Poulan BB185H42YT manual Engine

Page 17

MAINTENANCE

Slide blade on to an unthreaded portion of the steel bolt or pin and hold the bolt or pin parallel with the ground. If blade is balanced, it should remain in a horizontal position. If either end of the blade moves downward, sharpen the heavy end until the blade is balanced.

CENTER HOLE

BLADE

5/8" BOLT OR PIN

FIG. 11

BATTERY

Your tractor has a battery charging system which is sufficient for normal use. However, periodic charging of the battery with an automotive charger will extend its life.

Keep battery and terminals clean.

Keep battery bolts tight.

Keep small vent holes open.

Recharge at 6-10 amperes for 1 hour.

NOTE: The original equipment battery on your tractor is maintenance free. Do not attempt to open or remove caps or covers. Adding or checking level of electrolyte is not necessary.

TO CLEAN BATTERY AND TERMINALS

Corrosion and dirt on the battery and terminals can cause the battery to “leak” power.

Disconnect BLACK battery cable first then RED bat- tery cable and remove battery from tractor.

Rinse the battery with plain water and dry.

Clean terminals and battery cable ends with wire brush until bright.

Coat terminals with grease or petroleum jelly.

Reinstall battery (See “REPLACING BATTERY" in the SERVICE AND ADJUSTMENTS section of this manual).

V-BELTS

Check V-belts for deterioration and wear after 100 hours of operation and replace if necessary. The belts are not adjustable. Replace belts if they begin to slip from wear.

TRANSAXLE COOLING

The transmission fan and cooling fins should be kept clean to assure proper cooling.

Do not attempt to clean fan or transmission while engine is running or while the transmission is hot. To prevent pos- sible damage to seals, do not use high pressure water or steam to clean transaxle.

Inspect cooling fan to be sure fan blades are intact and clean.

Inspect cooling fins for dirt, grass clippings and other materials. To prevent damage to seals, do not use compressed air or high pressure sprayer to clean cool- ing fins.

TRANSAXLE PUMP FLUID

The transaxle was sealed at the factory and fluid mainte- nance is not required for the life of the transaxle. Should the transaxle ever leak or require servicing, contact your nearest authorized service center/department.

ENGINE

LUBRICATION

Only use high quality detergent oil rated with API service classification SG-SL. Select the oil’s SAE viscosity grade according to your expected operating temperature.

SAE VISCOSITY GRADES

 

 

 

 

 

 

 

 

 

 

SAE 30

 

 

 

 

 

 

5W-30

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

F

-20

0

 

 

30 32 40

 

60

80

100

C

-30

-20

-10

0

10

20

30

40

TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE

oil_visc_chart1_e

FIG. 12

NOTE: Although multi-viscosity oils (5W30, 10W30 etc.) improve starting in cold weather, they will result in increased oil consumption when used above 32°F. Check your engine oil level more frequently to avoid possible engine damage from running low on oil.

Change the oil after every 50 hours of operation or at least once a year if the tractor is not used for 50 hours in one year.

Check the crankcase oil level before starting the engine and after each eight (8) hours of operation. Tighten oil fill cap/dipstick securely each time you check the oil level.

TO CHANGE ENGINE OIL (See Figs. 12 and 13)

Determine temperature range expected before oil change. All oil must meet API service classification SG-SL.

Be sure tractor is on level surface.

Oil will drain more freely when warm.

Catch oil in a suitable container.

Remove oil fill cap/dipstick. Be careful not to allow dirt to enter the engine when changing oil.

Remove yellow cap from end of drain valve and install the drain tube onto the fitting.

17

Image 17
Contents Always Wear EYE Protection During Operation BB185H42YTSafe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationIV. Towing ServiceIII. Children Table of Contents Steering Wheel Seat Unassembled PartsKey Slope SheetTools Required for Assembly AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidCheck Battery See Fig Check Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Operate Mower See Fig To Adjust Gauge Wheels See FigReverse Operation System ROS To Operate on HillsADD Gasoline Before Starting the EngineTo Transport See Figs Check Engine OIL LevelAutomatic Transmission Warm UP Mowing TipsPurge Transmission Lubrication Chart MaintenanceGeneral Recommendations Before Each USEBlade Removal See Fig TractorTo Sharpen Blade See Fig Check Operator Presence SystemEngine Cleaning To Install Mower See Fig Service and AdjustmentsTo Level Mower Housing To Remove Mower See FigBelt Removal Belt InstallationTo Replace Mower Blade Drive Belt See Fig Transaxle Motion Control Lever Neutral Adjustment See Fig To Check and Adjust Brake See FigTo Adjust Brake To Replace Motion Drive Belt See FigTo Adjust Steering Wheel ALIGN- Ment Transmission REMOVAL/REPLACEMENTTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbOther StorageFuel System Engine OILTroubleshooting Points Engine dies when Limited Warranty Service Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationParts and Service

BB185H42YT specifications

The Poulan BB185H42YT is a versatile and efficient riding lawn mower designed to meet the needs of homeowners with medium to large yards. This mower combines ease of use with advanced technology, making it an ideal choice for those seeking performance and reliability in their lawn care routine.

One of the standout features of the BB185H42YT is its powerful engine. It is equipped with an 18.5 HP Briggs & Stratton engine that provides robust performance, enabling the mower to tackle tough grass and uneven terrain with ease. The engine's design ensures efficient fuel consumption, giving users peace of mind while mowing over larger areas without constantly refueling.

The mower features a 42-inch cutting deck, allowing for wider cutting paths and reducing the overall time spent mowing. The deck is constructed from durable steel, ensuring longevity and resilience against the rigors of regular use. Additionally, the BB185H42YT offers multiple cutting height adjustments, enabling homeowners to customize their lawn’s appearance according to their specific requirements.

One of the key technologies present in the Poulan BB185H42YT is the automatic transmission system. This feature allows for smooth speed adjustments while mowing, eliminating the need for manual gear shifting. As a result, users can focus on their mowing tasks without the distraction of managing speeds, ensuring a seamless mowing experience.

Maneuverability is another highlight of the BB185H42YT. With a tight turning radius, this mower can navigate around obstacles, flower beds, and trees with relative ease. This makes it an excellent option for yards with intricate layouts, saving time and effort in achieving a neat and well-manicured lawn.

Comfort is paramount in the design of the BB185H42YT. The mower comes with an adjustable high-back seat, providing ample support during extended mowing sessions. The ergonomic steering wheel design and easy-to-reach controls enhance user comfort, ensuring that mowing duties are less of a chore.

In terms of maintenance, this model is designed with user convenience in mind. The mower features easy-access components for routine checks and maintenance tasks, allowing owners to keep the machine in optimal condition without hassle.

In summary, the Poulan BB185H42YT stands out due to its powerful engine, wide cutting deck, automatic transmission, and user-friendly design. It is an excellent choice for homeowners looking for a reliable and efficient riding lawn mower capable of delivering exceptional results with minimal effort. With its combination of features and technologies, the BB185H42YT makes lawn care a manageable and enjoyable task.