Poulan XT195H46YT manual Tractor, Blade Care, Blade Removal See Fig, Battery

Page 15

MAINTENANCE

TRACTOR

Always observe safety rules when performing any maintenance.

BRAKE OPERATION

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be checked and adjusted. (See “TO CHECK BRAKE” in the Service and Adjustments section of this manual).

TIRES

•Maintain proper air pressure in all tires (See the sides of tires for proper PSI).

•Keep tires free of gasoline, oil, or insect control chemicals which can harm rubber.

•Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

OPERATOR PRESENCE SYSTEM AND REVERSE OPERATION SYSTEM (ROS) (See Fig. 13)

Be sure operator presence and reverse operation systems are working properly. If your tractor does not function as described, repair the problem immediately.

•The engine should not start unless the brake pedal is fully depressed, and the attachment clutch control is in the disengaged position.

CHECK OPERATOR PRESENCE SYSTEM

•When the engine is running, any attempt by the operator to leave the seat without first setting the parking brake should shut off the engine.

•When the engine is running and the attachment clutch is engaged, any attempt by the operator to leave the seat should shut off the engine.

•The attachment clutch should never operate unless the operator is in the seat.

CHECK REVERSE OPERATION (ROS) SYSTEM

•When the engine is running with the ignition switch in the engine "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should shut off the engine.

•When the engine is running with the ignition switch in the ROS "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should NOT shut off the engine.

 

 

 

 

 

 

 

 

 

 

02828

ROS "ON"

ENGINE "ON" POSITION

POSITION

(NORMAL OPERATING)

 

 

 

 

 

 

Fig. 13

BLADE CARE

For best results mower blades must be kept sharp. Replace bent or damaged blades.

CAUTION: Use only a replacement blade ap- proved by the manufacturer of your tractor. Using a blade not approved by the manu- facturer of your tractor is hazardous, could damage your tractor and void your warranty.

BLADE REMOVAL (See Fig. 14)

•Raisemowertohighestpositiontoallowaccesstoblades.

NOTE: Protect your hands with gloves and/or wrap blade with heavy cloth.

•Remove blade bolt by turning counterclockwise.

•Install new or resharpened blade with stamped "THIS SIDE UP" facing deck and mandrel assembly.

IMPORTANT:TOENSUREPROPERASSEMBLY,CENTERHOLE IN BLADE MUST ALIGN WITH STAR ON MANDREL ASSEMBLY.

•Install and tighten blade bolt securely (45-55 Ft. Lbs. torque).

IMPORTANT: SPECIAL BLADE BOLT HEAT TREATED.

MANDREL ASSEMBLY

 

BLADE

BLADE BOLT

STAR

(SPECIAL)

 

CENTER HOLE

Fig. 14

BATTERY

Your tractor has a battery charging system which is sufficient for normal use. However, periodic charging of the battery with an automotive charger will extend its life.

•Keep battery and terminals clean.

•Keep battery bolts tight.

•Keep small vent holes open.

•Recharge at 6-10 amperes for 1 hour.

NOTE:Theoriginalequipmentbatteryonyourtractorismain- tenance free. Do not attempt to open or remove caps or cov- ers. Adding or checking level of electrolyte is not necessary.

TO CLEAN BATTERY AND TERMINALS

Corrosion and dirt on the battery and terminals can cause the battery to “leak” power.

•Raise seat/hood.

•Disconnect BLACK battery cable first then RED bat- tery cable and remove battery from tractor.

•Rinse the battery with plain water and dry.

•Clean terminals and battery cable ends with wire brush until bright.

•Coat terminals with grease or petroleum jelly.

•Reinstall battery (See “REPLACING BATTERY" in the SERVICEANDADJUSTMENTSsectionofthismanual).

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Model XT195H46YTII. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents To Remove Tractor from Carton AssemblyTools Required for Assembly Unassembled PartsCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor To USE Throttle Control D See Fig HOW to USE Your TractorTo SET Parking BRAKESee Fig Stopping See FigTo Operate Mower To Adjust Gauge Wheels See FigTo Adjust Mower Cutting Height See Fig To USE Cruise Control J See FigCheck Engine OIL Level Before Starting the EngineReverse Operation System ROS To Operate on HillsAutomatic Transmission Warm UP Service REMINDER/HOUR MeterADD Gasoline To Start Engine See FigPurge Transmission Mowing TipsSchedule MaintenanceMaintenance General RecommendationsBlade Removal See Fig BatteryTractor Blade CareEngine Spark Plugs CleaningAIR Filter MufflerService and Adjustments To Install Mower See FigsTo Remove Mower See Fig Raise attachment lift lever to highest position Turn nut right Turn nut left To raise mower To lower mower Visual SIDE-TO-SIDE Adjustment See FigPrecision SIDE-TO-SIDE Adjustment See Fig To Level MowerTo Replace Motion Drive Belt See Fig Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Check BrakeTo Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigWeak or Dead Fully Charged Battery Front Wheel TOE-IN/CAMBERTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine dies when Service Notes HOP Stevens Creek Road Terry Fox Way Augusta, GA 30907 USAL5V 3E4 Fold Along This Dotted Line Degree Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés Initiale d’achat date la de compter à jours 90 dix Canada Au Pro PoulanAutorisé Garantie cette de exclus sont normal l’entretien etDentretien Remarques Correction Cause Problème Dépannage DE GuideLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage MoteurTracteur Carburateur LE Régler Pour Starter DU Commande LA Régler PourGAZ DES Commande LA DE Câble LE Régler Pour Reglages ET RevisionAvant Roue LA DE PINCEMENT/CARROSSAGE 32 .Fig31 .Fig Tondeuse DE Lame DE Mentnetraî Réglages ET RévisionFig la Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl Pour FIG LA Voir26 .Fig Tondeuse LA Niveau LE Ajuster Pour28 .Fig 27 .Fig20 .Fig 24 .Fig23 .Fig 21 .Fig19 .Fig Courroie LA ET Tondeuse LA InstallerFig Voir Tondeuse LA Enlever PourFig la Voir EntretienFig La Voir Coupe DE Plateau DU Lavage DE Raccord NettoyageSionmistrans LA DE Moteur Fluide AIR À Filtre’AIR Tamis LE Nettoyer Moteur DE D’HUILE FiltreFrein DU Fonctionnement Fig la Voir Lame LA EnleverLames DES Entretien PneusUtilisation Chaque Avant Recommandations LESGénérales Lubrification DE Tableau12 .Fig UtilisationTondre DE Conseils Transmission LA PurgerQueti ’ENTRETIEN/HOROMÈTRE IndicateurMoteur LE Démarrer Pour ’ESSENCE Réservoir LE RemplirDésengagée Transmission Accessoires AutresMoteur LE Démarrer DE Avant ET Charrettes DES Remorquer PourJauge DE Roues LES Régler Pour Vitess DE Régulateur LE Utiliser CommentTondeuse DE Lames LES Arrêter Pour Tondeuse LA Utiliser PourMoteur GAZ DES Commande LA Utiliser PourFig la Voir Mentnetionsta DE Frein LE Engager Pour Reculer Pour ET Avancer PourLe avancer faire à Sert Avant Marche DE Pédale K Transmission la débraye Libre Roue DE Commande MPas fonctionne ne Tracteur’EMBRAYAGE Montage Desmancom des fonction la etTionsec la Voir Rouler Faisant LE EN TE Fig la SIÈGEVoir LE Régler Pour Montées NON PiécesTracteur Votre DE Getamon LE Pour Exigés Outils LESSommaire Client DU ResponsabilitésProduit DE Spécifications Général Entretien EntretienRemorquage EnfantsTracteurs des sécurité toute en l’utilisation pour Conseils PentesLES Dans Fonctionnement Général FonctionnementAvertissement AUX Imprimé

XT195H46YT specifications

The Poulan XT195H46YT is a formidable riding lawn mower designed for homeowners who seek efficiency and power in lawn maintenance. With a combination of user-friendly features and advanced technologies, this mower makes tackling any lawn a breeze.

One of the most notable features of the XT195H46YT is its 46-inch cutting deck. This spacious deck allows for a wider cutting path, enabling users to cover more ground in less time. The deck is constructed from durable materials that ensure longevity while providing an even cut across various types of terrain. The mower offers multiple cutting height adjustments, allowing users to customize their mowing experience according to the grass conditions and personal preferences.

Powered by a robust 19.5 horsepower Briggs & Stratton engine, the XT195H46YT delivers reliable performance, ensuring that it can tackle tougher grass and uneven terrain with ease. The engine is designed for longevity and efficiency, providing ample power for both mowing and maneuvering across the yard. The automatic transmission enhances the driving experience, allowing for smooth acceleration and easy handling.

Another noteworthy characteristic of this mower is its tight turning radius, which improves maneuverability around obstacles, flower beds, and trees. This feature is particularly beneficial for homeowners with intricate landscape designs. The comfortable high-back seat enhances the riding experience, giving users adequate support during extended mowing sessions.

The Poulan XT195H46YT also comes equipped with an innovative blade engagement system. This system allows for the easy engagement and disengagement of the cutting blades, making it convenient to transition between mowing and transporting the mower. Additionally, the mower includes a fuel gauge that lets users monitor fuel levels at a glance, preventing unexpected interruptions during mowing.

Maintenance is uncomplicated with the XT195H46YT, as it features easy access points for oil changes and deck cleanings. The overall design emphasizes user comfort and efficiency, from the intuitive dashboard controls to the well-positioned foot pedals.

In summary, the Poulan XT195H46YT is a powerful riding mower that embodies a blend of technology and user-friendly design. With its impressive cutting deck, reliable engine, and advanced features, it is well-suited for homeowners looking to maintain a beautiful lawn effortlessly. The XT195H46YT is not just a mower; it is a partner in lawn care, designed to make your outdoor maintenance tasks more enjoyable and efficient.
Top Page Image Contents