Poulan 193747 manual Assemble Cables to Upper Handle, Assemble Rope Guide, Sparkplugbootifequipped

ASSEMBLE CABLE(S) TO UPPER HANDLE

(USE HARDWARE GROUP “F”)

•Assemble cable(s) to opposite side of upstop bracket.

•Be sure to route cable(s) underneath crossbar of lower handle.

•Position throttle control (if equipped) on outside of handle and zone control square fitting on the inside.

•Secure to handle with the 1/4-20 ma- chine screw or hex bolt supplied and locknut (if required) as shown. Tighten securely.

•Secure cable(s) to crossbar and lower handle with cable tie(s) as needed.

MODELS WITH REMOTE THROTTLE:

Control bar	Upstop
	bracket

Throttle control

Locknut

ASSEMBLE ROPE GUIDE

(USE HARDWARE GROUP “G”)

•Put threaded end of rope guide through hole in side of upper handle above lower handle crossbar. Secure with 1/4-20 keps locknut.

•Hold control bar against upper handle and slowly pull starter rope out until rope will slip into loop of rope guide.

Locknut	Upper
	handle

Rope

guideLower

handle crossbar

Engine starter rope

SPARKPLUGBOOT(IFEQUIPPED)

(NO HARDWARE REQUIRED)

On some model lawn mowers a spark plug boot is packed loose in the parts bag. If your model has one, install it on spark plug wire and then reconnect plug to spark plug.

Machine screw

Engine zone

control cable Wire tie square fitting

MODELS W/O REMOTE THROTTLE:

Control bar	Upper
	handle

Up-stop bracket

Screw

Engine zone control cable

Wire tie

Spark plug wire

Boot

ASSEMBLE GRASS CATCHER

(REAR DISCHARGE MODELS ONLY) (NO HARDWARE REQUIRED)

•Put grass catcher frame into grass bag with rigid part on bottom.

•Slip vinyl bindings over frame. If bind- ings are too stiff, hold them in warm water for a few minutes. Allow bag to dry before using.

Frame handle

Vinyl	Frame
14 bindings	opening