Poulan BB185H42YT manual Mowing Tips, Purge Transmission, Automatic Transmission Warm UP

Page 14

OPERATION

WARM WEATHER STARTING (50° F and above)

•When engine starts, move the throttle control to the fast position.

•The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING ( 50° F and below)

•When engine starts, allow engine to run with the throttle control in the choke position until the engine runs roughly, then move throttle control to fast posi- tion. This may require an engine warm-up period from several seconds to several minutes, depending on the temperature.

AUTOMATIC TRANSMISSION WARM UP

•Before driving the unit in cold weather, the transmission should be warmed up as follows:

•Be sure the tractor is on level ground.

•Place the motion control lever in neutral. Release the parking brake and let the clutch/brake slowly return to operating position.

•Allow one minute for transmission to warm up.This can be done during the engine warm up period.

•Theattachmentscanalsobeusedduringtheenginewarm- up period after the transmission has been warmed up.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjustments section of this manual.

PURGE TRANSMISSION

CAUTION: Never engage or disengage freewheel lever while the engine is run-

ning.

To ensure proper operation and performance, it is recom- mended that the transmission be purged before operating tractor for the first time. This procedure will remove any trapped air inside the transmission which may have de- veloped during shipping of your tractor.

IMPORTANT: SHOULD YOUR TRANSMISSION REQUIRE REMOVAL FOR SERVICE OR REPLACEMENT, IT SHOULD BE PURGED AFTER REINSTALLATION BEFORE OPERATING THE TRACTOR.

•Place tractor safely on level surface with engine off and parking brake set.

•Disengage transmission by placing freewheel control in freewheeling position (See “TO TRANSPORT” in this section of manual).

•Sitting in the tractor seat, start engine. After the engine is running, move throttle control to slow position. With motion control lever in neutral (N) position, slowly dis- engage clutch/brake pedal.

•Move motion control lever to full forward position and hold for five (5) seconds. Move lever to full reverse position and hold for five (5) seconds. Repeat this procedure three (3) times.

NOTE: During this procedure there will be no movement of drive wheels. The air is being removed from hydraulic

•Move motion control lever to neutral (N) position. Shut- off engine and set parking brake.

•Engage transmission by placing freewheel control in engaged position (See “TO TRANSPORT” in this sec- tion of manual).

•Sitting in the tractor seat, start engine. After the engine is running, move throttle control to half (1/2) speed. With motion control lever in neutral (N) position, slowly disengage clutch/brake pedal.

•Slowly move motion control lever forward, after the tractor moves approximately five (5) feet, slowly move motion control lever to reverse position. After the tractor moves approximately five (5) feet return the motion control lever to the neutral (N) position. Repeat this procedure with the motion control lever three (3) times.

•Your transmission is now purged and now ready for normal operation.

MOWING TIPS

•Mower should be properly leveled for best mowing per- formance. See “TO LEVEL MOWER HOUSING” in the Service and Adjustments section of this manual.

•The left hand side of mower should be used for trim- ming.

•Drive so that clippings are discharged onto the area that has been cut. Have the cut area to the right of the machine. This will result in a more even distribution of clippings and more uniform cutting.

•When mowing large areas, start by turning to the right so that clippings will discharge away from shrubs, fences, driveways, etc. After one or two rounds, mow in the opposite direction making left hand turns until finished (See Fig. 9).

FIG. 9

• If grass is extremely tall, it should be mowed twice to reduce load and possible fire hazard from dried clip- pings. Make first cut relatively high; the second to the desired height.

• Do not mow grass when it is wet. Wet grass will plug mower and leave undesirable clumps. Allow grass to dry before mowing.

• Always operate engine at full throttle when mow- ing to assure better mowing performance and proper discharge of material. Regulate ground speed by se- lecting a low enough gear to give the mower cutting performance as well as the quality of cut desired.

• When operating attachments, select a ground speed that will suit the terrain and give best performance of

drive system.

14

the attachment being used.

Page 13 Page 15
Image 14
Page 13 Page 15
Contents BB185H42YT Always Wear EYE Protection During OperationGeneral Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIV. Towing ServiceIII. Children Table of Contents Key Unassembled PartsSteering Wheel Seat Slope SheetTo Remove Tractor from Carton AssemblyTools Required for Assembly Before Removing Tractor from SkidCheck Battery See Fig Check for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Reverse Operation System ROS To Adjust Gauge Wheels See FigTo Operate Mower See Fig To Operate on HillsTo Transport See Figs Before Starting the EngineADD Gasoline Check Engine OIL LevelAutomatic Transmission Warm UP Mowing TipsPurge Transmission General Recommendations MaintenanceLubrication Chart Before Each USETo Sharpen Blade See Fig TractorBlade Removal See Fig Check Operator Presence SystemEngine Cleaning To Level Mower Housing Service and AdjustmentsTo Install Mower See Fig To Remove Mower See FigBelt Removal Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Adjust Brake To Check and Adjust Brake See FigTransaxle Motion Control Lever Neutral Adjustment See Fig To Replace Motion Drive Belt See FigTo Start Engine with a Weak Battery See Fig Transmission REMOVAL/REPLACEMENTTo Adjust Steering Wheel ALIGN- Ment Front Wheel TOE-IN/CAMBERTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbFuel System StorageOther Engine OILTroubleshooting Points Engine dies when Limited Warranty Service Notes Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service

BB185H42YT specifications

The Poulan BB185H42YT is a versatile and efficient riding lawn mower designed to meet the needs of homeowners with medium to large yards. This mower combines ease of use with advanced technology, making it an ideal choice for those seeking performance and reliability in their lawn care routine.

One of the standout features of the BB185H42YT is its powerful engine. It is equipped with an 18.5 HP Briggs & Stratton engine that provides robust performance, enabling the mower to tackle tough grass and uneven terrain with ease. The engine's design ensures efficient fuel consumption, giving users peace of mind while mowing over larger areas without constantly refueling.

The mower features a 42-inch cutting deck, allowing for wider cutting paths and reducing the overall time spent mowing. The deck is constructed from durable steel, ensuring longevity and resilience against the rigors of regular use. Additionally, the BB185H42YT offers multiple cutting height adjustments, enabling homeowners to customize their lawn’s appearance according to their specific requirements.

One of the key technologies present in the Poulan BB185H42YT is the automatic transmission system. This feature allows for smooth speed adjustments while mowing, eliminating the need for manual gear shifting. As a result, users can focus on their mowing tasks without the distraction of managing speeds, ensuring a seamless mowing experience.

Maneuverability is another highlight of the BB185H42YT. With a tight turning radius, this mower can navigate around obstacles, flower beds, and trees with relative ease. This makes it an excellent option for yards with intricate layouts, saving time and effort in achieving a neat and well-manicured lawn.

Comfort is paramount in the design of the BB185H42YT. The mower comes with an adjustable high-back seat, providing ample support during extended mowing sessions. The ergonomic steering wheel design and easy-to-reach controls enhance user comfort, ensuring that mowing duties are less of a chore.

In terms of maintenance, this model is designed with user convenience in mind. The mower features easy-access components for routine checks and maintenance tasks, allowing owners to keep the machine in optimal condition without hassle.

In summary, the Poulan BB185H42YT stands out due to its powerful engine, wide cutting deck, automatic transmission, and user-friendly design. It is an excellent choice for homeowners looking for a reliable and efficient riding lawn mower capable of delivering exceptional results with minimal effort. With its combination of features and technologies, the BB185H42YT makes lawn care a manageable and enjoyable task.
Top Page Image Contents