Poulan 417920 manual To Replace Headlight Bulb, Interlocks and Relays, To Replace Fuse

Page 24

SERVICE AND ADJUSTMENTS

REPLACING BATTERY (See Fig. 36)

WARNING: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected first to prevent sparking from accidental grounding.

•Lift hood to raised position.

•Disconnect BLACK battery cable (A) then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•First connect RED battery cable (B) to positive

(+) battery terminal with hex bolt and keps nut as shown. Tighten securely. Slide terminal cover (C) over terminal.

•Connect BLACK grounding cable to negative (-) battery terminal with remaining hex bolt and keps nut. Tighten securely

•Close hood.

A Negative(Black)

Cable

C

Positive B (Red) Cable

02954

FIG. 36

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder se- curely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 37)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

HOOD

HEADLIGHT

WIRE

CONNECTOR

03075

FIG. 37

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is necessary, see engine manual.

TO ADJUST CHOKE CONTROL

The choke control has been preset at the factory and adjustment should not be necessary. If adjustment is necessary, see engne manual.

TO ADJUST CARBURETOR

Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your tractor to an authorized service center for repair and/or adjustment.

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Model 417920 11.02.07 BMSafe Operation Practices for Ride-On Mowers General OperationII. Slope Operation Service General ServiceIII. Children IV. TowingTable of Contents To Remove Tractor from Carton Unpack CartonInstall Mower and Drive Belt Roll tractor forward off skidTighten securely First Install ANTI-SWAY BAR S Pivot bar towards you and insert other end of barCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor Reverse Operation System ROS on PositionHOW to USE Your Tractor StoppingTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigTo USE Cruise Control -J See Fig To Operate MowerService REMINDER/HOUR Meter Reverse Operation System ROSTo Operate on Hills To Transport See FigsBefore Starting the Engine Check Engine OIL LevelADD Gasoline To Start Engine See FigMowing Tips Lubrication Chart Before Each USEBattery TractorBrake Operation TiresEngine Cleaning Engine OIL FilterMuffler Spark PlugsTo Install Mower Tractor See FigTo Remove Mower To Level MowerPrecision SIDE-TO-SIDE Adjustment See Fig To Replace Mower Blade Drive Belt To Check BrakeTo Replace Motion Drive Belt To Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Remove Wheel for Repairs See Fig To Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbOther Fuel SystemEngine OIL CylindersTroubleshooting Points Problem Cause CorrectionMower blades will not Limited Warranty Only Ride UP and Down Hill Not Across Hill Degrees MAX Fold Along This Dotted Line Degree SlopeService Notes Service Notes Parts and Service Changere DE Pièces LES ET L’ENTRETIEN Dentretien Notes Dentretien Notes Degrés Suivant LES Pliez ESTLimitée Garantie Acheté l’avez vous qui chez autorisé concessionnaireDépannage DE Guide Correction Cause ProblèmeLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage DU Commande LA Régler Pour GAZ DES CommandeReglages ET Revision Carburateur LE Régler PourFig la Voir Tionsraparé LES Pour Roues LES Enlever Pour AvantRoue LA DE PINCEMENT/CARROSSAGE Courroie Acer Rempl Pour LA DE Lame LA DE D’ENTRAÎNEMENT’ENTRAÎNEMENT Freins LES Vérifier PourAVANT/ARRIÈRE Ajustement Tondeuse LA Installer Pour Fig la VoirTondeuse LA Niveau LE Ajuster Pour Tondeuse LA Enlever PourLigne EN Installe Dessence Filtre Entretien’ALLUMAGE Bougie Moteur DE D’HUILE FiltreAIR À Filtre ’AIR Tamis LE NettoyerLubrification Sionmistrans LA DE Moteur FluideFig la Voir Lame LA Enlever Lames DES EntretienEN Fonctionnement DE Système ET Généra Recommandations LES Lubrification DE TableauUtilisation Chaque Avant Utilisation Transmission LA Purger22 .FIG Moteur LE Démarrer Pour ’ESSENCE Réservoir LE RemplirMoteur DU D’HUILE Niveau LE Vérifier Quetima’ENTRETIEN/HOROMÈTRE Indicateur 21 et 13 .Fig les VoirMAR EN Fonctionnement DE Système Fig la Voir J- Vitess DE Régulateur LE Utiliser Comment Tondeuse LA Utiliser PourJauge DE Roues LES Régler Pour Système DU CaractéristiquesGAZ DES Commande LA Utiliser Pour Fig la Voir MentneTionsta DE Frein LE Engager Pour Reculer Pour ET Avancer Pour13 .FIG ’EMBRAYAGE Montage NI DE EST Tondeuse LA SI VérifierROULIS-ANTI Barre LA D’ABORD Installez 10 .FIGLA DE Latéraux Suspension DE Bras LES Fixez De avant l’avant vers pointent a tondeuse la de latérauxPA LA DE Tracteur LE Retirer Pour PAL LA DE Tracteur LE Retirer PourMontées NON Piéces Toncar DU Tracteur LE Sortir PourSommaire Garantie ’ENTRETIEN GuideUtilisation Réglages ET Révision Produit DE SpécificationsGénéral Entretien Tracteurs des sécurité touteEn l’utilisation pour Conseils ’ESSENCE DE Sûre ManipulationTES Tracteurs des sécurité toute en l’utilisation pour ConseilsMentsegneusoi vous-Lavez .tionducprore la de troubles AUX Imprimé BM 07.02.11Avertissement

417920 specifications

The Poulan 417920 is a powerful and efficient chainsaw designed for both casual users and professionals alike. It stands out in the market for its combination of performance, durability, and user-friendly features. Built with a robust 42cc engine, the Poulan 417920 delivers an impressive power-to-weight ratio, making it suitable for various cutting tasks, from trimming small branches to felling larger trees.

One of the standout features of the Poulan 417920 is its Easy Start system. This technology reduces the resistance in the pull cord, allowing users to start the chainsaw with minimal effort. The automatic oiling system is another key characteristic, ensuring that the chainsaw chain remains lubricated during operation. This not only enhances cutting efficiency but also prolongs the life of the chain and bar.

The 417920 features a 16-inch bar, which strikes a perfect balance between maneuverability and cutting capacity. The low-vibration design of the chainsaw helps reduce user fatigue during extended use, making it comfortable to operate for longer periods. The anti-vibration handle contributes to this comfort, allowing users to maintain better control while cutting.

Safety is a major consideration in the design of the Poulan 417920. It comes equipped with a chain brake that activates quickly in case of kickback, providing a vital layer of protection for the operator. Additionally, the chainsaw features a protective cover to shield the chain and bar when not in use, further enhancing its safety profile.

The Poulan 417920 also emphasizes ease of maintenance. The tool-less chain tensioning system allows for quick adjustments without the need for additional tools, saving time and effort. The accessible air filter is designed for easy cleaning, which helps maintain optimal engine performance.

In conclusion, the Poulan 417920 chainsaw embodies a blend of power, safety, and convenience. Its user-friendly features, such as the Easy Start system and tool-less adjustments, make it an ideal choice for both novice and experienced users. With its durable construction and advanced technology, the Poulan 417920 is well-equipped to handle a wide range of cutting tasks, ensuring that it remains a reliable companion for all your outdoor projects.
Top Page Image Contents