Icom IC-450, IC-460 Transmitting a call, Using call memory, Calling back from the queue channel

4 BIIS OPERATION

■Transmitting a call

Total of a 3 ways for code selection are available—selecting the call code from memory, entering the call code from the keypad and call- ing back from the queue channel record.

DUsing call memory

qWhile in the standby condition, push [P1] (Digital) to enter the call code memory channel selection mode.

Call code text is displayed.

wPush []/[] to select the desired call code. e Push [P0] (Call) or [PTT]* to call.

*PTT call can be made only when PTT call capability is permitted.

NOTE: When no answer back is received, the transceiver re-

peats the call 3 times (default) automatically, and “ ” is displayed during each call. However, an error beep sounds

and “ ” is displayed when no answer back is received after the calls.

rPush [PTT] to transmit; release to receive.

tPush [P3] (Moni(Audi)) to send the “Clear down” signal.

BIIS OPERATION 4

DCalling back from the queue channel

qWhile in the standby condition, push [P1] (Digital) for 1 sec. to enter queue memory channel selection mode.

w Push [ ]/[ ] to select the desired record. 4

ePush [P0] (Call) or [PTT]* to call.

*PTT call can be made only when PTT call capability is permitted.

NOTE: When no answer back is received, the transceiver re-

peats the call 3 times (default) automatically, and “ ” is displayed during each call. However, an error beep sounds

and “ ” is displayed when no answer back is received after the calls.

rPush [PTT] to transmit; release to receive.

tPush [P3] (Moni(Audi)) to send the “Clear down” signal.

23 24