Poulan XT195H46YT manual To Replace Mower Blade Drive Belt See Fig, To Check Brake, Belt Removal

Page 21

SERVICE AND ADJUSTMENTS

TO REPLACE MOWER BLADE DRIVE BELT (See Fig. 29)

The mower blade drive belt may be replaced without tools. Park the tractor on level surface. Engage parking brake.

BELT REMOVAL -

•Remove mower from tractor (See “TO REMOVE MOWER” in this section of manual).

•Work belt off both mandrel pulleys and idler pulleys.

•Pull belt away from mower.

BELT INSTALLATION -

•Work belt around both mandrel pulleys and idler pulleys.

•Make sure belt is in all pulley grooves and inside all belt guides.

•Install mower (See "TO INSTALL MOWER" in this section of manual).

MANDRELIDLER

PULLEYPULLEYS

MANDREL

PULLEY

Fig. 29

TO CHECK BRAKE

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be serviced.

You may also check brake by:

1.Park tractor on a level, dry concrete or paved surface, depress brake pedal all the way down and engage parking brake.

2.Disengage transmission by placing freewheel control in “transmission disengaged” position. Pull freewheel control out and into the slot and release so it is held in the disengaged position.

The rear wheels must lock and skid when you try to manu- ally push the tractor forward. If the rear wheels rotate, then the brake needs to be serviced. Contact a qualified service center.

TO REPLACE MOTION DRIVE BELT (See Fig. 30)

Park the tractor on level surface. Engage parking brake. For assistance, there is a belt installation guide decal on bottom side of left footrest.

BELT REMOVAL -

•Remove mower (See “TO REMOVE MOWER” section in this manual).

NOTE: Observe entire motion drive belt and position of all belt guides and keepers.

•Remove belt from stationary idler (A) and clutching idler (B).

•Remove belt from centerspan idler (C).

•Pull belt slack toward rear of tractor. Carefully remove belt upwards from transmission input pulley and over cooling fan blades (D).

•Remove belt downward from engine pulley (E).

•Slide belt toward rear of tractor, off the steering plate

(F) and remove from tractor.

BELT INSTALLATION -

•Install new belt from tractor rear to front, over the steer- ing plate (F) and above clutch brake pedal shaft (G).

•Pull belt toward front of tractor and roll belt onto engine pulley (E).

•Pull belt toward rear of tractor. Carefully work belt down around transmission cooling fan and onto the input pulley (D). Be sure belt is inside the belt keeper.

•Install belt on centerspan idler (C).

•Install belt through stationary idler (A) and clutching idler (B).

•Make sure belt is in all pulley grooves and inside all belt guides and keepers.

•Install mower (See “TO INSTALL MOWER” section in this manual).

 

E

 

F

A

 

B

G

 

C

 

D

02952

Fig. 30

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Model XT195H46YTSafe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationGeneral Service ServiceIII. Children IV. TowingTable of Contents Tools Required for Assembly AssemblyUnassembled Parts To Remove Tractor from CartonCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor To SET Parking BRAKESee Fig HOW to USE Your TractorStopping See Fig To USE Throttle Control D See FigTo Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigTo USE Cruise Control J See Fig To Operate MowerReverse Operation System ROS Before Starting the EngineTo Operate on Hills Check Engine OIL LevelADD Gasoline Service REMINDER/HOUR MeterTo Start Engine See Fig Automatic Transmission Warm UPPurge Transmission Mowing TipsMaintenance MaintenanceGeneral Recommendations ScheduleTractor BatteryBlade Care Blade Removal See FigEngine AIR Filter CleaningMuffler Spark PlugsService and Adjustments To Install Mower See FigsTo Remove Mower See Fig Raise attachment lift lever to highest position Precision SIDE-TO-SIDE Adjustment See Fig Visual SIDE-TO-SIDE Adjustment See FigTo Level Mower Turn nut right Turn nut left To raise mower To lower mowerTo Replace Mower Blade Drive Belt See Fig Belt InstallationTo Check Brake To Replace Motion Drive Belt See FigWeak or Dead Fully Charged Battery To Start Engine with a Weak Battery See FigFront Wheel TOE-IN/CAMBER To Remove Wheel for Repairs See FigTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbOther StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine dies when Service Notes HOP Stevens Creek Road Terry Fox Way Augusta, GA 30907 USAL5V 3E4 Fold Along This Dotted Line Degree Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés Autorisé Canada Au Pro PoulanGarantie cette de exclus sont normal l’entretien et Initiale d’achat date la de compter à jours 90 dixDentretien Remarques Correction Cause Problème Dépannage DE GuideLame de mandrin le Remplacez Tordu est lame de mandrin Un Entreposage MoteurTracteur GAZ DES Commande LA DE Câble LE Régler Pour Starter DU Commande LA Régler PourReglages ET Revision Carburateur LE Régler PourAvant Roue LA DE PINCEMENT/CARROSSAGE 32 .Fig31 .Fig Fig la Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl Pour Réglages ET RévisionFIG LA Voir Tondeuse DE Lame DE Mentnetraî28 .Fig Tondeuse LA Niveau LE Ajuster Pour27 .Fig 26 .Fig23 .Fig 24 .Fig21 .Fig 20 .FigFig Voir Courroie LA ET Tondeuse LA InstallerTondeuse LA Enlever Pour 19 .FigFig La Voir Coupe DE Plateau DU Lavage DE Raccord EntretienNettoyage Fig la Voir’AIR Tamis LE Nettoyer AIR À FiltreMoteur DE D’HUILE Filtre Sionmistrans LA DE Moteur FluideLames DES Entretien Fig la Voir Lame LA EnleverPneus Frein DU FonctionnementGénérales Recommandations LESLubrification DE Tableau Utilisation Chaque AvantTondre DE Conseils UtilisationTransmission LA Purger 12 .FigMoteur LE Démarrer Pour ’ENTRETIEN/HOROMÈTRE Indicateur’ESSENCE Réservoir LE Remplir QuetiMoteur LE Démarrer DE Avant Accessoires AutresET Charrettes DES Remorquer Pour Désengagée TransmissionTondeuse DE Lames LES Arrêter Pour Vitess DE Régulateur LE Utiliser CommentTondeuse LA Utiliser Pour Jauge DE Roues LES Régler PourFig la Voir Mentnetionsta DE Frein LE Engager Pour GAZ DES Commande LA Utiliser PourReculer Pour ET Avancer Pour MoteurPas fonctionne ne Transmission la débraye Libre Roue DE Commande MTracteur Le avancer faire à Sert Avant Marche DE Pédale K’EMBRAYAGE Montage Desmancom des fonction la etTionsec la Voir Rouler Faisant LE EN TE Tracteur Votre DE Getamon Montées NON PiécesLE Pour Exigés Outils LES Fig la SIÈGEVoir LE Régler PourSommaire Client DU ResponsabilitésProduit DE Spécifications Remorquage EntretienEnfants Général EntretienLES Dans Fonctionnement PentesGénéral Fonctionnement Tracteurs des sécurité toute en l’utilisation pour ConseilsAvertissement AUX Imprimé

XT195H46YT specifications

The Poulan XT195H46YT is a formidable riding lawn mower designed for homeowners who seek efficiency and power in lawn maintenance. With a combination of user-friendly features and advanced technologies, this mower makes tackling any lawn a breeze.

One of the most notable features of the XT195H46YT is its 46-inch cutting deck. This spacious deck allows for a wider cutting path, enabling users to cover more ground in less time. The deck is constructed from durable materials that ensure longevity while providing an even cut across various types of terrain. The mower offers multiple cutting height adjustments, allowing users to customize their mowing experience according to the grass conditions and personal preferences.

Powered by a robust 19.5 horsepower Briggs & Stratton engine, the XT195H46YT delivers reliable performance, ensuring that it can tackle tougher grass and uneven terrain with ease. The engine is designed for longevity and efficiency, providing ample power for both mowing and maneuvering across the yard. The automatic transmission enhances the driving experience, allowing for smooth acceleration and easy handling.

Another noteworthy characteristic of this mower is its tight turning radius, which improves maneuverability around obstacles, flower beds, and trees. This feature is particularly beneficial for homeowners with intricate landscape designs. The comfortable high-back seat enhances the riding experience, giving users adequate support during extended mowing sessions.

The Poulan XT195H46YT also comes equipped with an innovative blade engagement system. This system allows for the easy engagement and disengagement of the cutting blades, making it convenient to transition between mowing and transporting the mower. Additionally, the mower includes a fuel gauge that lets users monitor fuel levels at a glance, preventing unexpected interruptions during mowing.

Maintenance is uncomplicated with the XT195H46YT, as it features easy access points for oil changes and deck cleanings. The overall design emphasizes user comfort and efficiency, from the intuitive dashboard controls to the well-positioned foot pedals.

In summary, the Poulan XT195H46YT is a powerful riding mower that embodies a blend of technology and user-friendly design. With its impressive cutting deck, reliable engine, and advanced features, it is well-suited for homeowners looking to maintain a beautiful lawn effortlessly. The XT195H46YT is not just a mower; it is a partner in lawn care, designed to make your outdoor maintenance tasks more enjoyable and efficient.
Top Page Image Contents