Poulan PD22PH48STA owner manual To Replace Headlight Bulb, Interlocks and Relays, To Replace Fuse

Page 23

SERVICE AND ADJUSTMENTS

•Install new battery with terminals in same position as old battery.

•First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely.

•Connect BLACK grounding cable to negative (-) terminal with remaining hex bolt and keps nut. Tighten securely.

•Close battery box door.

SEAT PAN

BATTERY

BOX DOOR

FIG. 30

KEPS

NUT

HEX

BOLT

POSITIVE (RED)

NEGATIVE

CABLE

(BLACK) CABLE

FIG. 31

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 32)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

HOOD

HEADLIGHT WIRE CONNECTOR

FIG. 32

ENGINE

TO ADJUST THROTTLE CONTROL CABLE (See Fig. 33)

The throttle control has been preset at the factory and adjustment should not be necessary. Check adjustment as described below before loosening cable. If adjustment is necessary, proceed as follows:

•With engine not running, move throttle control lever from slow to choke position. Slowly move lever from choke to fast position.

•Check that holes “A” in governor control lever and hole in governor plate line-up. If holes “A” are not aligned, loosen clamp screw and move throttle cable until holes are aligned. Tighten clamp screw securely.

GOVERNOR

GOVERNOR

CONTROL LEVER

CONTROL PLATE

 

CLAMP

THROTTLE

SCREW

HOLES “A”

CABLE

FIG. 33

TO ADJUST CARBURETOR (See Fig. 33)

The carburetor has been preset at the factory and adjust- ment should not be necessary. However, minor adjustment may be required to compensate for differences in fuel, temperature, altitude or load. If the carburetor does need adjustment, see engine manual.

High speed stop is factory adjusted. Do not adjust - damage may result.

IMPORTANT: NEVER TAMPER WITH THE ENGINE GOVERNOR, WHICH IS FACTORY SET FOR PROPER ENGINE SPEED. OVERSPEEDING THE ENGINE ABOVE THE FACTORY HIGH SPEED SETTING CAN BE DANGEROUS. IF YOU THINK THE ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING, CONTACT YOUR N E A R E S T A U T H O R I Z E D S E R V I C E C E N T E R / DEPARTMENT, WHICH HAS PROPER EQUIPMENT AND E X P E R I E N C E T O M A K E A N Y N E C E S S A R Y

23ADJUSTMENTS.

Page 22 Page 24
Image 23
Page 22 Page 24
Contents PR17H42STC Safe Operation Practices for Ride-On Mowers Safety RulesBecome ALERT!!! Your Safety is IN- Volved Table of Contents Slope Sheet Unassembled PartsSteering Wheel Seat To Remove Tractor from Carton AssemblyTools Required for Assembly HOW to SET UP Your TractorInstall Seat See Fig To Convert to Bagging or Discharging To SET UP Your Mower for MulchingCheck Tire Pressure Check Deck LevelnessOperation Know Your Tractor To USE Throttle Control See Fig HOW to USE Your TractorTo Adjust Mower Cutting Height See Fig Stopping See Fig To SET Parking Brake See FigTo Transport See Figs To Adjust Gauge Wheels See FigTo Operate Mower See Fig To Operate on HillsTo Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolineMulching Mowing Tips Mowing TipsBefore Each USE Lubrication ChartCustomer Responsibilities General RecommendationsTractor Engine Spark Plugs CleaningMuffler To Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig To Level Mower HousingBelt Removal Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See Fig To Adjust Brake See FigTransmission REMOVAL/REPLACEMENT Transaxle Motion Control Lever Neutral ADJUSTMENTSee FigFront Wheel TOE-IN/CAMBER To Adjust Steering Wheel AlignmentTo Start Engine with a Weak Battery See Fig Replacing Battery See FigsTo Replace Fuse To Replace Headlight BulbInterlocks and Relays Engine OIL StorageOther Fuel SystemTroubleshooting Points OFF Tractor - Model Number PR17H42STC Schematic2122 ElectricalKEY Part Description Chassis 174619 Drive 175556 175765175578 175461Steering Assembly 175118 175121177876 175146Seat Assembly 178219 DecalsWheels and Tires 1782068113 EngineOptional Equipment Spark Arrester170551 Control Th/ch Flag 149 Mower Deck143 159 144 150 145 148 146 142 147 147 142157109X421 17490612175746 175747Mower Lift 159460 Wire Asm Inner/Sprg W/plunger LT Service Notes Service Notes Limited Warranty Sighting Guide Suggested Guide for Sighting Slopes for Safe OperationParts and Service

PD22PH48STA specifications

The Poulan PD22PH48STA is a versatile and efficient lawn tractor designed for homeowners who seek a reliable solution for maintaining their lawns. With a powerful engine and user-friendly features, it has quickly become a popular choice for residential lawn care. This lawn tractor boasts a 22 horsepower, 725cc Kohler engine that delivers ample power for tackling various mowing conditions. This engine is designed for efficiency and longevity, ensuring that it can handle the rigors of regular use without compromising performance.

One of the standout features of the Poulan PD22PH48STA is its 48-inch cutting deck. This wide deck allows for efficient mowing and minimizes the number of passes required to cover large areas, making lawn maintenance quicker and more effective. The deck is made from robust materials to withstand daily wear and tear, and it has multiple height adjustment options to provide users with flexibility when it comes to grass length.

The mower is equipped with a hydrostatic transmission, enabling smooth and effortless operation. This technology allows users to change speeds without having to shift gears manually, providing a more comfortable and efficient mowing experience. The hydrostatic transmission is particularly useful when navigating complex terrains and tight spaces, where precise control is essential.

Another impressive characteristic of the Poulan PD22PH48STA is its turning radius. With a tight turning radius, this lawn tractor allows users to maneuver easily around obstacles, flower beds, and trees, contributing to a cleaner and more precise cut. The comfortable operator’s seat and ergonomic controls enhance the overall user experience, providing ample support during extended mowing sessions.

In addition, the PD22PH48STA features a durable frame and heavy-duty wheels that provide stability and traction on various surfaces, ensuring it remains reliable on uneven terrain. The mower's easy access to maintenance points simplifies upkeep, allowing users to keep their equipment in peak condition with minimal effort.

Overall, the Poulan PD22PH48STA combines power, efficiency, and user-friendly features into a state-of-the-art lawn tractor that stands out in the market. Its focus on performance and comfort makes it a strong contender for dedicated homeowners looking to achieve a well-maintained lawn with ease.
Top Page Image Contents