Poulan PB195H42LTX manual Check Battery See Fig

Page 7

ASSEMBLY

•Push down on seat to engage pads in slots and pull seat towards rear of tractor.

•Raise seat and tighten bolt securely.

•Remove tape and discard.

•Lower seat into operating position and sit on seat. Press clutch/brake pedal all the way down. If operating position is not comfortable, adjust seat.

To adjust seat: Grasp adjustment handle and pull up, slide seat to desired position and release adjustment handle.

SLOT

 

TAPE

PAD

 

 

FLAT

 

 

WASHER

 

 

SEAT PAN

 

BOLT

TAB

ADJUSTMENT

HANDLE

 

 

Fig. 3

CHECK BATTERY (See Fig. 4)

•Lift seat pan to raised position.

•If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in MAINTENANCE section of this manual for charging instructions).

SEAT PAN

LABEL

TERMINAL

TERMINAL

FIG. 4

NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.

WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

TO ROLL TRACTOR OFF SKID (See Op- eration section for location and function of controls)

•Press lift lever plunger and raise attachment lift lever to its highest position.

•Release parking brake by depressing clutch/brake pedal.

•Place freewheel control in "transmission disengaged position" (See “TO TRANSPORT” in the Operation section of this manual).

•Roll tractor forward off skid.

•Remove banding holding the deflector shield up against tractor.

TO DRIVE TRACTOR OFF SKID (See Op- eration section for location and function of controls)

•Be sure all the above assembly steps have been com- pleted.

•Check engine oil level and fill fuel tank with gasoline.

•Place freewheel control in "transmission engaged" position (see "TO TRANSPORT" in Operation section of this manual).

•Sit on seat in operating position, depress clutch/brake pedal and set the parking brake.

•Place motion control lever in neutral (N) position.

•Press lift lever plunger and raise attachment lift lever to its highest position.

•Remove key from bag and start the engine (see "TO START ENGINE" in the Operation section of this manual). After engine has started, move throttle control to idle (slow) position.

•Release parking brake.

•Slowly move the motion control lever forward and slowly drive tractor off skid.

•Apply brake to stop tractor, set parking brake and place motion control lever in neutral position.

•Turn ignition key to "STOP" position.

Continue with the instructions that follow.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Model PB195H42LTXGeneral Operation Safe Operation Practices for Ride-On MowersII. Slope Operation III. Children ServiceIV. Towing Table of Contents Contents of Hardware Pack Before Removing Tractor from Tools Required for AssemblyTo Remove Tractor from CartonCheck Battery See Fig Check Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor To Operate Mower See Fig Using the Reverse Operation SystemReverse Operation System ROS To Operate on HillsCheck Engine OIL Level Before Starting the EngineTo Transport Towing Carts and Other ATTACH- MentsRunning Mowing TipsPurge Transmission Automatic Transmission Warm UPMaintenance Check Operator Presence System TractorBlade Removal See Fig To Sharpen Blade See FigTransaxle Cooling BatteryEngine BeltsCleaning To Remove Mower See Fig To Install Mower See FigInstall belt on engine pulley M, in belt keepers G To Level Mower To Check Brake Belt InstallationTo Replace Mower Drive Belt see FIG To Replace Motion Belt Drive See FigFront Wheel TOE-IN/CAMBER Transaxle Motion Control Lever Neutral Adjustment See FigTo Adjust Steering Wheel ALIGN- Ment To Start Engine with a Weak Battery See FigTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorCylinders OtherFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine dies when HOP Limited WarrantyFold Along This Dotted Line Degree Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXService Notes Service Notes Page Page Dentretien Remarques Dentretien Remarques UNE Pliez EST Ceci Degrés Suivant LESLimitée Garantie Centre un contactez corrigé, pas n’est problème le Si Dépannage DE GuideRalenti GAZ DES Commande DU Commande LA Régler PourEntreposage Réglages ET Révision LA DE L’ALIGNEMENT Régler Pour CarrossageAVANT/ Roues DES Convergence Tionrecdi25 .FIG Fig la Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl PourFreins LES Vérifier Pour 26 .FIG23 .FIG Tondeuse LA Niveau LE Ajuster Pour24 .FIG 22 .FIG19 .FIG 20 .FIG 18 .FIG17 .FIG Tondeuse LA Enlever Pour Courroie LA ET Tondeuse LA InstallerReglages ET Revision Fig VoirAIR À Filtre Ligne EN Installé D’ESSENCE FiltreEntretien ’ALLUMAGE BougieLubrification Transmission LA DE RefroidissementTrapézoïdales Courroies Fig la Voir Lame LA Enlever Fig la Voir Lame LA AffilerEN Fonctionnement DE Système ET Lubrification DE Tableau O I T a D N a M M O C E RUtilisation Chaque Avant 10 .FIG UtilisationTransmission LA Purger Tonte DE ConseilsMoteur DU D’HUILE Niveau LE Vérifier Accessoires AutresMoteur LE Démarrer Pour ’ESSENCE Réservoir LE RemplirROS Arrière CHE MAR EN Fonctionnement DE SystèmePentes LES Dans Utiliser Pour Tondeuse LA Utiliser PourFig la Voir Arrêter Pour GAZ DES Commande LA Utiliser PourFig la Voir Reculer Pour ET Avancer PourTracteur Votre Connaissez Propriété la de lendommagement Correctement Sont Courroies LES MontageToutes SI Vérifier Toutes SI Vérifier Rouler Faisant LE EN Palette LA DE Tracteur LE Retirer PourTionrecdi DE Volant LE Fixer DU Tracteur LE Sortir PourMON LE Pour Exigés Outils LES Et 2 .Figs les Voir Siège LE Ajustez Fig la VoirMontar SIN Piezas SL-SG-API U1R DimensionSommaire CCA .MIN AMP/HR’ESSENCE DE Sûre Manipulation Général EntretienTracteurs des sécurité toute ’utilisation pour ConseilsLES Dans Fonctionnement PentesTracteurs des sécurité toute en l’utilisation pour Conseils AUX Imprimé

PB195H42LTX specifications

The Poulan PB195H42LTX is a powerful and versatile lawn tractor designed for homeowners seeking efficiency and ease of use in their lawn care routines. With a cutting edge design and advanced technology, this model stands out in the crowded market of lawn care equipment.

One of the main features of the PB195H42LTX is its robust 19.5 horsepower Briggs & Stratton engine. This engine is known for its reliability and performance, allowing the tractor to tackle various mowing conditions effortlessly. The engine is paired with a smooth hydrostatic transmission, which provides seamless speed adjustments without the need for manual shifting. This user-friendly design enables operators to focus on their mowing tasks without the hassle of changing gears.

The cutting deck on the PB195H42LTX measures a generous 42 inches, making it suitable for medium to large-sized lawns. The deck features a durable steel construction and offers multiple cutting heights, allowing users to customize their mowing experience based on the lawn's requirements. With the ability to cut grass at heights between 1.5 to 4 inches, the tractor ensures a clean and healthy lawn.

In addition to its impressive cutting capabilities, the PB195H42LTX incorporates various technologies that enhance user experience and comfort. The tractor is designed with an ergonomic seat and an adjustable steering wheel, providing maximum comfort during extended mowing sessions. The easy-to-use controls are intuitively placed, ensuring operators can access all functions with minimal effort.

The inclusion of a reinforced front bumper enhances the tractor's durability, protecting it from potential bumps and impacts during operation. Moreover, the tractor is equipped with a large grass bagger attachment, making it easy to collect clippings for a polished lawn appearance.

For those concerned about storage and maintenance, the PB195H42LTX features a compact design that allows easy access to the engine and other components. Maintenance tasks, such as oil changes and blade replacements, can be completed with minimal tools and effort.

In summary, the Poulan PB195H42LTX is a well-equipped lawn tractor that combines power, comfort, and ease of use. With its reliable engine, adjustable cutting deck, and thoughtful design elements, it is an excellent choice for homeowners looking to maintain a pristine lawn with minimal hassle. Whether tackling rough weeds or maintaining well-kept grass, the PB195H42LTX is a capable and efficient ally in lawn care.
Top Page Image Contents