Toshiba TOSHIBA NB100 manual LCD Module Replacement Procedures, Removing the LCD module

4.9 LCD Module 4 Replacement Procedures

4.9LCD Module

NOTE: ICs are fragile. Use extreme care not to apply pressure to the ICs along the edges of the LCD module.

NOTE: Dispose of used LCD panels (fluorescent (FL) tubes) as required by local ordinances or regulations.

NOTE: The LCD/FL cable must be carefully peeled away before disconnecting it from the module.

Removing the LCD module

Remove the LCD module according to the following procedures and Figures 4-19, 4-20.

1.Remove LCM/CCD Cable from CCD Board. Connector.

2.Remove two M2.5 x 5 black flat-head screws on each side securing the LCD bracket.

3.Carefully tilt the LCD module toward you.

4.Remove two M2 x 2.5 black flat head screws on each securing the LCD bracket.

5.Remove the LCD brackets.

LCM/CCD Cable

LCD module

M2.5 X 5 black flat-head screw

M2.5 X 5 black flat-head screw

Figure 4-19 Removing the LCD module and screws

TOSHIBA NB100 Maintenance Manual 4-33