Hitachi CP-X4014WN, CP-WX3014WN, CP-X3014WN Communication settings, Half-Duplex/Full-Duplex

Page 16

Network Bridge Communication (continued)

Communication settings

For communication setting, use the OPTION - SERVICE - COMMUNICATION menu. (OPTION menu - SERVICE - COMMUNICATION in the Operating Guide)

Item

Condition

BAUD RATE	4800bps / 9600bps / 19200bps / 38400bps
Data length	8 bit (ﬁxed)
PARITY	NONE/ODD/EVEN
Start bit	1 bit (ﬁxed)
Stop bit	1 bit (ﬁxed)
Transmission method	HALF-DUPLEX/FULL-DUPLEX

NOTE • For connecting the projector to your devices, please read the manual for each devices, and connect them correctly with suitable cables.

•Turn off (the power of ) both the projector and other devices and unplug , beore connecting them.

•For details of Transmission method, refer to 6.4 Transmission method in the Network Guide.

16

Image 16

Contents Example of computer signal CP-X2514WN/CP-X3014WN/ CP-X4014WN/CP-WX3014WNInitial set signals TextConnection to the ports Computer IN1, B Computer IN2, C Monitor OUTVideo SDA SCLCEC USB Type a 㪭㫀㪻㪼㫆 Connection RS-232C CommunicationCommunicaion settings ProtocolResponse code / Error code h shows hexadecimal Command Control via the Network Communicaion Port Port1 Port Command control settings TCP #9715 Command formatAuthentication Automatic Connection BreakNetwork Bridge Communication Communication settings HALF-DUPLEX/FULL-DUPLEXRS-232C Communication / Network command table MagnifyFreeze PictureContrast BrightnessGamma Color Temp Gain RGain G Gain BColor Temp Offset R Offset GColor Temp Offset G Offset BPhase Auto AdjustOver Scan PositionECO Mode Hdmi FormatHdmi Range Computer IN1Volume StandbyMonitor OUT LANVolume Hdmi Volume LANVolume USB Volume ALLSound EnableHdmi Audio MIC Volume MIC LevelLanguage MenuMenu Position BlankStart UP MessagePower on Auto PowerAuto DirectMY BUTTON-2 MY SourceRemote Freq NormalMY Image PJLink command Avmt ?Inst ?

Related manuals

Manual 1 pages 12.33 Kb