start the saw and carefully reenter the cut. To avoid kickback and chain damage, do not use a metal wedge. Do not attempt to restart your saw when it is pinched or hung in a log.
Use a wedge to remove pinched saw
Turn saw OFF and use a plastic or wooden wedge to force cut open.
Overcutting begins on the top side of the log with the bottom of the saw against the log. When overcutting use light downward pres- sure.
Overcutting
Undercutting
Undercutting involves cutting on the under- side of the log with top of saw against the log. When undercutting use light upward pres- sure. Hold saw firmly and maintain control. The saw will tend to push back toward you.
WARNING: Never turn saw upside down to undercut. The saw cannot be con- trolled in this position.
Always make your first cut on the compres- sion side of the log. The compression side of the log is where the pressure of the log’s weight is concentrated.
First cut on compression side of log
Using a log for support 2nd Cut
1st Cut
1st Cut
2nd Cut
Using a support stand 2nd Cut
1st Cut
1st Cut
2nd Cut
Second cut
Second cut
First cut on compression side of log
BUCKING WITHOUT A SUPPORT
SOvercut through 1/3 of the diameter of the
log.
SRoll the log over and finish with a second overcut.
SWatch for logs with a compression side to prevent the saw from pinching. See il- lustrations for cutting logs with a compres- sion side.
BUCKING USING A LOG OR SUPPORT STAND
SRemember your first cut is always on the compression side of the log.
(Refer to the illustrations below for your first and second cut)
S Your first cut should extend 1/3 of the diameter of the log.
SFinish with your second cut.
LIMBING AND PRUNING
WARNING: Be alert for and guard against kickback. Do not allow the moving chain to contact any other branches or objects at the nose of the guide bar when limbing or pruning. Allowing such contact can result in serious injury.
WARNING: Never climb into a tree to limb or prune. Do not stand on ladders, plat- forms, a log, or in any position which can cause you to lose your balance or control of the saw.
IMPORTANT POINTS
S Work slowly, keeping both hands firmly gripped on the saw. Maintain secure footing and balance.
SWatch out for springpoles. Springpoles are small size limbs which can catch the saw chain and whip toward you or pull you off bal-
ance. Use extreme caution when cutting small size limbs or slender material.
S Be alert for springback. Watch out for branches that are bent or under pressure. Avoid being struck by the branch or the saw when the tension in the wood fibers is released.
S Keep a clear work area. Frequently clear branches out of the way to avoid tripping over them.
13