Poulan Pro 900 ZX manual Cutting height pedal, Accessories

Page 25

CONTROLS

12. Cutting height pedal

The deck cutting height is obtained by pressing the foot pedal forward to lift the deck. To lower the deck, you apply pressure to the top side of the foot pedal and allow it to pivot while allowing the lift arm to rotate to the rear of the unit. To stop in a desired cutting position, rotate the foot pedal down into the notch in the height plate. The cutting height range is from 1 1/2" (38 mm) to 5" (127 mm) in 1/2" (13 mm) increments. The heights are measured from the ground up to the blade tip with the engine not running

.

IMPORTANT INFORMATION

In order to obtain an even cutting height it is important that the air pressure in all four tires is the same 15 psi (1 bar).

Accessories

For mulching, there is a BioClip attachment available. This is mounted underneath the mower deck and consists of discharge cover and blades.

4

1/2

4

3

1/2

3

2

1/2

2

1

1/2

8011-753

Cutting height pedal

English-23

Image 25
Contents Pro 900 ZX Page OPERATOR’S Manual Rider Series ContentsEnglish-2 Introduction IntroductionManufacturing Number Good ServiceSymbols and Decals Symbols and DecalsXxxx xxxxxx Objects Engine is Running Moving sharp blades under cover Safety Instructions Safety InstructionsGeneral Operation English-8 Slope Operation Personal Safety EquipmentChildren Maintenance General Maintenance Risk of sparking Important Information TransportCustomer responsibilities Controls ControlsControl Locations Tracking Motion Control LeversFuses Seat adjustment knobsBy pass linkages Refueling Blade switchChoke Control Ignition SwitchThrottle Control Parking Brake Hour MeterMachine must be stopped before activating the parking brake Cutting height pedal AccessoriesOperation OperationTraining Starting the Engine Before StartingDepress the control for disengaging the mower deck Press in and turn the ignition key to the start position To remove cables, reverse order To start an engine with a weak batteryRunning Operating on hills Mowing Tips Stopping the Engine Moving by Hand Maintenance MaintenanceMaintenance Schedule = Described in this manual  = Not described in this manual To clean battery and terminals BatteryReplacing battery Always use protective glasses when handling the batteryIgnition System Checking the Safety System Checking and Adjusting the Choke Cable Checking and Adjusting the Throttle CableChecking the Engines Cooling Air Intake Briggs and Stratton engine Replacing the Air FilterReplacing the Fuel Filter Faulty adjustment can cause an accidentChecking Tire Pressures Checking the Parking BrakeDeck belt Checking the V-beltsDeck belt installation To replace EZT E-Series Zeroturn Transaxle belt EZT beltEZT belt removal Check the blades Checking the BladesAdjusting the Mower Deck To level deck Side-to-side adjustmentFront-to-back adjustment To adjust anti-scalp rollers Use protective glasses when cleaning and washing Cleaning and WashingCaster Wheels HardwareLubrication LubricationLubrication Schedule Lubricating in Accordance with the Lubrication Schedule Lubricating the CablesCaster wheels Engine Oil Briggs & Stratton Changing the Engine OilOil drain valve Changing the Oil Filter Checking the oil levelTransmission Trouble Shooting Guide Trouble Shooting GuideProblem Cause Wrong fuel type English-58 Storage ServiceStorage Winter StorageWiring diagram Wiring DiagramsTechnical Data Technical DataZ4822 Equipment Torque Specifications Conformity Certificates Conformity CertificatesUSA requirements Service Journal Service JournalDelivery Service Action Date, mtr reading, stamp, signAfter the First 5-8 Hours Hour Service English-68 English-69 English-70 At Least Once Each Year English-72 English-73 110192Rir12/19/05