Poulan 418757, 96012008400 manual Install Seat See Fig, Check Battery See Fig

Page 7

ASSEMBLY

INSTALL SEAT (See Fig. 2)

Adjust seat before tightening adjustment knob.

•Remove adjustment knob and flat washer securing seat to cardboard packing and set aside for assembly of seat to tractor.

•Pivot seat upward and remove from the cardboard pack- ing. Remove the cardboard packing and discard.

•Place seat on seat pan so head of shoulder bolts are positioned over the large slotted holes in pan.

•Push down on seat to engage shoulder bolts in slots and pull seat towards rear of tractor.

•Pivot seat and pan forward and assemble adjustment knob and flat washer loosely. Do not tighten.

•Lower seat into operating position and sit in seat.

•Slide seat until a comfortable position is reached which allows you to press clutch/brake pedal all the way down.

•Get off seat without moving its adjusted position.

•Raise seat and tighten adjustment knob securely.

SEAT SHOULDER

BOLT

SEAT PAN

FLAT WASHER

02464

ADJUSTMENT

KNOB

FIG. 2

CHECK BATTERY (See Fig. 3)

•Lift seat pan to raised position.

•If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 amps. (See "BATTERY" in MAINTENANCE section of this manual for charging instructions).

SEAT PAN

LABEL

FIG. 3

NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.

WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

TO ROLL TRACTOR OFF SKID (See Op- eration section for location and function of controls)

•Press lift lever plunger and raise attachment lift lever to its highest position.

•Release parking brake by depressing clutch/brake pedal.

•Place gearshift lever in neutral (N) position.

•Roll tractor forward off skid.

•Remove banding holding the deflector shield up against tractor.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Lawn Tractor Model PBA19542LTXII. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIII. Children ServiceIV. Towing Table of Contents Keys Unassembled PartsSteering Wheel SeatBefore Removing Tractor from Skid AssemblyTools Required for Assembly To Remove Tractor from CartonCheck Battery See Fig Install Seat See FigCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor HOW to USE Your Tractor Reverse Operation System ROS To Operate Mower See FigTo Operate on Hills ADD Gasoline Before Starting the EngineTo Transport Check Engine OIL LevelMowing Tips Check Brake Operation Check Tire Pressure MaintenanceGeneral Recommendations Before Each USECheck Operator Presence System TractorBlade Removal See Fig To Sharpen Blade See FigEngine Muffler CleaningClean AIR Screen AIR FilterTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See Fig To Level Mower HousingRecheck side-to-side adjustment To Replace Motion Drive Belt See Fig Belt InstallationTo Check Brake To Replace Mower Blade Drive Belt See FigFront Wheel TOE-IN/CAMBER Transaxle Gear Shift Lever NEUTRAL- Adjustment See FigTo Start Engine with a Weak Battery See Fig To Adjust Steering Wheel ALIGN- MentInterlocks and Relays To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine dies when Stevens Creek Road Terry Fox Way Augusta, GA 30907 USA Outdoor Products Customer Service DeptHOP Canada contactService Notes Suggested Guide for Sighting Slopes for Safe Operation Parts and Service Changere DE Pièces LES ET L’ENTRETIEN UNE Pliez EST Ceci Degrés Suivant LES’ENTRETIEN Remarques Autorisé Dept Service Customer Products Outdoor Canada AuGarantie cette de exclus sont normal l’entretien et Conducteur le lorsque Dépannage DE GuideLame de mandrin le Remplacez Tordu est lame de mandrin Un Moteur EntreposageTracteur Moteur Reglages ET RevisionVoir Vitesses DE Boîte LA DE Mentge Rossage -AVANT/CAR Roues DES ConvergenceLA DE L’ALIGNEMENT Régler Pour Fig la’EN Courroie LA Remplacer Pour Fig la VoirCourroie Acer Rempl Pour 17 .FIG Tondeuse DE Boîtier LE Niveler Pour19 .FIG 18 .FIG15 .FIG Tracteur’AIR Tamis LE Nettoyer Entretien’ALLUMAGE Bougie AIR À FiltreTrapézoïdales Courroies Sionmistrans LA DE Moteur FluideTransmission LA DE Refroidissement Fig la Voir Lame LA AffilerEN Fonctionnement DE Système ET Fig la Voir Lame LA EnleverUtilisation Chaque Avant Recommandations LESGénérales Lubrification DE TableauTondre DE Conseils UtilisationAvec marcher le-faites moteur, le démarrez vous Quand Moteur LE Démarrer DE Avant Fonction DE Système DU Utilisation Pentes LES Dans Utiliser PourMAR EN Fonctionnement DE Système Fig la Voir Arrêter Pour GAZ DES Commande LA Utiliser PourTeurtrac Votre Utiliser Comment Reculer Pour ET Avancer PourLSW02838 ’EMBRAYAGE PA LA DE Tracteur LE Retirer Pour MontageDesmancom des tionfonc la et Tionsec la Voir Conduisant LE EN LetteCom des fonction la et mentceplalem Fig la Voir Siège LE InstallerVotre Monter Comment DesmanPalette LA DU Tracteur LE Sortir PourToncar Pente-Guide Montées NON PiécesCCA .MIN AMP/HR SommaireClient DU Responsabilités Produit DE SpécificationsGénéral Entretien EntretienRemorquage EnfantsTracteurs des sécurité toute en l’utilisation pour Conseils TESPEN LES Dans Fonctionnement Général FonctionnementCom.poulan.www web site notre Visitez LTX19542PBA ModèleAUX Imprimé

418757, 96012008400 specifications

The Poulan 96012008400 418757 is a robust and reliable chainsaw that has garnered attention among both casual users and professional arborists. Designed primarily for cutting firewood and maintaining trees, this chainsaw is a quintessential tool for outdoor enthusiasts and homeowners alike.

One of the standout features of this model is its powerful engine. Fitted with a 20-inch bar, the chainsaw is equipped to handle larger cutting tasks with ease. The engine delivers strong performance, allowing for efficient cutting through hardwood and softwood alike, making it versatile for various applications. Furthermore, the chainsaw's lightweight design ensures that it is manageable for extended use, offering comfort during long periods of operation.

The Poulan 96012008400 418757 is designed with advanced technologies that enhance user safety and operational efficiency. It features an automatic oiler that provides constant lubrication to the chain, ensuring a smooth cutting experience while reducing wear and tear. This technology minimizes the need for manual adjustments, allowing users to focus more on their tasks. Additionally, the chain brake feature is a crucial safety element, designed to protect the user in the event of kickback, allowing for a quick stop of the chain movement.

Another impressive characteristic of the Poulan chainsaw is its easy-start system. This technology reduces the effort required to start the engine, making it accessible for all users, regardless of their experience level. The ergonomic design of the handles also contributes to user comfort, with rubber grips that absorb vibration, preventing fatigue during longer cutting sessions.

Maintenance is simplified with easy-access air filters and spark plugs, allowing users to keep their saw in top condition without the hassle of complicated disassemblies. The Poulan 96012008400 418757 also boasts a durable construction, featuring a high-quality plastic body that resists wear from environmental factors, extending the life of the equipment.

In summary, the Poulan 96012008400 418757 chainsaw combines power, safety, and user-friendly design, making it an outstanding choice for anyone in need of a reliable cutting tool. Its blend of advanced features and durability ensures that it is well-equipped to tackle a variety of cutting tasks with confidence and efficiency.
Top Page Image Contents