Poulan 178500 owner manual To Adjust Gauge Wheels See Fig, To Operate on Hills, To Transport

Page 13

OPERATION

TO ADJUST GAUGE WHEELS (See Fig. 10)

Gauge wheels are properly adjusted when they are slightly off the ground when mower is at the desired cutting height in operating position. Gauge wheels then keep the deck in proper position to help prevent scalping in most terrain conditions.

NOTE:Adjust gauge wheels with tractor on a flat level surface.

•

Adjust mower to desired cutting height (See “TO AD-

 

JUST MOWER CUTTING HEIGHT” in the Operation

 

section of this manual).

•

Remove retainer spring and clevis pin which secure

ATTACHMENT CLUTCH SWITCH PULL OUT TO “ENGAGE”

PUSH IN TO “DISENGAGE”

LIFT LEVER

HIGHEST

POSITION

LOWEST

POSITION

DELECTOR SHIELD

each gauge wheel bar.

FIG. 11

• Lower gauge wheels to ground. Raise gauge wheels

TO OPERATE ON HILLS

slightly to align holes in bracket and gauge wheel bar and

 

 

insert clevis pin. Gauge wheels should be slightly off the

 

CAUTION: Do not drive up or down hills

ground.

 

with slopes greater than 15° and do not

• Replace retainer spring into clevis pin.

 

drive across any slope.

• Be sure all gauge wheels are in the same setting.

•

Choose the slowest speed before starting up or down

IMPORTANT: BE SURE TO READJUST GAUGE WHEELS

 

hills.

IF YOU CHANGE THE CUTTING HEIGHT OF THE MOWER

 

• Avoid stopping or changing speed on hills.

DECK.

 

• If slowing is necessary, move throttle control lever to

 

 

slower position.

 

• If stopping is absolutely necessary, push clutch/brake

RETAINER

 

pedal quickly to brake position and engage parking

SPRING

 

brake.

 

• Move gearshift lever to 1st gear and range shift lever to

 

 

low (L) position. Be sure you have allowed room for

CLEVIS

 

tractor to roll slightly as you restart movement.

• To restart movement, slowly release parking brake and

PIN

 

clutch/brake pedal.

 

 

 

• Make all turns slowly.

 

TO TRANSPORT

 

• Raise attachment lift to highest position with attachment

FIG. 10

 

lift control.

TO OPERATE MOWER (See Fig. 11)

Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine.

•Select desired height of cut.

•Lower mower with attachment lift control.

•Start mower blades by engaging attachment clutch control.

•TO STOP MOWER BLADES - disengage attachment clutch control.

CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the deflector shield in place.

•When pushing or towing your tractor, be sure gearshift lever is in neutral (N) position.

•Do not push or tow tractor at more than five (5) MPH.

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

TOWING CARTS AND OTHER ATTACH- MENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your tractor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents PRGT2046B IV. Service Safety RulesGeneral Operation II. Slope OperationSafe Operation Practices for Ride-On Mowers Safety RulesTable of Contents Contents of Hardware Pack Tools Required for Assembly AssemblyHOW to SET UP Your Tractor To Remove Tractor from CartonAssemble Gauge Wheels to Mower Deck See Fig Install Seat See FigInstall Mulcher Plate See Fig To SET UP Your Mower for Mulching See FigInstall Mower and Drive Belt See Figs To Convert to Bagging or DischargingCheck Mower Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor Height Adjustment Knob Used to adjust the mower heightHOW to USE Your Tractor To Operate on Hills To Adjust Gauge Wheels See FigTo Transport To Operate Mower See FigMowing Tips Before Starting the EngineCheck Engine OIL Level ADD GasolineProvide the best recutting action of the blades Mulching Mowing TipsCustomer Responsibilities Service DatesGeneral Recommendations Before Each USETractor Engine Clean AIR ScreenBelts Transaxle CoolingClean AIR INTAKE/COOLING Areas CleaningEngine OIL Filter MufflerTo Install Mower Service and AdjustmentsTo Level Mower Housing To Remove Mower See FigTo Replace Mower Blade Drive Belt See Fig To Replace Mower Drive BeltTo Adjust Brake See Fig To Adjust Attachment Clutch See FigBelt Installation To Replace Motion Drive Belt See FigFront Wheel TOE-IN Adjustment To Adjust Steering Wheel AlignmentFront Wheel Camber To Remove Wheel for RepairsInterlocks and Relays To Replace Headlight BulbTo Replace Fuse To Adjust Carburetor To Remove Hood and Grill Assembly See FigTo Adjust Throttle Control Cable See Fig To Adjust Choke Control See FigOther StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsWith attachment clutch Tractor - Model Number PRGT2046B SchematicElectrical 178861 KEY Part DescriptionChassis and Enclosures 177679 175282175289X428 177956117 4855 150 6156 Ground Drive150035 Nyliner 7563R Washer, Thrust, AxleSteering Assembly 137156 137347Engine 175437X428 177748175440X428 KEY Part NO. NO.DESCRIPTION Seat AssemblyWheels & Tires Decals178500 178501Lift Assembly 175560 175805175689 Mower Deck 178342 174493Transaxle Repair Parts Service Notes Service Notes Limited Warranty Slope Sighting Guide CUT This OUT Dotted Is aParts and Service

178500 specifications

The Poulan 178500 is a powerful and versatile string trimmer that caters to the needs of both professional landscapers and homeowners looking for an efficient lawn maintenance tool. Known for its robust design and user-friendly features, the Poulan 178500 stands out in the market of outdoor power equipment.

One of the main features of the Poulan 178500 is its potent 17cc, 2-cycle engine. This engine delivers a strong performance, allowing users to tackle tough grass, weeds, and overgrown areas with ease. The 2-cycle technology ensures that the trimmer is not only powerful but also lightweight, making it easier to maneuver during extended use. Users will benefit from a balanced weight distribution, which minimizes user fatigue.

Equipped with a dual-line cutting head, the Poulan 178500 ensures efficient cutting performance. The dual-line system offers a wider cutting path, enabling greater coverage with each pass. This feature is especially beneficial for larger yards or heavily landscaped areas, as it reduces the time spent on trimming tasks. Additionally, the trimmer utilizes a bump-feed line advancement system, allowing users to easily release more line with a simple tap on the ground, keeping productivity high without interruptions.

The ergonomic design of the Poulan 178500 enhances user comfort and usability. It boasts cushioned grips that reduce vibration and improve handling. Furthermore, the adjustable handle allows users to customize the position for optimal control, making trimming at various angles easier and more efficient.

Another remarkable characteristic of the Poulan 178500 is its ease of starting. The trimmer is equipped with a simplified starting mechanism, minimizing the effort required to get the engine running. This feature is particularly advantageous for those who may struggle with traditional starting methods.

For added convenience, the Poulan 178500 features a lightweight frame, making it one of the more portable options in the string trimmer market. This ease of transport and storage ensures that users can easily move from one area of their property to another without hassle.

In summary, the Poulan 178500 is a high-performance string trimmer that merges power, comfort, and user-friendly technology. Its robust engine, dual-line system, ergonomic design, and easy starting mechanism make it an excellent choice for anyone seeking a reliable and efficient lawn maintenance tool. Whether for professional landscaping or routine yard care, the Poulan 178500 is built to meet diverse trimming demands while delivering excellent results.
Top Page Image Contents