Poulan 530163809 Starting a Cold Engine, Starting a Warm Engine, Starting a Flooded Engine

Page 7

STARTING POSITION

Blower

Vacuum

WARNING: When starting engine, hold the unit as illustrated. Do not set unit on any surface except a clean, hard area when starting engine or while engine is running. Debris such as gravel, sand, dust, grass, etc. could be picked up by the air intake and thrown out through the discharge opening, damaging the unit or property, or causing serious injury to by- standers or the operator.

STARTING A COLD ENGINE

1.Move throttle lever to the position.

2.Move choke lever to the FULL CHOKE position.

3.Slowly press the primer button 8 times.

Throttle Lever Primer Button

Choke Lever

4.Pull starter rope sharply until engine at- tempts to run, but no more than 5 pulls (be- low 30_ F, 8 pulls).

NOTE: If engine attempts to start before the 5th pull, go to next step immediately.

5.Move the choke lever to the HALF CHOKE position.

6.Pull the starter rope sharply until the en- gine runs, but no more than 5 pulls (below 30_ F, 10 pulls).

7.After a 5--second warm--up, move the choke lever to the RUN position.

8.Allow the unit to run for 30 more seconds at the RUN position before moving the

throttle lever to the position.

If engine has not started after 5 pulls (at HALF CHOKE), repeat STARTING A COLD ENGINE procedure. If engine still does not start, proceed to STARTING A FLOODED ENGINE.

9.To stop the engine, move the throttle lever to the STOP position.

STARTING A WARM ENGINE

NOTE: If fuel tank is empty, add fuel; then, follow STARTING A COLD ENGINE proce- dure. Do not fill fuel tank while engine is hot.

1.Move throttle lever to the position.

2.Pull starter rope sharply until engine runs, but no more than 5 pulls.

NOTE: If engine has not started, pull starter rope 5 more pulls. If engine still does not run, it is probably flooded.

3.To stop the engine, move the throttle lever to the STOP position.

STARTING A FLOODED ENGINE

Flooded engines can be started by placing the choke lever in the RUN position. Move throttle

lever to the fast position ; then, pull rope until engine starts. After engine starts, move the

throttle lever to the slow position to allow engine to idle.

Starting could require pulling the starter rope many times depending on how badly the unit is flooded.

If unit still doesn’t start refer to the TROUBLE- SHOOTING TABLE or call 1-800-554-6723.

WARNING: Avoid touching muffler unless engine and muffler are cold. A hot muffler can cause serious burns.

WARNING: Stop engine and be sure the impeller blades have stopped turning be- fore opening the vacuum inlet door or at- tempting to insert or remove the vacuum or blower tubes. The rotating blades can cause serious injury. Always disconnect the spark plug before performing maintenance or ac- cessing movable parts.

GENERAL RECOMMENDATIONS

The warranty on this unit does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, the operator must maintain unit as

instructed in this manual. Various adjust- ments will need to be made periodically to properly maintain your unit.

CHECK FOR LOOSE

FASTENERS AND PARTS

SSpark Plug Boot S Air Filter

S Housing Screws S Muffler

CHECK FOR DAMAGED OR WORN PARTS

Contact an authorized service dealer for re- placement of damaged or worn parts.

SFuel Tank -- Do not use unit if fuel tank shows signs of damage or leaks.

SVacuum Bag -- Do not use vacuum bag if it is torn or damaged.

-- 7 --

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Manual de Instrucciones Manuel d’Instructions Operate Your Unit Safely Know Your UnitPlan Ahead Handle Fuel with CAUTION, IT is Highly FlammableStore in a dry area out of reach of children Blower Tube AssemblyVacuum BAG Assembly Maintain Your Unit ProperlyHOW to Convert Unit from Vacuum USE to Blower USE Vacuum Tube AssemblyPrimer Button Shoulder Strap AdjustmentKnow Your Blower Throttle LeverTo Stop the Engine Operating PositionOperating Tips Before Starting Engine Fueling EngineGeneral Recommendations Starting a Cold EngineStarting a Warm Engine Starting a Flooded EngineReplace Spark Plug Inspect and Clean Unit and DecalsClean AIR Filter Check Muffler Mounting ScrewsEngine Carburetor AdjustmentsSeasonal Storage Fuel SystemCarbon build up Troubleshooting Table Cause RemedyAdjustment Crankshaft seals worn AdjustmentTions The U.S. Environmental Protection Electrolux Home PRODUCTS, INC

530163809 specifications

The Poulan 530163809, an essential tool in the realm of outdoor power equipment, showcases a remarkable blend of features, technologies, and characteristics that make it a standout choice for both homeowners and professionals alike. Designed with a commitment to performance and ease of use, this product embodies the innovation that Poulan is known for.

One of the key highlights of the Poulan 530163809 is its powerful engine. Engineered for efficiency, it boasts a robust power output that allows for effective cutting, trimming, and maintenance of various outdoor spaces. This ensures that tasks, whether small or large, can be completed with minimal effort and maximum effectiveness. The engine is designed to provide reliable performance, ensuring that users can count on it for their gardening and landscaping needs.

Another significant attribute is its lightweight construction. Weighing in at an easily manageable level, the Poulan 530163809 allows for prolonged usage without causing strain or fatigue. This feature is particularly beneficial for extended tasks, where comfort can greatly enhance productivity. Coupled with ergonomic handles, it provides users with a more comfortable grip and better maneuverability.

In terms of technology, the Poulan 530163809 incorporates advanced fuel efficiency features. The engine's design minimizes fuel consumption while maximizing power output, leading to cost savings and a reduced environmental impact. This eco-friendly focus is ideal for the modern user who is conscious of both budget and sustainability.

Additionally, the Poulan 530163809 is equipped with an easy-start system that reduces the hassle typically associated with starting outdoor equipment. This feature is particularly beneficial for those who may struggle with traditional pull-start mechanisms. With a simple press or turn, users can get their tool up and running quickly.

Durability is another characteristic that stands out with the Poulan 530163809. Constructed with high-quality materials, it is built to withstand the rigors of outdoor use. This resilience ensures that users can rely on this equipment year-round, making it a valuable addition to anyone's tool collection.

Overall, the Poulan 530163809 blends power, comfort, technological innovation, and durability into a single, efficient tool. Whether tackling garden chores or larger landscaping projects, this product is designed to deliver exceptional performance, making it a reliable choice for anyone in need of outdoor maintenance solutions.
Top Page Image Contents