is designed for efficiency and longevity, ensuring that it can handle the rigors of regular use without compromising performance.

One of the standout features of the Poulan PD22PH48STA is its 48-inch cutting deck. This wide deck allows for efficient mowing and minimizes the number of passes required to cover large areas, making lawn maintenance quicker and more effective. The deck is made from robust materials to withstand daily wear and tear, and it has multiple height adjustment options to provide users with flexibility when it comes to grass length.

The mower is equipped with a hydrostatic transmission, enabling smooth and effortless operation. This technology allows users to change speeds without having to shift gears manually, providing a more comfortable and efficient mowing experience. The hydrostatic transmission is particularly useful when navigating complex terrains and tight spaces, where precise control is essential.

Another impressive characteristic of the Poulan PD22PH48STA is its turning radius. With a tight turning radius, this lawn tractor allows users to maneuver easily around obstacles, flower beds, and trees, contributing to a cleaner and more precise cut. The comfortable operator’s seat and ergonomic controls enhance the overall user experience, providing ample support during extended mowing sessions.

In addition, the PD22PH48STA features a durable frame and heavy-duty wheels that provide stability and traction on various surfaces, ensuring it remains reliable on uneven terrain. The mower's easy access to maintenance points simplifies upkeep, allowing users to keep their equipment in peak condition with minimal effort.

Overall, the Poulan PD22PH48STA combines power, efficiency, and user-friendly features into a state-of-the-art lawn tractor that stands out in the market. Its focus on performance and comfort makes it a strong contender for dedicated homeowners looking to achieve a well-maintained lawn with ease.
Top Page Image Contents