Poulan PB195H42LTX manual Tools Required for Assembly, To Remove Tractor from, Carton, Skid

Page 6

ASSEMBLY

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to insure proper tightness.

TOOLS REQUIRED FOR ASSEMBLY

 

INSERT

5/16 HEX

 

A socket wrench set will make assembly easier. Standard

 

wrench sizes are listed.

BOLT

 

 

 

(1)

1/2" wrench

5/16 LOCK

 

(2)

3/4" wrench

WASHER

 

(3)

Pliers

LARGE FLAT

 

(4)

Utility knife

WASHER

 

 

 

(5)

Tire pressure gauge

 

 

When right or left hand is mentioned in this manual, it means

 

STEERING

when you are in the operating position (seated behind the

 

steering wheel).

 

WHEEL

TO REMOVE TRACTOR FROM

STEERING BOOT

ADAPTER

 

 

 

CARTON

 

 

UNPACK CARTON

TABS

 

• Remove all accessible loose parts and parts cartons

TAB

 

 

from carton.

 

SLOTS

•Cut along dashed lines on all four panels of carton.

Remove end panels and lay side panels flat.

EXTENSION SHAFT

•Check for any additional loose parts or cartons and remove.

BEFORE REMOVING TRACTOR FROM

LOWER STEERING SHAFT

03132

SKID

 

ATTACH STEERING WHEEL (See Fig. 1)

FIG. 1

ASSEMBLE EXTENSION SHAFT AND BOOT

•Slide extension shaft onto lower steering shaft.

• Place tabs of steering boot over tab slots in dash and

INSTALL SEAT (See Figs. 2 and 3)

push down to secure.

• Remove bolt and flat washer securing seat to cardboard

INSTALL STEERING WHEEL

packing and set aside for assembly of seat to tractor.

• Position front wheels of the tractor so they are pointing

Remove the cardboard packing and discard.

straight forward.

• Connect switch to seat.

• Remove steering wheel adapter from steering wheel

• Place seat on seat pan so all three (3) bottom pads

and slide adapter onto steering shaft extension.

are positioned over large slotted holes in pan.

• Position steering wheel so cross bars are horizontal

 

(left to right) and slide inside boot and onto adapter.

 

• Assemble large flat washer, 5/16 lock washer, 5/16 hex

 

bolt and tighten securely.

SEAT

• Snap steering wheel insert into center of steering

SWITCH

wheel.

 

• Remove protective materials from tractor hood and

PAD

grill.

IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN

 

SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO

SLOT

ROLL OFF SKID.

SEAT

 

 

PAN

 

TAPE

 

WIRING HARNESS

 

Fig. 2

6

Page 5 Page 7
Image 6
Page 5 Page 7
Contents PB195H42LTX ModelSafe Operation Practices for Ride-On Mowers General OperationII. Slope Operation Service III. ChildrenIV. Towing Table of Contents Contents of Hardware Pack Carton Tools Required for AssemblyTo Remove Tractor from Before Removing Tractor fromCheck Battery See Fig Check for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate on Hills Using the Reverse Operation SystemReverse Operation System ROS To Operate Mower See FigTowing Carts and Other ATTACH- Ments Before Starting the EngineTo Transport Check Engine OIL LevelAutomatic Transmission Warm UP Mowing TipsPurge Transmission RunningMaintenance To Sharpen Blade See Fig TractorBlade Removal See Fig Check Operator Presence SystemBelts BatteryEngine Transaxle CoolingCleaning To Install Mower See Fig To Remove Mower See FigInstall belt on engine pulley M, in belt keepers G To Level Mower To Replace Motion Belt Drive See Fig Belt InstallationTo Replace Mower Drive Belt see FIG To Check BrakeTo Start Engine with a Weak Battery See Fig Transaxle Motion Control Lever Neutral Adjustment See FigTo Adjust Steering Wheel ALIGN- Ment Front Wheel TOE-IN/CAMBERTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbEngine OIL OtherFuel System CylindersTroubleshooting Points Problem Cause CorrectionEngine dies when Limited Warranty HOPOnly Ride UP and Down Hill Not Across Hill Degrees MAX Fold Along This Dotted Line Degree SlopeService Notes Service Notes Page Page Dentretien Remarques Dentretien Remarques Degrés Suivant LES UNE Pliez EST CeciLimitée Garantie Dépannage DE Guide Centre un contactez corrigé, pas n’est problème le SiRalenti DU Commande LA Régler Pour GAZ DES CommandeEntreposage Réglages ET Révision Tionrecdi CarrossageAVANT/ Roues DES Convergence LA DE L’ALIGNEMENT Régler Pour26 .FIG Fig la Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl PourFreins LES Vérifier Pour 25 .FIG22 .FIG Tondeuse LA Niveau LE Ajuster Pour24 .FIG 23 .FIG20 .FIG 18 .FIG 19 .FIG17 .FIG Fig Voir Courroie LA ET Tondeuse LA InstallerReglages ET Revision Tondeuse LA Enlever Pour’ALLUMAGE Bougie Ligne EN Installé D’ESSENCE FiltreEntretien AIR À FiltreTransmission LA DE Refroidissement LubrificationTrapézoïdales Courroies Fig la Voir Lame LA Affiler Fig la Voir Lame LA EnleverEN Fonctionnement DE Système ET O I T a D N a M M O C E R Lubrification DE TableauUtilisation Chaque Avant Tonte DE Conseils UtilisationTransmission LA Purger 10 .FIG’ESSENCE Réservoir LE Remplir Accessoires AutresMoteur LE Démarrer Pour Moteur DU D’HUILE Niveau LE VérifierTondeuse LA Utiliser Pour MAR EN Fonctionnement DE SystèmePentes LES Dans Utiliser Pour ROS Arrière CHEVoir Reculer Pour ET Avancer Pour GAZ DES Commande LA Utiliser PourFig la Fig la Voir Arrêter PourTracteur Votre Connaissez Propriété la de lendommagement Montage Correctement Sont Courroies LESToutes SI Vérifier Toutes SI Vérifier LA DE Tracteur LE Retirer Pour Rouler Faisant LE EN PaletteEt 2 .Figs les Voir Siège LE Ajustez Fig la Voir DU Tracteur LE Sortir PourMON LE Pour Exigés Outils LES Tionrecdi DE Volant LE FixerMontar SIN Piezas CCA .MIN AMP/HR U1R DimensionSommaire SL-SG-API’utilisation pour Conseils Général EntretienTracteurs des sécurité toute ’ESSENCE DE Sûre ManipulationPentes LES Dans FonctionnementTracteurs des sécurité toute en l’utilisation pour Conseils AUX Imprimé

PB195H42LTX specifications

The Poulan PB195H42LTX is a powerful and versatile lawn tractor designed for homeowners seeking efficiency and ease of use in their lawn care routines. With a cutting edge design and advanced technology, this model stands out in the crowded market of lawn care equipment.

One of the main features of the PB195H42LTX is its robust 19.5 horsepower Briggs & Stratton engine. This engine is known for its reliability and performance, allowing the tractor to tackle various mowing conditions effortlessly. The engine is paired with a smooth hydrostatic transmission, which provides seamless speed adjustments without the need for manual shifting. This user-friendly design enables operators to focus on their mowing tasks without the hassle of changing gears.

The cutting deck on the PB195H42LTX measures a generous 42 inches, making it suitable for medium to large-sized lawns. The deck features a durable steel construction and offers multiple cutting heights, allowing users to customize their mowing experience based on the lawn's requirements. With the ability to cut grass at heights between 1.5 to 4 inches, the tractor ensures a clean and healthy lawn.

In addition to its impressive cutting capabilities, the PB195H42LTX incorporates various technologies that enhance user experience and comfort. The tractor is designed with an ergonomic seat and an adjustable steering wheel, providing maximum comfort during extended mowing sessions. The easy-to-use controls are intuitively placed, ensuring operators can access all functions with minimal effort.

The inclusion of a reinforced front bumper enhances the tractor's durability, protecting it from potential bumps and impacts during operation. Moreover, the tractor is equipped with a large grass bagger attachment, making it easy to collect clippings for a polished lawn appearance.

For those concerned about storage and maintenance, the PB195H42LTX features a compact design that allows easy access to the engine and other components. Maintenance tasks, such as oil changes and blade replacements, can be completed with minimal tools and effort.

In summary, the Poulan PB195H42LTX is a well-equipped lawn tractor that combines power, comfort, and ease of use. With its reliable engine, adjustable cutting deck, and thoughtful design elements, it is an excellent choice for homeowners looking to maintain a pristine lawn with minimal hassle. Whether tackling rough weeds or maintaining well-kept grass, the PB195H42LTX is a capable and efficient ally in lawn care.
Top Page Image Contents