Poulan PB195H42LTX manual To Level Mower

Page 21

SERVICE AND ADJUSTMENTS

TO LEVEL MOWER

Make sure tires are properly inflated to the PSI shown on tires. If tires are over or under inflated, it may affect the appearance of your lawn and lead you to think the mower is not adjusted properly.

VISUAL SIDE-TO-SIDE ADJUSTMENT (See Fig. 21)

With all tires properly inflated and if your lawn appears unevenly cut, determine which side of mower is cutting lower.

NOTE: As desired, you can raise the low side of mower or lower the high side.

Go to side of mower you wish to adjust.

With a 3/4" or adjustable wrench, turn lift link adjust- ment nut (A) to the left to lower the mower, or, to the right to raise the mower.

A

Turn nut right

Turn nut left

to raise mower

to lower mower

02948

FIG. 21

NOTE: Each full turn of adjustment nut will change mower height about 3/16".

Test your adjustment by mowing some uncut grass and visually checking the appearance. Readjust, if necessary, until you are satisfied with the results.

PRECISION SIDE-TO-SIDE ADJUSTMENT (See Fig. 22)

With all tires properly inflated, park tractor on level ground or driveway.

CAUTION: Blades are sharp. Protect your hands with gloves and/or wrap blade with heavy cloth.

Raise mower to its highest position.

At both sides of mower, position blade at side and measure the distance (A) from bottom edge of blade to the ground. The distance should be the same on both sides.

If adjustment is necessary, see steps in Visual Adjust- ment instructions above.

Recheck measurements, adjust if necessary until both sides are equal.

 

02966

A

A

FIG. 22

FRONT-TO-BACK ADJUSTMENT (See Figs. 23 and 24) IMPORTANT: Deck must be level side-to-side.

To obtain the best cutting results, the mower blades should be adjusted so the front tip is 1/8" to 1/2" lower than the rear tip when the mower is in its highest position.

CAUTION: Blades are sharp. Protect your hands with gloves and/or wrap blade with heavy cloth.

Raise mower to highest position.

Position any blade so the tip is pointing straight forward. Measure distance (B) to the ground at front and rear tip of the blade.

If front tip of blade is not 1/8" to 1/2" lower than the rear tip, go to the front of tractor.

With an 11/16" or adjustable wrench, loosen jam nut A several turns to clear adjustment nut B.

With a 3/4" or adjustable wrench, turn front link adjust- ment nut (B) clockwise (ltighten) to raise the front of mower, or, counterclockwise (loosen) to lower the front mower.

02548

BB

FIG. 23

B

A

Tighten adjust nut

Loosen adjust

nut B to lower

 

02950

Loosen jam nut A first

FIG. 24

NOTE: Each full turn of the adjustment nut will change mower height about 1/8".

Recheck measurements, adjust if necessary until front tip of blade is 1/8" to 1/2" lower than the rear tip.

Hold adjustment nut in position with wrench and tighten jam nut securely against adjustment nut.

21

Image 21
Contents Model PB195H42LTXSafe Operation Practices for Ride-On Mowers General OperationII. Slope Operation Service III. ChildrenIV. Towing Table of Contents Contents of Hardware Pack To Remove Tractor from Tools Required for AssemblyCarton Before Removing Tractor fromCheck Battery See Fig Check Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Reverse Operation System ROS Using the Reverse Operation SystemTo Operate on Hills To Operate Mower See FigTo Transport Before Starting the EngineTowing Carts and Other ATTACH- Ments Check Engine OIL LevelPurge Transmission Mowing TipsAutomatic Transmission Warm UP RunningMaintenance Blade Removal See Fig TractorTo Sharpen Blade See Fig Check Operator Presence SystemEngine BatteryBelts Transaxle CoolingCleaning To Remove Mower See Fig To Install Mower See FigInstall belt on engine pulley M, in belt keepers G To Level Mower To Replace Mower Drive Belt see FIG Belt InstallationTo Replace Motion Belt Drive See Fig To Check BrakeTo Adjust Steering Wheel ALIGN- Ment Transaxle Motion Control Lever Neutral Adjustment See FigTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbFuel System OtherEngine OIL CylindersProblem Cause Correction Troubleshooting PointsEngine dies when HOP Limited WarrantyFold Along This Dotted Line Degree Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXService Notes Service Notes Page Page Dentretien Remarques Dentretien Remarques UNE Pliez EST Ceci Degrés Suivant LESLimitée Garantie Centre un contactez corrigé, pas n’est problème le Si Dépannage DE GuideRalenti DU Commande LA Régler Pour GAZ DES CommandeEntreposage Réglages ET Révision AVANT/ Roues DES Convergence CarrossageTionrecdi LA DE L’ALIGNEMENT Régler PourFreins LES Vérifier Pour Fig la Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl Pour26 .FIG 25 .FIG24 .FIG Tondeuse LA Niveau LE Ajuster Pour22 .FIG 23 .FIG20 .FIG 18 .FIG 19 .FIG17 .FIG Reglages ET Revision Courroie LA ET Tondeuse LA InstallerFig Voir Tondeuse LA Enlever PourEntretien Ligne EN Installé D’ESSENCE Filtre’ALLUMAGE Bougie AIR À FiltreTransmission LA DE Refroidissement LubrificationTrapézoïdales Courroies Fig la Voir Lame LA Affiler Fig la Voir Lame LA EnleverEN Fonctionnement DE Système ET O I T a D N a M M O C E R Lubrification DE TableauUtilisation Chaque Avant Transmission LA Purger UtilisationTonte DE Conseils 10 .FIGMoteur LE Démarrer Pour Accessoires Autres’ESSENCE Réservoir LE Remplir Moteur DU D’HUILE Niveau LE VérifierPentes LES Dans Utiliser Pour MAR EN Fonctionnement DE SystèmeTondeuse LA Utiliser Pour ROS Arrière CHEFig la GAZ DES Commande LA Utiliser PourVoir Reculer Pour ET Avancer Pour Fig la Voir Arrêter PourTracteur Votre Connaissez Propriété la de lendommagement Montage Correctement Sont Courroies LESToutes SI Vérifier Toutes SI Vérifier Rouler Faisant LE EN Palette LA DE Tracteur LE Retirer PourMON LE Pour Exigés Outils LES DU Tracteur LE Sortir PourEt 2 .Figs les Voir Siège LE Ajustez Fig la Voir Tionrecdi DE Volant LE FixerMontar SIN Piezas Sommaire U1R DimensionCCA .MIN AMP/HR SL-SG-APITracteurs des sécurité toute Général Entretien’utilisation pour Conseils ’ESSENCE DE Sûre ManipulationPentes LES Dans FonctionnementTracteurs des sécurité toute en l’utilisation pour Conseils AUX Imprimé

PB195H42LTX specifications

The Poulan PB195H42LTX is a powerful and versatile lawn tractor designed for homeowners seeking efficiency and ease of use in their lawn care routines. With a cutting edge design and advanced technology, this model stands out in the crowded market of lawn care equipment.

One of the main features of the PB195H42LTX is its robust 19.5 horsepower Briggs & Stratton engine. This engine is known for its reliability and performance, allowing the tractor to tackle various mowing conditions effortlessly. The engine is paired with a smooth hydrostatic transmission, which provides seamless speed adjustments without the need for manual shifting. This user-friendly design enables operators to focus on their mowing tasks without the hassle of changing gears.

The cutting deck on the PB195H42LTX measures a generous 42 inches, making it suitable for medium to large-sized lawns. The deck features a durable steel construction and offers multiple cutting heights, allowing users to customize their mowing experience based on the lawn's requirements. With the ability to cut grass at heights between 1.5 to 4 inches, the tractor ensures a clean and healthy lawn.

In addition to its impressive cutting capabilities, the PB195H42LTX incorporates various technologies that enhance user experience and comfort. The tractor is designed with an ergonomic seat and an adjustable steering wheel, providing maximum comfort during extended mowing sessions. The easy-to-use controls are intuitively placed, ensuring operators can access all functions with minimal effort.

The inclusion of a reinforced front bumper enhances the tractor's durability, protecting it from potential bumps and impacts during operation. Moreover, the tractor is equipped with a large grass bagger attachment, making it easy to collect clippings for a polished lawn appearance.

For those concerned about storage and maintenance, the PB195H42LTX features a compact design that allows easy access to the engine and other components. Maintenance tasks, such as oil changes and blade replacements, can be completed with minimal tools and effort.

In summary, the Poulan PB195H42LTX is a well-equipped lawn tractor that combines power, comfort, and ease of use. With its reliable engine, adjustable cutting deck, and thoughtful design elements, it is an excellent choice for homeowners looking to maintain a pristine lawn with minimal hassle. Whether tackling rough weeds or maintaining well-kept grass, the PB195H42LTX is a capable and efficient ally in lawn care.