Poulan PR1842STC owner manual Other, Fuel System, Engine OIL, Cylinders

Page 24

STORAGE

Immediately prepare your tractor for storage at the end of the season or if the tractor will not be used for 30 days or more.

CAUTION: Never store the tractor with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TRACTOR

Remove mower from tractor for winter storage. When mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

•Clean entire tractor (See “CLEANING” in the Customer Responsibilities section of this manual).

•Inspect and replace belts, if necessary (See belt re- placement instructions in the Service and Adjustments section of this manual).

•Lubricate as shown in the Customer Responsibilities section of this manual.

•Be sure that all nuts, bolts and screws are securely fastened. Inspect moving parts for damage, breakage and wear. Replace if necessary.

•Touch up all rusted or chipped paint surfaces; sand lightly before painting.

BATTERY

•Fully charge the battery for storage.

•After a period of time in storage, battery may require recharging.

•To help prevent corrosion and power leakage during long periods of storage, battery cables should be discon- nected and battery cleaned thoroughly (see “TO CLEAN BATTERY AND TERMINALS” in the Customer Respon- sibilities section of this manual).

•After cleaning, leave cables disconnected and place cables where they cannot come in contact with battery terminals.

•If battery is removed from tractor for storage, do not store battery directly on concrete or damp surfaces.

ENGINE

FUEL SYSTEM

IMPORTANT: IT IS IMPORTANT TO PREVENT GUM DEPOSITS FROM FORMING IN ESSENTIAL FUEL SYSTEM PARTS SUCH AS CARBURETOR, FUEL FILTER, FUEL

H O S E , O R T A N K D U R I N G S T O R A G E . A L S O , EXPERIENCE INDICATES THAT ALCOHOL BLENDED FUELS (CALLED GASOHOL OR USING ETHANOL OR METHANOL) CAN ATTRACT MOISTURE WHICH LEADS TO SEPARATION AND FORMATION OF ACIDS DURING STORAGE. ACIDIC GAS CAN DAMAGE THE FUEL SYSTEM OF AN ENGINE WHILE IN STORAGE.

•Drain the fuel tank.

•Start the engine and let it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during stor- age. Add stabilizer to gasoline in fuel tank or storage container. Always follow the mix ratio found on stabilizer container. Run engine at least 10 minutes after adding stabilizer to allow the stabilizer to reach the carburetor. Do not drain the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See “ENGINE” in the Customer Responsibilities section of this manual).

CYLINDER(S)

•Remove spark plug(s).

•Pour one ounce of oil through spark plug hole(s) into cylinder(s).

•Turn ignition key to “START” position for a few seconds to distribute oil.

•Replace with new spark plug(s).

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your tractor indoors and cover it to give protection from dust and dirt.

•Cover your tractor with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot breathe which allows condensation to form and will cause your tractor to rust.

IMPORTANT: NEVER COVER TRACTOR WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.

24

Page 23 Page 25
Image 24
Page 23 Page 25
Contents PR1842STC IV. Service Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationSafety Rules Table of Contents Contents of Hardware Pack Tools Required for Assembly HOW to SET UP Your TractorTo Remove Tractor from Carton Before Removing Tractor from SkidInstall Seat See Fig To SET UP Your Mower for Mulching To Convert to Bagging or DISCHARG- INGCheck Tire Pressure Check Deck LevelnessOperation Know Your Tractor HOW to USE Your Tractor To Adjust Gauge Wheels See Fig To Operate Mower See FigTo Operate on Hills To TransportBefore Starting the Engine ADD GasolineCheck Engine OIL Level To Start Engine See FigMowing Tips Mulching Mowing TipsLubrication Chart General RecommendationsBefore Each USE Tractor Engine Cleaning MufflerSpark Plugs Engine OIL FilterTo Install Mower See Fig To Remove Mower See FigTo Level Mower Housing To Replace Mower Blade Drive Belt See FigTo Adjust Brake See Fig Transaxle Gear Shift Lever Neutral Adjustment See FigTo Replace Motion Drive Belt See Fig To Adjust Steering Wheel Alignment To Start Engine with a Weak Battery See FigReplacing Battery See Figs Front Wheel TOE-IN/CAMBERTo Adjust Throttle Control Cable To Adjust CarburetorTo Replace Headlight Bulb Interlocks and RelaysOther Fuel SystemEngine OIL CylindersTroubleshooting Points OFF Schematic Tractor - Model Number PR1842STCElectrical KEY Part Description Chassis and Enclosures Screw Hex Wshd 8-18 x 7/8 Drive Repair Parts Steering Assembly 180656 Wheel Steering Seat Assembly KEY Part NO. NO. DescriptionDecals Wheels and TiresEngine 170551 Control Th/ch Flag Mower Deck Repair Parts Mower Lift 159460 Wire Asm Inner/Sprg W/plunger LT Page Limited Warranty Policy Fold Along This Dotted Line Degree Only Ride UP and Down Hill Not Across Hill Degrees MAXParts and Service

PR1842STC specifications

The Poulan PR1842STC is a powerful and versatile riding lawn mower designed for homeowners seeking efficiency and reliability in lawn care. With its robust engineering and user-friendly features, the PR1842STC stands out among its competitors, making it an ideal choice for maintaining larger yards with ease.

One of the keynote features of the PR1842STC is its 18.5 horsepower Briggs & Stratton engine. Known for its durability and easy starting capabilities, this engine provides ample power to handle tough mowing tasks, ensuring a clean cut even in challenging conditions. The mower’s automatic transmission allows for smooth operation, enabling users to easily adjust their speed without the hassle of shifting gears manually.

The PR1842STC boasts a 42-inch cutting deck, which strikes a perfect balance between maneuverability and cutting width. This size is particularly advantageous for homeowners with medium to large lawns, as it allows for efficient mowing while still being able to navigate through tighter spots. The cutting deck features three adjustable positions, giving users the flexibility to choose their desired grass height from 1 to 4 inches.

Equipped with a front bumper and reinforced deck, the PR1842STC is built to withstand the rigors of regular lawn maintenance. The mower also incorporates a comfortable high-back seat, providing additional support for those longer mowing sessions, and an ergonomic steering wheel designed for ease of handling. An essential feature is the cutting height adjustment lever located conveniently near the operator's seat, allowing for quick changes on the fly.

One of the most notable technologies integrated into the PR1842STC is its easy-starting system, designed to ensure reliability on the first pull. Furthermore, the mower features a reliable mulching system, allowing users to finely chop grass clippings to enhance lawn health and minimize waste.

Safety is a priority for Poulan, and the PR1842STC includes several safety features. These include an automatic shut-off system that engages when the operator leaves the seat, ensuring that the mower stops safely to prevent accidents.

Overall, the Poulan PR1842STC is a well-rounded riding lawn mower that combines power, user-friendly design, and advanced features, making it an excellent investment for those serious about lawn maintenance. Whether tackling tall grass or navigating tricky terrain, the PR1842STC delivers robust performance for a beautifully manicured lawn.
Top Page Image Contents