Poulan Pro 900 ZX manual Checking the oil level, Changing the Oil Filter

Page 56

LUBRICATION

Checking the oil level

Check the oil level in the engine when the machine is standing level and the engine is stopped.

Remove the dipstick, wipe it clean, and then replace it.

The dipstick should be screwed into place.

Take the dipstick out again and read the oil level.

The oil level shall lie between the markings on the dipstick. If the level is approaching the ”ADD” mark, fill the oil to the ”FULL” mark on the dipstick.

Never fill above the ”FULL” mark.

The oil is filled through the hole for the dipstick.

API class SF, SG, SH, SJ or higher must be used

Synthetic oil SAE 5W-30 or 10W30 is recommended at all temperatures.

Mineral oil SAE 5W-30, 10W30 can be used between 0 °F/-18 °C and 40 °F/+5 °C. At temperature above 40 °F/+5 °C single grade SAE 30 must be used.

The engine holds 1.5 quarts (1.4 liters) of oil excluding the filter; including the filter 1.6 quarts (1.5 liters).

2. Changing the Oil Filter

1.Drain the engine oil following the procedure described in Engine Oil/ Change Engine Oil section.

2.Remove the oil filter. If necessary, use a filter remover.

3.Wipe new, clean engine oil on the seal of the new filter.

4.Mount the filter by hand with + 3/4 turn.

5.Run the engine warm, then check that there are no leaks around the oil filter seal.

8011-500

Remove the dipstick

8009-159

The dipstick markings

8011-707

Changing the oil filter Briggs & Stratton

English-54

Image 56
Contents Pro 900 ZX Page Contents OPERATOR’S Manual Rider SeriesEnglish-2 Introduction IntroductionGood Service Manufacturing NumberXxxx xxxxxx Symbols and DecalsSymbols and Decals Objects Engine is Running Moving sharp blades under cover General Operation Safety InstructionsSafety Instructions English-8 Personal Safety Equipment Slope OperationChildren Maintenance General Maintenance Risk of sparking Transport Important InformationCustomer responsibilities Control Locations ControlsControls Motion Control Levers TrackingSeat adjustment knobs FusesBy pass linkages Blade switch RefuelingThrottle Control Ignition SwitchChoke Control Machine must be stopped before activating the parking brake Hour MeterParking Brake Accessories Cutting height pedalTraining OperationOperation Before Starting Starting the EngineDepress the control for disengaging the mower deck Press in and turn the ignition key to the start position To start an engine with a weak battery To remove cables, reverse orderRunning Operating on hills Mowing Tips Stopping the Engine Moving by Hand Maintenance Schedule MaintenanceMaintenance = Described in this manual  = Not described in this manual Battery To clean battery and terminalsReplacing battery Always use protective glasses when handling the batteryIgnition System Checking the Safety System Checking the Engines Cooling Air Intake Checking and Adjusting the Throttle CableChecking and Adjusting the Choke Cable Replacing the Air Filter Briggs and Stratton engineFaulty adjustment can cause an accident Replacing the Fuel FilterChecking Tire Pressures Checking the Parking BrakeChecking the V-belts Deck beltDeck belt installation EZT belt removal EZT beltTo replace EZT E-Series Zeroturn Transaxle belt Checking the Blades Check the bladesAdjusting the Mower Deck Side-to-side adjustment To level deckFront-to-back adjustment To adjust anti-scalp rollers Cleaning and Washing Use protective glasses when cleaning and washingCaster Wheels HardwareLubrication Schedule LubricationLubrication Lubricating the Cables Lubricating in Accordance with the Lubrication ScheduleCaster wheels Engine Oil Briggs & Stratton Changing the Engine OilOil drain valve Checking the oil level Changing the Oil FilterTransmission Problem Cause Trouble Shooting GuideTrouble Shooting Guide Wrong fuel type English-58 Service StorageStorage Winter StorageWiring Diagrams Wiring diagramZ4822 Technical DataTechnical Data Equipment Torque Specifications USA requirements Conformity CertificatesConformity Certificates Service Journal Service JournalDelivery Service Action Date, mtr reading, stamp, signAfter the First 5-8 Hours Hour Service English-68 English-69 English-70 At Least Once Each Year English-72 English-73 110192Rir12/19/05