Poulan PRK17H42STA owner manual To Start Engine with a Weak Battery See Fig, Replacing Battery See

Page 22

SERVICE AND ADJUSTMENTS

WASHERS

RETAINING

RING

AXLE COVER

SQUARE KEY (REAR WHEEL ONLY)

FIG. 26

TO START ENGINE WITH A WEAK BATTERY (See Fig. 27)

CAUTION: Lead-acid batteries generate explosive gases. Keep sparks, flame and smoking materials away from bat- teries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

Connect each end of the RED cable to the POSITIVE (+) terminal of each battery, taking care not to short against chassis.

Connect one end of the BLACK cable to the NEGATIVE (-) terminal of fully charged battery.

Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

BLACK cable first from chassis and then from the fully charged battery.

RED cable last from both batteries.

POSITIVE TERMINAL

NEGATIVE TERMINAL

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CHASSIS

CABLES

NEGATIVE

POSITIVETERMINAL

TERMINAL

CHARGED

BATTERY

FIG. 27

REPLACING BATTERY (See Fig. 28 and 29

CAUTION: Do not short battery termi- nals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands, rings, etc.

Positive terminal must be connected first to prevent sparking from accidental grounding.

Lift seat pan to raised position and open battery box door.

Disconnect BLACK battery cable first then RED battery cable and carefully remove battery from tractor.

Install new battery with terminals in same position as old battery.

First connect RED battery cable to positive (+) terminal with hex bolt and keps nut as shown. Tighten securely.

Connect BLACK grounding cable to negative (-) terminal with remaining hex bolt and keps nut. Tighten securely.

Close battery box door.

SEAT PAN

BATTERY

BOX DOOR

FIG. 28

KEPS

HEX

NUT

BOLT

POSITIVE

NEGATIVE

(RED)

CABLE

(BLACK)

 

CABLE

FIG. 29

TO REPLACE HEADLIGHT BULB

Raise hood.

Pull bulb holder out of the hole in the backside of the grill.

Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.

Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run poorly, stop running, or prevent it from starting.

Check wiring. See electrical wiring diagram in the Repair Parts section.

TO REPLACE FUSE

Replace with 20 amp automotive-type plug-in fuse. The fuse holder is located behind the dash.

22

Image 22
Contents PRK17H42STA Safety Rules Safe Operation Practices for Ride-On MowersSafety Rules Table of Contents Steering Wheel Seat Unassembled PartsSlope Sheet HOW to SET UP Your Tractor AssemblyTools Required for Assembly To Remove Tractor from CartonGet off seat without moving its adjusted position Check Deck Levelness To SET UP Your Mower for MulchingCheck Tire Pressure To Convert to Bagging or DischargingOperation Know Your Tractor To SET Parking Brake See Fig HOW to USE Your TractorTo Adjust Mower Cutting Height See Fig Stopping See Fig To USE Throttle Control See FigTo Operate on Hills To Adjust Gauge Wheels See FigTo Operate Mower See Fig To Transport See FigsADD Gasoline Before Starting the EngineCheck Engine OIL Level See Fig To Start Engine See FigMowing Tips Mulching Mowing TipsGeneral Recommendations Lubrication ChartCustomer Responsibilities Before Each USETractor Engine Muffler Clean AIR INTAKE/COOLING AreasCleaning Spark PlugsTo Level Mower Housing Service and AdjustmentsTo Install Mower See Fig To Remove Mower See FigTo Replace Mower Blade Drive Belt See Fig To Adjust Brake See FigBelt Installation Belt RemovalTo Adjust Steering Wheel Alignment Transmission REMOVAL/REPLACEMENTFront Wheel TOE-IN/CAMBER To Replace Headlight Bulb To Start Engine with a Weak Battery See FigReplacing Battery See Interlocks and RelaysTo Adjust Carburetor See Fig To Remove Hood and Grill Assembly See FigTo Adjust Throttle Control Cable See Fig Acceleration TestFuel System StorageOther Engine OILTroubleshooting Points OFF Schematic Tractor - Model Number PRK17H42STAElectrical KEY Part Description Chassis Screw Hex Wshd 8-18 x 7/8 Drive Transaxle Hydro Gear Steering Assembly KEY Part NO. NO.DESCRIPTION Seat Assembly Decals Wheels and TiresEngine 170805 Control Th/ch Flag Mower Deck Tractor - Model Number PRK17H42STA Mower Lift 159460 Wire Asm Inner/Sprg W/plunger LT Service Notes Service Notes Limited Warranty Suggested Guide for Sighting Slopes for Safe Operation Sighting GuideParts and Service

PRK17H42STA specifications

The Poulan PRK17H42STA is a robust riding lawn mower designed for residential mowing tasks, blending efficiency with a user-friendly experience. This mower is powered by a reliable 17 HP Briggs & Stratton engine, known for its durability and performance. The engine provides ample power to tackle various grass and terrain types, making it ideal for medium to large yards.

One of the standout features of the PRK17H42STA is its 42-inch cutting deck. This deck size strikes an excellent balance between maneuverability and coverage, allowing users to navigate around obstacles with ease while still covering a substantial area in a single pass. The cutting height can be easily adjusted to ensure that your lawn is maintained to the desired length, accommodating different grass types and seasonal growth patterns.

The Poulan PRK17H42STA incorporates a manual drive system with a foot-operated hydrostatic transmission. This feature allows for smooth speed adjustments without the need for clutching or shifting gears, making it easier for users to focus on mowing without distractions. The comfortable high-back seat adds to the overall riding experience, providing support during longer mowing sessions.

In terms of design, the mower has a durable construction built to withstand regular use. Its solid frame and robust components contribute to longevity, ensuring that it can handle the rigors of residential mowing. The machine is equipped with easy-access maintenance points, making it simple to perform routine checks and service.

Another significant feature of the PRK17H42STA is its capability to attach various accessories, including mulching kits and baggers. This versatility allows homeowners to customize their mowing experience and manage grass clippings effectively. The incorporation of safety features such as a blade brake that stops the blades when the driver leaves the seat enhances user safety.

Overall, the Poulan PRK17H42STA is an excellent choice for homeowners seeking a reliable and efficient riding mower. With its powerful engine, adjustable cutting deck, and comfortable riding experience, it is a valuable asset for proper lawn maintenance. Whether you have a small or moderately-sized lawn, this mower is designed to meet your needs, making it a commendable addition to any outdoor maintenance arsenal.