Poulan 417920 manual Tractor See Fig, To Remove Mower, To Install Mower, To Level Mower

Page 20

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS:

•Depress brake pedal fully and set parking brake.

•Place attachment clutch in “DISENGAGED” position.

•Turn ignition key to “STOP” and remove key.

•Make sure the blades and all moving parts have completely stopped.

•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TRACTOR (See Fig. 27)

TO REMOVE MOWER

•Place attachment clutch in “DISENGAGED” posi- tion.

•Lower attachment lift lever to its lowest position.

•Disengage belt tension rod (K) from lock bracket

(L).

CAUTION: Belt tension rod is spring loaded. Have a tight grip on rod and release slowly.

•Remove mower belt from electric clutch pulley

•Disconnect front link (E) from mower - remove retainer spring and washer.

•Go to either side of mower and disconnect mower suspension arm (A) from chassis and rear lift link

(C)from rear mower bracket (D) - remove retainer springs and washers.

•Go to other side of mower and disconnect the suspension arm and rear lift link.

•From right side of mower, disconnect anti-sway bar (S) from right rear mower bracket (D) - remove retainer spring and washer and pull mower toward you until the bar falls from the hole in bracket.

•Turn tractor steering wheel to the left as far as it will go.

•Slide mower out from under right side of tractor.

TO INSTALL MOWER

Follow procedure described in “INSTALL MOWER AND DRIVE BELT” in the Assembly section of this manual.

TO LEVEL MOWER

Make sure tires are properly inflated to the PSI shown on tires. If tires are over or under inflated, it may affect the appearance of your lawn and lead you to think the mower is not adjusted properly.

VISUAL SIDE-TO-SIDE ADJUSTMENT (See Fig. 28)

•With all tires properly inflated and if your lawn ap- pears unevenly cut, determine which side of mower is cutting lower.

CAUTION: After rear lift links are dis- connected, the attachment lift lever will be spring loaded. Have a tight grip on lift lever when changing position of the lever.

NOTE: As desired, you can raise the low side of mower or lower the high side.

•Go to side of mower you wish to adjust.

LB

M

K

F

A

E

H

S

C

D

FIG. 27

20

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Model 417920 11.02.07 BMII. Slope Operation Safe Operation Practices for Ride-On MowersGeneral Operation Service General ServiceIII. Children IV. TowingTable of Contents To Remove Tractor from Carton Unpack CartonTighten securely Install Mower and Drive BeltRoll tractor forward off skid First Install ANTI-SWAY BAR S Pivot bar towards you and insert other end of barCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor Reverse Operation System ROS on PositionHOW to USE Your Tractor StoppingTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigTo USE Cruise Control -J See Fig To Operate MowerService REMINDER/HOUR Meter Reverse Operation System ROSTo Operate on Hills To Transport See FigsBefore Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See FigMowing Tips Lubrication Chart Before Each USEBattery TractorBrake Operation TiresEngine Cleaning Engine OIL FilterMuffler Spark PlugsTo Install Mower Tractor See FigTo Remove Mower To Level MowerPrecision SIDE-TO-SIDE Adjustment See Fig To Replace Motion Drive Belt To Replace Mower Blade Drive BeltTo Check Brake To Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbOther Fuel SystemEngine OIL CylindersTroubleshooting Points Problem Cause CorrectionMower blades will not Limited Warranty Only Ride UP and Down Hill Not Across Hill Degrees MAX Fold Along This Dotted Line Degree SlopeService Notes Service Notes Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Dentretien Notes Dentretien Notes Degrés Suivant LES Pliez ESTLimitée Garantie Acheté l’avez vous qui chez autorisé concessionnaireDépannage DE Guide Correction Cause ProblèmeLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage DU Commande LA Régler Pour GAZ DES CommandeReglages ET Revision Carburateur LE Régler PourRoue LA DE PINCEMENT/CARROSSAGE Fig la Voir Tionsraparé LES Pour Roues LES Enlever PourAvant Courroie Acer Rempl Pour LA DE Lame LA DE D’ENTRAÎNEMENT’ENTRAÎNEMENT Freins LES Vérifier PourAVANT/ARRIÈRE Ajustement Tondeuse LA Installer Pour Fig la VoirTondeuse LA Niveau LE Ajuster Pour Tondeuse LA Enlever PourLigne EN Installe Dessence Filtre Entretien’ALLUMAGE Bougie Moteur DE D’HUILE FiltreAIR À Filtre ’AIR Tamis LE NettoyerLubrification Sionmistrans LA DE Moteur FluideEN Fonctionnement DE Système ET Fig la Voir Lame LA EnleverLames DES Entretien Utilisation Chaque Avant Généra Recommandations LESLubrification DE Tableau 22 .FIG UtilisationTransmission LA Purger Moteur LE Démarrer Pour ’ESSENCE Réservoir LE RemplirMoteur DU D’HUILE Niveau LE Vérifier QuetimaMAR EN Fonctionnement DE Système ’ENTRETIEN/HOROMÈTRE Indicateur21 et 13 .Fig les Voir Fig la Voir J- Vitess DE Régulateur LE Utiliser Comment Tondeuse LA Utiliser PourJauge DE Roues LES Régler Pour Système DU CaractéristiquesGAZ DES Commande LA Utiliser Pour Fig la Voir MentneTionsta DE Frein LE Engager Pour Reculer Pour ET Avancer Pour13 .FIG ’EMBRAYAGE Montage NI DE EST Tondeuse LA SI VérifierROULIS-ANTI Barre LA D’ABORD Installez 10 .FIGLA DE Latéraux Suspension DE Bras LES Fixez De avant l’avant vers pointent a tondeuse la de latérauxPA LA DE Tracteur LE Retirer Pour PAL LA DE Tracteur LE Retirer PourMontées NON Piéces Toncar DU Tracteur LE Sortir PourSommaire Garantie ’ENTRETIEN GuideUtilisation Réglages ET Révision Produit DE SpécificationsGénéral Entretien Tracteurs des sécurité touteEn l’utilisation pour Conseils ’ESSENCE DE Sûre ManipulationMentsegneusoi vous-Lavez .tionducprore la de troubles TESTracteurs des sécurité toute en l’utilisation pour Conseils Avertissement AUX ImpriméBM 07.02.11

417920 specifications

The Poulan 417920 is a powerful and efficient chainsaw designed for both casual users and professionals alike. It stands out in the market for its combination of performance, durability, and user-friendly features. Built with a robust 42cc engine, the Poulan 417920 delivers an impressive power-to-weight ratio, making it suitable for various cutting tasks, from trimming small branches to felling larger trees.

One of the standout features of the Poulan 417920 is its Easy Start system. This technology reduces the resistance in the pull cord, allowing users to start the chainsaw with minimal effort. The automatic oiling system is another key characteristic, ensuring that the chainsaw chain remains lubricated during operation. This not only enhances cutting efficiency but also prolongs the life of the chain and bar.

The 417920 features a 16-inch bar, which strikes a perfect balance between maneuverability and cutting capacity. The low-vibration design of the chainsaw helps reduce user fatigue during extended use, making it comfortable to operate for longer periods. The anti-vibration handle contributes to this comfort, allowing users to maintain better control while cutting.

Safety is a major consideration in the design of the Poulan 417920. It comes equipped with a chain brake that activates quickly in case of kickback, providing a vital layer of protection for the operator. Additionally, the chainsaw features a protective cover to shield the chain and bar when not in use, further enhancing its safety profile.

The Poulan 417920 also emphasizes ease of maintenance. The tool-less chain tensioning system allows for quick adjustments without the need for additional tools, saving time and effort. The accessible air filter is designed for easy cleaning, which helps maintain optimal engine performance.

In conclusion, the Poulan 417920 chainsaw embodies a blend of power, safety, and convenience. Its user-friendly features, such as the Easy Start system and tool-less adjustments, make it an ideal choice for both novice and experienced users. With its durable construction and advanced technology, the Poulan 417920 is well-equipped to handle a wide range of cutting tasks, ensuring that it remains a reliable companion for all your outdoor projects.
Top Page Image Contents