Crankshaft | Blade |
| |
Housing hole | adapter |
|
| Hardened |
|
| washer |
Tab |
|
|
|
| Blade |
| Debris shield | bolt |
|
| |
Trailing edge |
|
OR:
Crankshaft Tab
Housing
holeBlade adapter
| Hardened |
| washer |
Debris | Blade |
shield | bolt |
Screw Trailing edge |
Gearcase pulley | Drive |
| cover |
| Spring |
| Belt |
| keeper |
| Belt |
•Place new drive belt in engine pulley and belt retainer of debris shield.
Engine pulley
Drive belt
Belt retainer
Debris shield
MODELS WITH GEARCASE-MOUNTED BELT KEEPER AND DEBRIS SHIELD:
•Remove drive cover.
•Remove spring and belt keeper.
•Remove belt from gearcase pulley.
•Turn lawn mower on its side. See engine manual for proper direction of turning over the engine.
•Remove blade, engine pulley and debris shield.
•Remove engine pulley and belt from debris shield.
•Route the other end of the new drive belt through hole in housing.
•Reinstall debris shield.
•Return mower to upright position.
•Install new belt on gearcase pulley.
•Reinstall belt keeper and spring.
•Reinstall drive cover.
NOTE: Always use factory approved belt to assure proper fit and long life.
•Turn lawn mower on its side with air filter and carburetor down.
•Reinstall blade.
23