Poulan 530165412, 2004-07 Cutting a Fallen Tree, Types of Cutting Used for Bucking

Page 12

SDO NOT cut down a partially fallen tree with your saw. Be extremely cautious with partially fallen trees that may be poorly supported. When a tree doesn’t fall com- pletely, set the saw aside and pull down the tree with a cable winch, block and tackle, or tractor.

CUTTING A FALLEN TREE

(BUCKING)

Bucking is the term used for cutting a fallen tree to the desired log size.

WARNING: Do not stand on the log being cut. Any portion can roll causing loss of footing and control. Do not stand downhill of the log being cut.

IMPORTANT POINTS

SCut only one log at a time.

SCut shattered wood very carefully; sharp pieces of wood could be flung toward oper-

ator.

SUse a sawhorse to cut small logs. Never allow another person to hold the log while

cutting and never hold the log with your leg or foot.

SDo not cut in an area where logs, limbs, and roots are tangled such as in a blown down area. Drag the logs into a clear area before cutting by pulling out exposed and cleared logs first.

TYPES OF CUTTING USED FOR BUCKING

WARNING: If saw becomes pinched or hung in a log, don’t try to force it out. You can lose control of the saw resulting in injury and/or damage to the saw. Stop the saw, drive a wedge of plastic or wood into the cut until the saw can be removed easily. Re- start the saw and carefully reenter the cut. To avoid kickback and chain damage, do not use a metal wedge. Do not attempt to restart your saw when it is pinched or hung in a log.

Use a wedge to remove pinched saw

Turn saw OFF and use a plastic or wooden wedge to force cut open.

Overcutting begins on the top side of the log with the bottom of the saw against the log. When overcutting use light downward pres- sure.

Overcutting Undercutting

Undercutting involves cutting on the under- side of the log with top of saw against the log. When undercutting use light upward pres- sure. Hold saw firmly and maintain control. The saw will tend to push back toward you.

WARNING: Never turn saw upside down to undercut. The saw cannot be con- trolled in this position.

Always make your first cut on the compres- sion side of the log. The compression side of the log is where the pressure of the log’s weight is concentrated.

First cut on compression side of log

Second cut

Second cut

First cut on compression side of log

BUCKING WITHOUT A

SUPPORT

SOvercut through 1/3 of the diameter of the log.

SRoll the log over and finish with a second

overcut.

SWatch for logs with a compression side to prevent the saw from pinching. See il- lustrations for cutting logs with a compres- sion side.

BUCKING USING A LOG OR

SUPPORT STAND

SRemember your first cut is always on the compression side of the log.

(Refer to the illustrations below for your

first and second cut)

S Your first cut should extend 1/3 of the diameter of the log.

SFinish with your second cut.

Using a log for support

2nd Cut

1st Cut

1st Cut

2nd Cut

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Manual de Instrucciones Manuel d’Instructions English Español FrançaisIdentification of Symbols Safety RulesPlan Ahead Operate Your SAW Safely Maintain Your SAW in Good Working OrderHandle Fuel with Caution KickbackKickback Safety Features Reduce the Chance of KickbackMaintain Control Avoid Obstructions Clear The Working AreaChain Brake and CKA Angle Computed kickback angle CKA TableLength 952044418 18″Assembly Inside view Chain Brake Adjustment located on Chain BrakeAttaching the BAR & Chain If not Already attachedAdjusting the tension Chain Tension Including units with chain already installedChecking the tension CuttersON/STOP Switch Know Your SAWThrottle Trigger Throttle LockoutStarting Fueling EngineBAR and Chain Lubrication Important Points to RememberCutting Methods Starting a Warm EngineImportant Points Tree Felling Techniques Felling Large TreesNotch CUT and Felling the Tree Bucking Using a LOG or Support Stand Cutting a Fallen TreeTypes of Cutting Used for Bucking Bucking Without a SupportService PruningLimbing and Pruning Important Points LimbingCleaning the air filter Carburetor AdjustmentBAR Maintenance Inspect Muffler and Spark Arresting ScreenNeed ASSISTANCE? Limited Warranty Load Adjustment EngineEmpty fuel tank and refill with Ligations The U. S. Environmental Electrolux Home PRODUCTS, INCIntermediate 125 hours Extended 300 hours

2004-07, 530165412 specifications

The Poulan 2004-07,530165412 is a notable model in the Poulan range, which is well-regarded for its reliability and performance in lawn care and outdoor maintenance. Designed primarily for homeowners and light commercial use, this trimmer has garnered attention for its robust features and innovative technologies that enhance both efficiency and user experience.

One of the main features of the Poulan 2004-07,530165412 is its powerful engine. The unit typically boasts a two-stroke engine, which provides sufficient power and torque to tackle various yard maintenance tasks, including trimming grass, weeds, and light brush. The engine's lightweight design makes it easy to maneuver, reducing fatigue during extended use.

Equipped with a straight shaft design, the Poulan trimmer allows users to access difficult-to-reach areas such as under shrubs and fences. The design also helps improve performance and reduces the risk of clogging, enabling a cleaner cut. This model often features a dual-line cutting system that spins at high speed, providing a wider cutting path for faster trimming. The bump feed head allows users to easily advance the cutting line with a simple tap on the ground, ensuring uninterrupted operation.

In terms of ergonomics, the Poulan 2004-07,530165412 incorporates adjustable handles to cater to users of various heights. The padded grips enhance comfort during prolonged use, while the lightweight body reduces strain on the arms and back.

Technologically, this model may include anti-vibration features that minimize feedback to the user, helping to decrease operator fatigue and increase trimming efficiency. The fuel efficiency of the engine is another highlight, allowing users to spend more time working and less time refueling.

Maintenance is straightforward, which is essential for homeowners and semi-professionals alike. The easy-start system simplifies starting, and the accessible air filter and spark plug contribute to a user-friendly maintenance routine.

Overall, the Poulan 2004-07,530165412 is a well-rounded trimmer, blending power, versatility, and user comfort. Its enhancements serve to elevate the user experience, making yard work less of a chore and more efficient. Whether you are tackling a residential lawn or light landscaping projects, this model stands out in the crowded market of outdoor power tools.
Top Page Image Contents