Poulan PXT12530 manual Before Starting the Engine

Page 12

OPERATION

TO STOP MOWER BLADES

•Disengage attachment clutch control.

CAUTION: Do not operate the mower without either the entire grass catcher, on mowers so equipped, or the deflector shield

(S) in place (See Fig. 10).

S

Fig. 11

TO OPERATE ON HILLS

CAUTION: Do not drive up or down hills with slopes greater than 15° and do not drive across any slope.

•Choose the slowest speed before starting up or down hills.

•Avoid stopping or changing speed on hills.

•If slowing is necessary, move throttle control lever to slower position.

•If stopping is absolutely necessary, push clutch/brake pedalquicklytobrakepositionandengageparkingbrake.

•Movegearshiftleverto1stgear.Besureyouhaveallowed room for tractor to roll slightly as you restart movement.

•To restart movement, slowly release parking brake and clutch/brake pedal.

•Make all turns slowly.

TO TRANSPORT

•Raise attachment lift to highest position with attachment lift control.

•When pushing or towing your tractor, be sure gearshift lever is in neutral (N) position.

•Do not push or tow tractor at more than five (5) MPH.

NOTE: To protect hood from damage when transporting your tractor on a truck or a trailer, be sure hood is closed and secured to tractor. Use an appropriate means of tying hood to tractor (rope, cord, etc.).

TOWING CARTS & OTHER ATTACHMENTS

Tow only the attachments that are recommended by and comply with specifications of the manufacturer of your trac- tor. Use common sense when towing. Too heavy of a load, while on a slope, is dangerous. Tires can lose traction with the ground and cause you to lose control of your tractor.

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

The engine in your tractor has been shipped, from the factory, already filled with summer weight oil.

•Check engine oil with tractor on level ground.

•Remove oil fill cap/dipstick and wipe clean, reinsert the dipstick and screw cap tight, wait for a few seconds, remove and read oil level. If necessary, add oil until “FULL” mark on dipstick is reached. Do not overfill.

•For cold weather operation you should change oil for easier starting (See “OIL VISCOSITY CHART” in the Maintenance section of this manual).

•To change engine oil, see the Maintenance section in this manual.

ADD GASOLINE

•Fill fuel tank to bottom of filler neck. Do not overfill. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to assure fuel freshness.

CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW 32°F (0°C), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP ENSURE GOOD COLD WEATHER STARTING.

CAUTION: Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract mois- ture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Use fresh fuel next season. See Storage Instructions for additional information. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents PXT12530 Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService General ServiceIII. Children IV. TowingTable of Contents Unassembled Parts Steering WheelAssembly Tools Required for AssemblyToremovetractorfromcarton Before Removing Tractor from SkidInstall Seat See Fig Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Attachment Clutch Switch Disengaged EngagedTo SET Parking Brake See Fig Stopping See FigTo Adjust Mower Cutting Height See Fig Using the Reverse Operation SystemTo Move Forward and Backward See Fig Reverse Operation System ROS See FigBefore Starting the Engine Mowing Tips To Start Engine See FigMaintenance MaintenanceGeneral Recommendations ScheduleTractor Blade CareBlade Removal See Fig Brake OperationBattery Transaxle MaintenanceEngine BeltsCleaning Clean AIR ScreenAIR Filter MufflerService and Adjustments To Install Mower See FigTo Remove Mower See Fig Raise attachment lift lever to highest position Visual SIDE-TO-SIDE Adjustment See Fig To Level MowerBelt Installation To Replace Mower Blade Drive Belt See FigTo Replace Motion Drive Belt See Fig To Check BrakeTransaxle Gear Shift Lever Neutral Adjustment See Fig To Adjust Steering Wheel AlignmentTo Start Engine with a Weak Battery See Fig To Remove Wheel See FigTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor Interlocks and RelaysStorage OtherFuel System Engine OILTroubleshooting Points Problem Cause CorrectionEngine continues Suggested Guide for Sighting Slopes for Safe Operation Limited Warranty

PXT12530 specifications

The Poulan PXT12530 is a robust and versatile string trimmer designed for homeowners and landscapers who value efficiency and power in their gardening tools. This model boasts an array of features and technologies that make it a standout choice for tackling both small and large yard maintenance tasks.

One of the main features of the Poulan PXT12530 is its lightweight design. Weighing in at a mere 12 pounds, this string trimmer is easy to maneuver, reducing fatigue during extended use. The trimmer also features a curved shaft, which enhances control and provides a comfortable grip, allowing users to reach tight spaces and navigate around obstacles with ease.

Powering the PXT12530 is a dependable 25cc two-cycle engine that delivers ample power for various trimming tasks. This engine ensures that users can tackle overgrown grass and weeds without straining the equipment. The trimmer is equipped with a centrifugal clutch that engages the cutting head only when the throttle is pulled, enhancing safety and improving user control.

Another notable characteristic of the Poulan PXT12530 is its dual-line cutting system. This feature allows for a wider cutting swath, effectively reducing the time needed to complete trimming tasks. The trimmer head is designed to accept .065-inch line, making reloading quick and straightforward. Additionally, it comes with a bump feed mechanism, which automatically feeds more line with a simple tap on the ground, providing convenience and efficiency while you work.

The PXT12530 also emphasizes user comfort through its anti-vibration technology. This system significantly reduces vibrations during operation, making it more comfortable for the user and helping to maintain focus during prolonged use. Coupled with its adjustable handle, the trimmer enables personalized adjustments to suit different user heights, promoting ergonomic handling.

Durability is another key aspect of the Poulan PXT12530. Constructed with high-quality materials, this trimmer is built to withstand the demands of regular use. The protective guards around the cutting head not only enhance safety but also minimize wear and tear.

In conclusion, the Poulan PXT12530 combines practicality, power, and user-friendly features, making it an excellent choice for anyone looking to maintain their yard efficiently. Its lightweight design, powerful engine, dual-line system, and comfort features all contribute to an impressive performance, setting it apart in the realm of string trimmers. Whether you're tackling routine lawn maintenance or preparing your yard for a special occasion, the PXT12530 is a reliable companion that gets the job done effectively.
Top Page Image Contents