Poulan 417920 manual Install Mower and Drive Belt, Roll tractor forward off skid, Tighten securely

Page 6

ASSEMBLY

A

FIG. 2

NOTE: You may now roll or drive your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid.

WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

TO ROLL TRACTOR OFF SKID (See Op- eration section for location and function of controls)

•Raise attachment lift lever to its highest position.

•Release parking brake by depressing brake ped- al.

•Place freewheel control in disengaged position to disengage transmission (See “TO TRANSPORT” in the Operation section of this manual).

•Roll tractor forward off skid.

TO DRIVE TRACTOR OFF SKID (See Op- eration section for location and function of controls)

•Be sure all the above assembly steps have been completed.

•Check engine oil level and fill fuel tank with gaso- line.

•Place freewheel control in "transmission engaged" position (see "TO TRANSPORT" in Operation sec- tion of this manual).

•Sit on seat in operating position, depress brake pedal and set the parking brake.

•Raise attachment lift lever to its highest position.

•Remove key from bag and start the engine (see "TO START" in the Operation section of this manual). After engine has started, move throttle control to idle (slow) position.

•Release parking brake.

•Slowly depress forward drive pedal and drive trac- tor off skid.

ASSEMBLE FRONT WHEEL TO MOWER (See Fig. 3)

•Using shoulder bolt, washer and locknut from parts bag, assemble front wheel to mower as shown.

Tighten securely.

6

 

FIG. 3

INSTALL MOWER AND DRIVE BELT

(See Figs. 4-12)

See MOWER AND DRIVE BELT ASSEMBLY Supplement Sheet for additional guidance on this assembly.

Be sure tractor is on level surface and engage park- ing brake.

•Lower attachment lift lever to lowest position.

CAUTION: Lift lever is spring loaded. Have a tight grip on lift lever, lower it slowly and engage in lowest position.

•Turn steering wheel to the left as far as it will go and position mower on right side of tractor with deflector shield to the right.

02965

FIG. 4

•Remove plastic tie securing belt, bring belt forward and check belt for proper routing in all mower pul- ley grooves.

A

FIG. 5

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Model 417920 11.02.07 BMSafe Operation Practices for Ride-On Mowers General OperationII. Slope Operation III. Children ServiceGeneral Service IV. TowingTable of Contents To Remove Tractor from Carton Unpack CartonInstall Mower and Drive Belt Roll tractor forward off skidTighten securely First Install ANTI-SWAY BAR S Pivot bar towards you and insert other end of barCheck for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor Reverse Operation System ROS on PositionHOW to USE Your Tractor StoppingTo USE Cruise Control -J See Fig To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig To Operate MowerTo Operate on Hills Service REMINDER/HOUR MeterReverse Operation System ROS To Transport See FigsADD Gasoline Before Starting the EngineCheck Engine OIL Level To Start Engine See FigMowing Tips Lubrication Chart Before Each USEBrake Operation BatteryTractor TiresEngine Muffler CleaningEngine OIL Filter Spark PlugsTo Remove Mower To Install MowerTractor See Fig To Level MowerPrecision SIDE-TO-SIDE Adjustment See Fig To Replace Mower Blade Drive Belt To Check BrakeTo Replace Motion Drive Belt To Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Remove Wheel for Repairs See Fig To Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbEngine OIL OtherFuel System CylindersTroubleshooting Points Problem Cause CorrectionMower blades will not Limited Warranty Only Ride UP and Down Hill Not Across Hill Degrees MAX Fold Along This Dotted Line Degree SlopeService Notes Service Notes Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Dentretien Notes Dentretien Notes Degrés Suivant LES Pliez ESTLimitée Garantie Acheté l’avez vous qui chez autorisé concessionnaireDépannage DE Guide Correction Cause ProblèmeLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage Reglages ET Revision DU Commande LA Régler PourGAZ DES Commande Carburateur LE Régler PourFig la Voir Tionsraparé LES Pour Roues LES Enlever Pour AvantRoue LA DE PINCEMENT/CARROSSAGE ’ENTRAÎNEMENT Courroie Acer Rempl PourLA DE Lame LA DE D’ENTRAÎNEMENT Freins LES Vérifier PourAVANT/ARRIÈRE Ajustement Tondeuse LA Niveau LE Ajuster Pour Tondeuse LA Installer PourFig la Voir Tondeuse LA Enlever Pour’ALLUMAGE Bougie Ligne EN Installe Dessence FiltreEntretien Moteur DE D’HUILE FiltreLubrification AIR À Filtre’AIR Tamis LE Nettoyer Sionmistrans LA DE Moteur FluideFig la Voir Lame LA Enlever Lames DES EntretienEN Fonctionnement DE Système ET Généra Recommandations LES Lubrification DE TableauUtilisation Chaque Avant Utilisation Transmission LA Purger22 .FIG Moteur DU D’HUILE Niveau LE Vérifier Moteur LE Démarrer Pour’ESSENCE Réservoir LE Remplir Quetima’ENTRETIEN/HOROMÈTRE Indicateur 21 et 13 .Fig les VoirMAR EN Fonctionnement DE Système Jauge DE Roues LES Régler Pour Fig la Voir J- Vitess DE Régulateur LE Utiliser CommentTondeuse LA Utiliser Pour Système DU CaractéristiquesTionsta DE Frein LE Engager Pour GAZ DES Commande LA Utiliser PourFig la Voir Mentne Reculer Pour ET Avancer Pour13 .FIG ’EMBRAYAGE Montage NI DE EST Tondeuse LA SI VérifierLA DE Latéraux Suspension DE Bras LES Fixez ROULIS-ANTI Barre LA D’ABORD Installez10 .FIG De avant l’avant vers pointent a tondeuse la de latérauxPA LA DE Tracteur LE Retirer Pour PAL LA DE Tracteur LE Retirer PourMontées NON Piéces Toncar DU Tracteur LE Sortir PourUtilisation SommaireGarantie ’ENTRETIEN Guide Réglages ET Révision Produit DE SpécificationsEn l’utilisation pour Conseils Général EntretienTracteurs des sécurité toute ’ESSENCE DE Sûre ManipulationTES Tracteurs des sécurité toute en l’utilisation pour ConseilsMentsegneusoi vous-Lavez .tionducprore la de troubles AUX Imprimé BM 07.02.11Avertissement

417920 specifications

The Poulan 417920 is a powerful and efficient chainsaw designed for both casual users and professionals alike. It stands out in the market for its combination of performance, durability, and user-friendly features. Built with a robust 42cc engine, the Poulan 417920 delivers an impressive power-to-weight ratio, making it suitable for various cutting tasks, from trimming small branches to felling larger trees.

One of the standout features of the Poulan 417920 is its Easy Start system. This technology reduces the resistance in the pull cord, allowing users to start the chainsaw with minimal effort. The automatic oiling system is another key characteristic, ensuring that the chainsaw chain remains lubricated during operation. This not only enhances cutting efficiency but also prolongs the life of the chain and bar.

The 417920 features a 16-inch bar, which strikes a perfect balance between maneuverability and cutting capacity. The low-vibration design of the chainsaw helps reduce user fatigue during extended use, making it comfortable to operate for longer periods. The anti-vibration handle contributes to this comfort, allowing users to maintain better control while cutting.

Safety is a major consideration in the design of the Poulan 417920. It comes equipped with a chain brake that activates quickly in case of kickback, providing a vital layer of protection for the operator. Additionally, the chainsaw features a protective cover to shield the chain and bar when not in use, further enhancing its safety profile.

The Poulan 417920 also emphasizes ease of maintenance. The tool-less chain tensioning system allows for quick adjustments without the need for additional tools, saving time and effort. The accessible air filter is designed for easy cleaning, which helps maintain optimal engine performance.

In conclusion, the Poulan 417920 chainsaw embodies a blend of power, safety, and convenience. Its user-friendly features, such as the Easy Start system and tool-less adjustments, make it an ideal choice for both novice and experienced users. With its durable construction and advanced technology, the Poulan 417920 is well-equipped to handle a wide range of cutting tasks, ensuring that it remains a reliable companion for all your outdoor projects.
Top Page Image Contents