Poulan XT195H46YT manual To USE Cruise Control J See Fig, To Adjust Gauge Wheels See Fig

Page 10

OPERATION

TO USE CRUISE CONTROL (J) (See Fig. 7)

The cruise control feature can be used for forward travel only.

J

K

L

Fig. 7

SYSTEM CHARACTERISTICS

The cruise control should only be used while mowing or transporting on relatively smooth, straight surfaces. Other conditions such as trimming at slow speeds may cause the cruise control to disengage. Do not use the cruise control on slopes, rough terrian or while trimmimg or turning.

•With forward drive pedal depressed to desired speed, pull cruise control lever (J) up and hold while lifting your foot off the pedal, then release the lever.

To disengage the cruise control, depress the brake pedal or tap on forward drive pedal.

TO ADJUST GAUGE WHEELS (See Fig. 9)

Gauge wheels are properly adjusted when they are slightly off the ground when mower is at the desired cutting height in operating position. Gauge wheels then keep the deck in prop- er position to help prevent scalping in most terrain conditions.

NOTE: Adjust gauge wheels with tractor on a flat level surface.

•Adjust mower to desired cutting height (See “TO AD- JUST MOWER CUTTING HEIGHT” in this section of manual).

•With mower in desired height of cut position, gauge wheels should be assembled so they are slightly off the ground. Install gauge wheel in appropriate hole. Tighten securely.

•Repeat for all, installing gauge wheel in same adjust- ment hole.

Fig. 9

TO ADJUST MOWER CUTTING HEIGHT (See Fig. 8)

The position of the attachment lift lever (A) determines the cutting height.

A

Fig. 8

•Put attachment lift lever in desired cutting height slot.

The cutting height range is approximately 1" to 4". The heights are measured from the ground to the blade tip with the engine not running. These heights are approximate and may vary depending upon soil conditions, height of grass and types of grass being mowed.

•The average lawn should be cut to approximately 2-1/2" during the cool season and to over 3" during hot months. For healthier and better looking lawns, mow often and after moderate growth.

•For best cutting performance, grass over 6" in height should be mowed twice. Make the first cut relatively

high; the second to desired height.

10

TO OPERATE MOWER

Your tractor is equipped with an operator presence sensing switch. Any attempt by the operator to leave the seat with the engine running and the attachment clutch engaged will shut off the engine. You must remain fully and centrally positioned in the seat to prevent the engine from hesitat- ing or cutting off when operating your equipment on rough, rolling terrain or hills.

•Select desired height of cut (see "TO ADJUST MOWER CUTTING HEIGHT")

•Start mower blades by engaging attachment clutch control.

TO STOP MOWER BLADES

•Disengage attachment clutch control.

CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the deflector shield

(S) in place (See Fig. 10).

S

Fig. 10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents XT195H46YT ModelGeneral Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationIII. Children ServiceGeneral Service IV. TowingTable of Contents Unassembled Parts AssemblyTools Required for Assembly To Remove Tractor from CartonCheck for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor Stopping See Fig HOW to USE Your TractorTo SET Parking BRAKESee Fig To USE Throttle Control D See FigTo USE Cruise Control J See Fig To Adjust Gauge Wheels See FigTo Adjust Mower Cutting Height See Fig To Operate MowerTo Operate on Hills Before Starting the EngineReverse Operation System ROS Check Engine OIL LevelTo Start Engine See Fig Service REMINDER/HOUR MeterADD Gasoline Automatic Transmission Warm UPMowing Tips Purge TransmissionGeneral Recommendations MaintenanceMaintenance ScheduleBlade Care BatteryTractor Blade Removal See FigEngine Muffler CleaningAIR Filter Spark PlugsTo Install Mower See Figs Service and AdjustmentsTo Remove Mower See Fig Raise attachment lift lever to highest position To Level Mower Visual SIDE-TO-SIDE Adjustment See FigPrecision SIDE-TO-SIDE Adjustment See Fig Turn nut right Turn nut left To raise mower To lower mowerTo Check Brake Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Replace Motion Drive Belt See FigFront Wheel TOE-IN/CAMBER To Start Engine with a Weak Battery See FigWeak or Dead Fully Charged Battery To Remove Wheel for Repairs See FigTo Adjust Carburetor To Adjust Throttle Control CableTo Adjust Choke Control To Replace Headlight BulbFuel System StorageOther Engine OILTroubleshooting Points Problem Cause CorrectionEngine dies when Service Notes Stevens Creek Road Terry Fox Way Augusta, GA 30907 USA HOPL5V 3E4 Only Ride UP and Down Hill Not Across Hill Degrees MAX Fold Along This Dotted Line Degree SlopeParts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés Garantie cette de exclus sont normal l’entretien et Canada Au Pro PoulanAutorisé Initiale d’achat date la de compter à jours 90 dixDentretien Remarques Dépannage DE Guide Correction Cause ProblèmeLame de mandrin le Remplacez Tordu est lame de mandrin Un Moteur EntreposageTracteur Reglages ET Revision Starter DU Commande LA Régler PourGAZ DES Commande LA DE Câble LE Régler Pour Carburateur LE Régler Pour32 .Fig Avant Roue LA DE PINCEMENT/CARROSSAGE31 .Fig FIG LA Voir Réglages ET RévisionFig la Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl Pour Tondeuse DE Lame DE Mentnetraî27 .Fig Tondeuse LA Niveau LE Ajuster Pour28 .Fig 26 .Fig21 .Fig 24 .Fig23 .Fig 20 .FigTondeuse LA Enlever Pour Courroie LA ET Tondeuse LA InstallerFig Voir 19 .FigNettoyage EntretienFig La Voir Coupe DE Plateau DU Lavage DE Raccord Fig la VoirMoteur DE D’HUILE Filtre AIR À Filtre’AIR Tamis LE Nettoyer Sionmistrans LA DE Moteur FluidePneus Fig la Voir Lame LA EnleverLames DES Entretien Frein DU FonctionnementLubrification DE Tableau Recommandations LESGénérales Utilisation Chaque AvantTransmission LA Purger UtilisationTondre DE Conseils 12 .Fig’ESSENCE Réservoir LE Remplir ’ENTRETIEN/HOROMÈTRE IndicateurMoteur LE Démarrer Pour QuetiET Charrettes DES Remorquer Pour Accessoires AutresMoteur LE Démarrer DE Avant Désengagée TransmissionTondeuse LA Utiliser Pour Vitess DE Régulateur LE Utiliser CommentTondeuse DE Lames LES Arrêter Pour Jauge DE Roues LES Régler PourReculer Pour ET Avancer Pour GAZ DES Commande LA Utiliser PourFig la Voir Mentnetionsta DE Frein LE Engager Pour MoteurTracteur Transmission la débraye Libre Roue DE Commande MPas fonctionne ne Le avancer faire à Sert Avant Marche DE Pédale K’EMBRAYAGE Desmancom des fonction la et MontageTionsec la Voir Rouler Faisant LE EN TE LE Pour Exigés Outils LES Montées NON PiécesTracteur Votre DE Getamon Fig la SIÈGEVoir LE Régler PourClient DU Responsabilités SommaireProduit DE Spécifications Enfants EntretienRemorquage Général EntretienGénéral Fonctionnement PentesLES Dans Fonctionnement Tracteurs des sécurité toute en l’utilisation pour ConseilsAUX Imprimé Avertissement

XT195H46YT specifications

The Poulan XT195H46YT is a formidable riding lawn mower designed for homeowners who seek efficiency and power in lawn maintenance. With a combination of user-friendly features and advanced technologies, this mower makes tackling any lawn a breeze.

One of the most notable features of the XT195H46YT is its 46-inch cutting deck. This spacious deck allows for a wider cutting path, enabling users to cover more ground in less time. The deck is constructed from durable materials that ensure longevity while providing an even cut across various types of terrain. The mower offers multiple cutting height adjustments, allowing users to customize their mowing experience according to the grass conditions and personal preferences.

Powered by a robust 19.5 horsepower Briggs & Stratton engine, the XT195H46YT delivers reliable performance, ensuring that it can tackle tougher grass and uneven terrain with ease. The engine is designed for longevity and efficiency, providing ample power for both mowing and maneuvering across the yard. The automatic transmission enhances the driving experience, allowing for smooth acceleration and easy handling.

Another noteworthy characteristic of this mower is its tight turning radius, which improves maneuverability around obstacles, flower beds, and trees. This feature is particularly beneficial for homeowners with intricate landscape designs. The comfortable high-back seat enhances the riding experience, giving users adequate support during extended mowing sessions.

The Poulan XT195H46YT also comes equipped with an innovative blade engagement system. This system allows for the easy engagement and disengagement of the cutting blades, making it convenient to transition between mowing and transporting the mower. Additionally, the mower includes a fuel gauge that lets users monitor fuel levels at a glance, preventing unexpected interruptions during mowing.

Maintenance is uncomplicated with the XT195H46YT, as it features easy access points for oil changes and deck cleanings. The overall design emphasizes user comfort and efficiency, from the intuitive dashboard controls to the well-positioned foot pedals.

In summary, the Poulan XT195H46YT is a powerful riding mower that embodies a blend of technology and user-friendly design. With its impressive cutting deck, reliable engine, and advanced features, it is well-suited for homeowners looking to maintain a beautiful lawn effortlessly. The XT195H46YT is not just a mower; it is a partner in lawn care, designed to make your outdoor maintenance tasks more enjoyable and efficient.
Top Page Image Contents