Poulan CO18542STA manual Before Starting the Engine, To Start Engine, Check Engine OIL Level

Page 15

TOWING CARTS AND OTHER ATTACH- MENTS

Tow only the attachments that are recom- mended by and comply with specifications of the manufacturer of your tractor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

1.Check engine oil with tractor on level ground.

2.Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, re- move and read oil level. If necessary,

add oil until “FULL” mark on dipstick is reached. Do not overfill.

•For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Mainte- nance section of this manual).

•To change engine oil, see the Mainte- nance section in this manual.

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of

87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quan- tities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: When operating in temper- atures below32°F(0°C), use fresh, clean winter grade gasoline to help insure good cold weather starting.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or metha- nol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

TO START ENGINE

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

1.Sit on seat in operating position, depress clutch/brake pedal and set parking brake.

2.Place gear shift lever in neutral (N) position.

3.Move attachment clutch to disengaged position.

4.Move throttle control to choke position. NOTE: Before starting, read the warm and cold starting procedures below.

5.Insert key into ignition and turn key clockwise to start position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, move throttle control to fast position, wait a few minutes and try again. If engine still does not start, move the throttle control back to the choke position and retry.

WARM WEATHER STARTING (50° F and above)

6.When engine starts, move the throttle control to the fast position.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING ( 50° F and below)

6.When engine starts, leave throttle control in choke position until engine warms up and begins to run roughly. Once rough running begins, immediately move the throttle control to the fast position. Engine

warm-up may take from several seconds to several minutes (the colder the tem- perature, the longer the warm-up).

• The attachments can also be used dur- ing the engine warm-up period.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance (see “TO ADJUST CARBURETOR” in the Service and Adjustments section of this manual).

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Model NO. CO18542STA Warranty Table of ContentsSafety Rules General OperationII. Slope Operation IV. Service III. ChildrenDo not Safety Rules Product Specifications Customer ResponsibilitiesAPI-SG-SL Unassembled Parts Tools Required for Assembly To Remove Tractor from CartonBefore Removing Tractor from Skid If previously removed Install Mulcher PlateCheck for Proper Position of ALL Belts To Convert to Bagging or DischargingReposition Right Rear Gauge Wheel Check Tire PressureOperation Know Your Tractor HOW to USE Your Tractor To Operate Mower Check Engine OIL Level Before Starting the EngineTo Start Engine Towing Carts and Other ATTACH- MentsMowing Tips Maintenance General RecommendationsBefore Each USE Tractor Engine Cleaning Service and AdjustmentsFRONT-TO-BACK Adjustment To Install MowerTo Level Mower Housing SIDE-TO-SIDE AdjustmentTo Check and Adjust Brake To Replace Mower Blade Drive BeltTo Replace Motion Drive Belt Front Wheel TOE-IN/CAMBER To Adjust Steering Wheel ALIGN- MentTransaxle Gear Shift Lever NEU- Tral Adjustment To Start Engine with a Weak BatteryTo Adjust Carburetor Engine OIL BatteryOther Fuel SystemProblem Cause Correction Troubleshooting ChartExcessive Poor grass Suggested Guide for Sighting Slopes for Safe Operation

CO18542STA specifications

The Poulan CO18542STA is a robust and efficient lawn mower designed for homeowners seeking a reliable solution for their lawn care needs. This model stands out due to its combination of power, ease of use, and advanced features, making it suitable for various lawn sizes and terrains.

At the heart of the Poulan CO18542STA is a high-performance engine, which provides ample power for cutting through dense grass and challenging conditions. The engine is engineered for durability and efficiency, allowing users to tackle larger areas without frequent refueling. This model features a wide cutting deck measuring 18 inches, which means less time spent mowing and more time enjoying your outdoor space. The cutting height can be easily adjusted, allowing users to customize their lawn care routine according to the season and grass type.

One of the key technologies embedded in this mower is its innovative cutting system. The CO18542STA is equipped with a dual-blade design, which enhances cutting performance and improves grass clippings discharge. This system ensures a clean cut, promoting healthy grass growth and a visually appealing lawn. Additionally, the mower's lightweight construction allows for enhanced maneuverability, ensuring it can navigate around obstacles and tight corners with ease.

The Poulan CO18542STA also emphasizes user comfort and convenience. Its ergonomic handles are designed for optimal comfort during long mowing sessions, reducing fatigue and promoting ease of operation. The mower includes a convenient starting system that allows for quick and easy ignition, minimizing downtime between tasks.

Maintenance is straightforward with the Poulan CO18542STA, thanks to its easy-access engine components and removable cutting deck. This feature enables users to perform routine maintenance tasks without hassle, ensuring the mower remains in peak operating condition.

For those seeking an environmentally friendly option, the Poulan CO18542STA runs on clean-burning, efficient fuel technology. This reduces emissions and aligns with modern sustainability practices, making it a responsible choice for eco-conscious homeowners.

Overall, the Poulan CO18542STA offers an impressive blend of power, technology, and user-focused features. Whether you have a small garden or a more extensive landscape, this mower is designed to deliver reliable performance and ease of use, ensuring your lawn stays healthy and well-maintained year-round.
Top Page Image Contents