Poulan XT195H46YT manual To Replace Headlight Bulb, Interlocks and Relays, To Replace Fuse

Page 23

SERVICE AND ADJUSTMENTS

REPLACING BATTERY (See Fig. 33)

WARNING: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connect- ing battery, remove metal bracelets, wristwatch bands, rings, etc. Positive terminal must be connected first to prevent sparking from acci- dental grounding.

•Lift seat pan to raised position.

•Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

•Install new battery with terminals in same position as old battery.

•First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely. Slide terminal cover over terminal.

•Connect BLACK grounding cable to negative (-) ter- minal with remaining hex bolt and keps nut. Tighten securely.

DISCARD TERMINAL

KEPS NUT

HEX BOLT

 

PROTECTIVE CAPS

 

 

 

TERMINAL

COVER

NEGATIVE

(BLACK) CABLE POSITIVE (RED)

CABLE

03037

Fig. 33

TO REPLACE HEADLIGHT BULB

•Raise hood.

•Pull bulb holder out of the hole in the backside of the grill.

•Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

•Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

•Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY (See Fig. 34)

•Raise hood.

•Unsnap headlight wire connector.

•Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.

•To replace, reverse above procedure.

HOOD

HEADLIGHT

WIRE

CONNECTOR

03075

Fig. 34

ENGINE

TO ADJUST THROTTLE CONTROL CABLE

The throttle control has been preset at the factory and adjustment should not be necessary. If adjustment is nec- essary, see engine manual.

TO ADJUST CHOKE CONTROL

The choke control has been preset at the factory and ad- justment should not be necessary. If adjustment is neces- sary, see engne manual.

TO ADJUST CARBURETOR

Your carburetor is not adjustable. If your engine does not operate properly due to suspected carburetor problems, take your tractor to an authorized service center for repair and/or adjustment.

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents Model XT195H46YTII. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents To Remove Tractor from Carton AssemblyTools Required for Assembly Unassembled PartsCheck Brake System Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsOperation Know Your Tractor To USE Throttle Control D See Fig HOW to USE Your TractorTo SET Parking BRAKESee Fig Stopping See FigTo Operate Mower To Adjust Gauge Wheels See FigTo Adjust Mower Cutting Height See Fig To USE Cruise Control J See FigCheck Engine OIL Level Before Starting the EngineReverse Operation System ROS To Operate on HillsAutomatic Transmission Warm UP Service REMINDER/HOUR MeterADD Gasoline To Start Engine See FigPurge Transmission Mowing TipsSchedule MaintenanceMaintenance General RecommendationsBlade Removal See Fig BatteryTractor Blade CareEngine Spark Plugs CleaningAIR Filter MufflerTo Remove Mower See Fig Service and AdjustmentsTo Install Mower See Figs Raise attachment lift lever to highest position Turn nut right Turn nut left To raise mower To lower mower Visual SIDE-TO-SIDE Adjustment See FigPrecision SIDE-TO-SIDE Adjustment See Fig To Level MowerTo Replace Motion Drive Belt See Fig Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Check BrakeTo Remove Wheel for Repairs See Fig To Start Engine with a Weak Battery See FigWeak or Dead Fully Charged Battery Front Wheel TOE-IN/CAMBERTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemProblem Cause Correction Troubleshooting PointsEngine dies when Service Notes L5V 3E4 HOPStevens Creek Road Terry Fox Way Augusta, GA 30907 USA Fold Along This Dotted Line Degree Slope Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service Changere DE Pièces LES ET L’ENTRETIEN Degrés Initiale d’achat date la de compter à jours 90 dix Canada Au Pro PoulanAutorisé Garantie cette de exclus sont normal l’entretien etDentretien Remarques Correction Cause Problème Dépannage DE GuideLame de mandrin le Remplacez Tordu est lame de mandrin Un Tracteur EntreposageMoteur Carburateur LE Régler Pour Starter DU Commande LA Régler PourGAZ DES Commande LA DE Câble LE Régler Pour Reglages ET Revision31 .Fig Avant Roue LA DE PINCEMENT/CARROSSAGE32 .Fig Tondeuse DE Lame DE Mentnetraî Réglages ET RévisionFig la Voir D’ENTRAÎNEMENT Courroie a L Acer Rempl Pour FIG LA Voir26 .Fig Tondeuse LA Niveau LE Ajuster Pour28 .Fig 27 .Fig20 .Fig 24 .Fig23 .Fig 21 .Fig19 .Fig Courroie LA ET Tondeuse LA InstallerFig Voir Tondeuse LA Enlever PourFig la Voir EntretienFig La Voir Coupe DE Plateau DU Lavage DE Raccord NettoyageSionmistrans LA DE Moteur Fluide AIR À Filtre’AIR Tamis LE Nettoyer Moteur DE D’HUILE FiltreFrein DU Fonctionnement Fig la Voir Lame LA EnleverLames DES Entretien PneusUtilisation Chaque Avant Recommandations LESGénérales Lubrification DE Tableau12 .Fig UtilisationTondre DE Conseils Transmission LA PurgerQueti ’ENTRETIEN/HOROMÈTRE IndicateurMoteur LE Démarrer Pour ’ESSENCE Réservoir LE RemplirDésengagée Transmission Accessoires AutresMoteur LE Démarrer DE Avant ET Charrettes DES Remorquer PourJauge DE Roues LES Régler Pour Vitess DE Régulateur LE Utiliser CommentTondeuse DE Lames LES Arrêter Pour Tondeuse LA Utiliser PourMoteur GAZ DES Commande LA Utiliser PourFig la Voir Mentnetionsta DE Frein LE Engager Pour Reculer Pour ET Avancer PourLe avancer faire à Sert Avant Marche DE Pédale K Transmission la débraye Libre Roue DE Commande MPas fonctionne ne Tracteur’EMBRAYAGE Tionsec la Voir Rouler Faisant LE EN TE MontageDesmancom des fonction la et Fig la SIÈGEVoir LE Régler Pour Montées NON PiécesTracteur Votre DE Getamon LE Pour Exigés Outils LESProduit DE Spécifications SommaireClient DU Responsabilités Général Entretien EntretienRemorquage EnfantsTracteurs des sécurité toute en l’utilisation pour Conseils PentesLES Dans Fonctionnement Général FonctionnementAvertissement AUX Imprimé

XT195H46YT specifications

The Poulan XT195H46YT is a formidable riding lawn mower designed for homeowners who seek efficiency and power in lawn maintenance. With a combination of user-friendly features and advanced technologies, this mower makes tackling any lawn a breeze.

One of the most notable features of the XT195H46YT is its 46-inch cutting deck. This spacious deck allows for a wider cutting path, enabling users to cover more ground in less time. The deck is constructed from durable materials that ensure longevity while providing an even cut across various types of terrain. The mower offers multiple cutting height adjustments, allowing users to customize their mowing experience according to the grass conditions and personal preferences.

Powered by a robust 19.5 horsepower Briggs & Stratton engine, the XT195H46YT delivers reliable performance, ensuring that it can tackle tougher grass and uneven terrain with ease. The engine is designed for longevity and efficiency, providing ample power for both mowing and maneuvering across the yard. The automatic transmission enhances the driving experience, allowing for smooth acceleration and easy handling.

Another noteworthy characteristic of this mower is its tight turning radius, which improves maneuverability around obstacles, flower beds, and trees. This feature is particularly beneficial for homeowners with intricate landscape designs. The comfortable high-back seat enhances the riding experience, giving users adequate support during extended mowing sessions.

The Poulan XT195H46YT also comes equipped with an innovative blade engagement system. This system allows for the easy engagement and disengagement of the cutting blades, making it convenient to transition between mowing and transporting the mower. Additionally, the mower includes a fuel gauge that lets users monitor fuel levels at a glance, preventing unexpected interruptions during mowing.

Maintenance is uncomplicated with the XT195H46YT, as it features easy access points for oil changes and deck cleanings. The overall design emphasizes user comfort and efficiency, from the intuitive dashboard controls to the well-positioned foot pedals.

In summary, the Poulan XT195H46YT is a powerful riding mower that embodies a blend of technology and user-friendly design. With its impressive cutting deck, reliable engine, and advanced features, it is well-suited for homeowners looking to maintain a beautiful lawn effortlessly. The XT195H46YT is not just a mower; it is a partner in lawn care, designed to make your outdoor maintenance tasks more enjoyable and efficient.
Top Page Image Contents