5 LOWER CHUTE (See Fig. 5)
1.Raise and hold deflector shield in upright position.
2.Place slot in lower chute over tab on mower and position lower chute over mower opening as shown.
3.Hook rear latch into flange hole on back of mower.
4.Hook front latch into tab hole on front of mower.
CAUTION: Do not remove deflector shield from mower. Raise and hold shield when attaching lower chute and allow it to rest on chute while in operation.
DEFLECTOR
SHIELD
OPTIONAL FRONT
GAUGE WHEEL
TAB
6 UPPER CHUTE (See Figs. 6A & 6B)
1.Lower mower to its lowest cutting position.
2.Assemble upper chute by inserting curved end into hole in back of cover.
NOTE: Handle carefully so as not to damage full bagger indicator.
3.Push in and turn upper chute until it is in line with lower chute.
4.Align the bosses on lower chute with alignment slots on upper chute and slide together.
5.Secure with rubber latch by hooking hole in latch over latch pin.
|
| FULL BAGGER |
|
COVER | UPPER | INDICATOR | HANDLE |
CHUTE |
| ||
|
|
|
LOWER
CHUTE
03029
02552
FRONT
LATCH
REAR LATCH
FIG. 5
FIG. 6A
ALIGNMENT
SLOT
LATCH PIN
03023 | RUBBER |
| LATCH |
BOSSES
FIG. 6B
7 LEVEL MOWER
•Be sure mower is properly leveled for best mower performance. See your tractors owner's manual for
instructions
7