Poulan 417920 manual Reverse Operation System ROS, To Operate on Hills, To Transport See Figs

Page 13

OPERATION

S

FIG. 20

REVERSE OPERATION SYSTEM (ROS)

Your tractor is equipped with a Reverse Operation Sys- tem (ROS). Any attempt by the operator to travel in the reverse direction with the attachment clutch engaged will shut off the engine unless ignition key is placed in the ROS "ON" position.

WARNING: Backing up with the attachment clutch engaged while mowing is strongly discouraged. Turn- ing the ROS "ON", to allow reverse operation with the attachment clutch engaged, should only be done when the operator decides it is necessary to reposition the machine with the attachment engaged. Do not mow in reverse unless absolutely necessary.

USING THE REVERSE OPERATION SYSTEM -

Only use if you are certain no children or other bystand- ers will enter the mowing area.

•Depress brake pedal all the way down.

•With engine running, turn ignition key counter- clockwise to ROS "ON" position.

•Look down and behind before and while backing.

•Slowly depress reverse drive pedal to start move- ment.

•When use of the ROS is no longer needed, turn the ignition key clockwise to engine "ON" position.

ROS "ON" POSITION

ENGINE "ON" POSITION

 

(NORMAL OPERATING)

02828

TO OPERATE ON HILLS

CAUTION: Do not drive up or down hills with slopes greater than 15° and do not drive across any slope.

•Choose the slowest speed before starting up or down hills.

•Avoid stopping or changing speed on hills.

•If stopping is absolutely necessary, push brake pedal quickly to brake position and engage parking brake.

•To restart movement, slowly release parking brake and brake pedal.

•Slowly depress appropriate drive pedal to slowest setting.

•Make all turns slowly.

TO TRANSPORT (See Figs. 13 and 21)

When pushing or towing your tractor, be sure to dis- engage transmission by placing freewheel control in freewheeling position. Free wheel control is located at the rear drawbar of tractor.

•Raise attachment lift to highest position with at- tachment lift control.

•Pull freewheel control out and down into the slot and release so it is held in the disengaged posi- tion.

•Do not push or tow tractor at more than two (2) MPH.

•To reengage transmission, reverse above proce- dure.

NOTE: To protect hood from damage when transport- ing your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

Transmission Engaged

Transmission Disengaged

FIG. 21

SERVICE REMINDER/HOUR METER

Service reminder shows the total number of hours the engine has run and flashes to indicate that the engine or mower needs servicing. When service is required, the service reminder will flash for two hours. To ser- vice engine and mower, see the Maintenance section of this manual.

NOTE: Service reminder runs when the ignition key is in any position but "STOP". For accurate reading, be sure key remains in the "STOP" position when engine is not running.

TOWING CARTS AND OTHER ATTACHMENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your tractor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents 417920 11.02.07 BM ModelGeneral Operation Safe Operation Practices for Ride-On MowersII. Slope Operation General Service ServiceIII. Children IV. TowingTable of Contents Unpack Carton To Remove Tractor from CartonRoll tractor forward off skid Install Mower and Drive BeltTighten securely Pivot bar towards you and insert other end of bar First Install ANTI-SWAY BAR SCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Reverse Operation System ROS on Position Know Your TractorStopping HOW to USE Your TractorTo Adjust Gauge Wheels See Fig To Adjust Mower Cutting Height See FigTo USE Cruise Control -J See Fig To Operate MowerReverse Operation System ROS Service REMINDER/HOUR MeterTo Operate on Hills To Transport See FigsCheck Engine OIL Level Before Starting the EngineADD Gasoline To Start Engine See FigMowing Tips Before Each USE Lubrication ChartTractor BatteryBrake Operation TiresEngine Engine OIL Filter CleaningMuffler Spark PlugsTractor See Fig To Install MowerTo Remove Mower To Level MowerPrecision SIDE-TO-SIDE Adjustment See Fig To Check Brake To Replace Mower Blade Drive BeltTo Replace Motion Drive Belt Front Wheel TOE-IN/CAMBER To Start Engine with a Weak Battery See FigTo Remove Wheel for Repairs See Fig To Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbFuel System OtherEngine OIL CylindersProblem Cause Correction Troubleshooting PointsMower blades will not Limited Warranty Fold Along This Dotted Line Degree Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXService Notes Service Notes Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Dentretien Notes Dentretien Notes Pliez EST Degrés Suivant LESAcheté l’avez vous qui chez autorisé concessionnaire Limitée GarantieCorrection Cause Problème Dépannage DE GuideLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage GAZ DES Commande DU Commande LA Régler PourReglages ET Revision Carburateur LE Régler PourAvant Fig la Voir Tionsraparé LES Pour Roues LES Enlever PourRoue LA DE PINCEMENT/CARROSSAGE LA DE Lame LA DE D’ENTRAÎNEMENT Courroie Acer Rempl Pour’ENTRAÎNEMENT Freins LES Vérifier PourAVANT/ARRIÈRE Ajustement Fig la Voir Tondeuse LA Installer PourTondeuse LA Niveau LE Ajuster Pour Tondeuse LA Enlever PourEntretien Ligne EN Installe Dessence Filtre’ALLUMAGE Bougie Moteur DE D’HUILE Filtre’AIR Tamis LE Nettoyer AIR À FiltreLubrification Sionmistrans LA DE Moteur FluideLames DES Entretien Fig la Voir Lame LA EnleverEN Fonctionnement DE Système ET Lubrification DE Tableau Généra Recommandations LESUtilisation Chaque Avant Transmission LA Purger Utilisation22 .FIG ’ESSENCE Réservoir LE Remplir Moteur LE Démarrer PourMoteur DU D’HUILE Niveau LE Vérifier Quetima21 et 13 .Fig les Voir ’ENTRETIEN/HOROMÈTRE IndicateurMAR EN Fonctionnement DE Système Tondeuse LA Utiliser Pour Fig la Voir J- Vitess DE Régulateur LE Utiliser CommentJauge DE Roues LES Régler Pour Système DU CaractéristiquesFig la Voir Mentne GAZ DES Commande LA Utiliser PourTionsta DE Frein LE Engager Pour Reculer Pour ET Avancer Pour13 .FIG ’EMBRAYAGE NI DE EST Tondeuse LA SI Vérifier Montage10 .FIG ROULIS-ANTI Barre LA D’ABORD InstallezLA DE Latéraux Suspension DE Bras LES Fixez De avant l’avant vers pointent a tondeuse la de latérauxPAL LA DE Tracteur LE Retirer Pour PA LA DE Tracteur LE Retirer PourToncar DU Tracteur LE Sortir Pour Montées NON PiécesGarantie ’ENTRETIEN Guide SommaireUtilisation Réglages ET Révision Produit DE SpécificationsTracteurs des sécurité toute Général EntretienEn l’utilisation pour Conseils ’ESSENCE DE Sûre ManipulationTracteurs des sécurité toute en l’utilisation pour Conseils TESMentsegneusoi vous-Lavez .tionducprore la de troubles BM 07.02.11 AUX ImpriméAvertissement

417920 specifications

The Poulan 417920 is a powerful and efficient chainsaw designed for both casual users and professionals alike. It stands out in the market for its combination of performance, durability, and user-friendly features. Built with a robust 42cc engine, the Poulan 417920 delivers an impressive power-to-weight ratio, making it suitable for various cutting tasks, from trimming small branches to felling larger trees.

One of the standout features of the Poulan 417920 is its Easy Start system. This technology reduces the resistance in the pull cord, allowing users to start the chainsaw with minimal effort. The automatic oiling system is another key characteristic, ensuring that the chainsaw chain remains lubricated during operation. This not only enhances cutting efficiency but also prolongs the life of the chain and bar.

The 417920 features a 16-inch bar, which strikes a perfect balance between maneuverability and cutting capacity. The low-vibration design of the chainsaw helps reduce user fatigue during extended use, making it comfortable to operate for longer periods. The anti-vibration handle contributes to this comfort, allowing users to maintain better control while cutting.

Safety is a major consideration in the design of the Poulan 417920. It comes equipped with a chain brake that activates quickly in case of kickback, providing a vital layer of protection for the operator. Additionally, the chainsaw features a protective cover to shield the chain and bar when not in use, further enhancing its safety profile.

The Poulan 417920 also emphasizes ease of maintenance. The tool-less chain tensioning system allows for quick adjustments without the need for additional tools, saving time and effort. The accessible air filter is designed for easy cleaning, which helps maintain optimal engine performance.

In conclusion, the Poulan 417920 chainsaw embodies a blend of power, safety, and convenience. Its user-friendly features, such as the Easy Start system and tool-less adjustments, make it an ideal choice for both novice and experienced users. With its durable construction and advanced technology, the Poulan 417920 is well-equipped to handle a wide range of cutting tasks, ensuring that it remains a reliable companion for all your outdoor projects.
Top Page Image Contents