4 Replacement Procedures | 4.1 General |
Tools and Equipment
For your safety and that of other people in the working environment, it is strongly recommended that you use electrostatic discharge (ESD) equipment. The proper use of this equipment will ensure successful repair work and reduce the costs for repairing damaged components. The equipment and tools required for disassembly and reassembly are:
One 2 mm Phillips screwdriver
One 4 mm
Torx screwdriver
Tweezers (for pulling out screws)
ESD mats (for the floor and work desks)
An ESD wrist strap or heel grounder
Air ionizers (for highly electrostatic sensitive areas)
A plastic card (in credit card size)
Screw Tightening Torque
To secure screws, follow the torque values listed below. Over tightening can damage components and screws. Under tightening can loosen the screw or cause screws to come off, which may result in short circuits or other damage.
M2 (2 mm) | 0.22 N･m (2.2 kgf･cm) |
M2.5 (2.5 mm) | 0.36 N･m (3.5 kgf･cm) |
M3 (3 mm) | 0.51 N･m (5.0 kgf･cm) |
M2.5x4 PSP TITE screws | 0.204 N･m (2.0 kgf･cm) |
M2.5x6 GIZA TITE screws | 0.36 N･m (3.5 kgf･cm) |
TOSHIBA NB100 Maintenance Manual |
