4.9 LCD Module

4 Replacement Procedures

Installing the LCD Module

NOTE: LCD/FL cable must be carefully peeled away before disconnecting it from the module.

Install the LCD module according to the following procedures and Figures 4-19, 4-20.

1.Turn the LCD right side up.

2.Place the LCD bracket in the correct position and secure it with two M2 x 2.5 black flat head screws on each side.

3.Place the LCD module in the correct position and secure it with two M2.5 x 5 black flat heat screws on each side.

4.Connect the LCM/CCD Cable to Connector on CCD Board.

CAUTION: When installing the LCD module, please follow below instruction:

When plug in LCD/FL cable into LCD module connector, need to plug horizontally. For Sharp panel, if LCD/FL cable connector is not plugged horizontally, it may be damaged.

TOSHIBA NB100 Maintenance Manual

4-35

Page 166
Image 166
Toshiba TOSHIBA NB100 manual Installing the LCD Module