Poulan 2250, 2450, 2550, 2550 SE, 2555 instruction manual Limited Warranty, Load Adjustment Engine

Page 16

TROUBLESHOOTING TABLE

WARNING: Always stop unit and disconnect spark plug before performing all of the recommended remedies below except remedies that require operation of the unit.

 

TROUBLE

CAUSE

REMEDY

 

 

 

 

 

Engine will not

1. Ignition switch off.

1. Move ignition switch to ON.

 

start or will run

2. Engine flooded.

2. See “Difficult Starting” in

 

only a few

 

 

 

Operation Section.

 

seconds after

3. Fuel tank empty.

3. Fill tank with correct fuel mixture.

 

starting.

4. Spark plug not firing.

4. Install new spark plug.

 

 

5. Fuel not reaching

5. Check for dirty fuel filter; replace.

 

 

 

carburetor.

 

Check for kinked or split fuel line;

 

 

 

 

 

repair or replace.

 

 

 

 

 

 

Engine will

1.

Carburetor requires

1. See “Carburetor Adjustment” in the

 

not idle

 

adjustment.

 

Service and Adjustments Section.

 

properly.

2.

Crankshaft seals worn.

2. Contact an authorized service dealer.

 

 

 

 

 

 

 

Engine will not

1.

Air filter dirty.

1.

Clean or replace air filter.

 

accelerate,

2.

Spark plug fouled.

2.

Clean or replace plug and regap.

 

lacks power,

3.

Chain brake engaged.

3.

Disengage chain brake.

 

or dies under

4.

Carburetor requires

4.

Contact an authorized service dealer.

 

a load.

 

adjustment.

 

 

 

 

 

 

 

Engine

1. Too much oil mixed with

1. Empty fuel tank and refill with

 

smokes

 

gasoline.

 

correct fuel mixture.

 

excessively.

 

 

 

 

 

Chain moves

1. Idle speed requires

1. See “Carburetor Adjustment” in the

 

at idle speed.

 

adjustment.

 

Service and Adjustments Section.

 

 

2. Clutch requires repair.

2.

Contact an authorized service dealer.

 

 

 

 

 

 

LIMITED WARRANTY

ELECTROLUX HOME PRODUCTS, INC., warrants to the original purchaser that each new PoulanR brand gasoline chain saw is free from defects in material and workman- ship and agrees to repair or replace under this warranty any defective gasoline chain saw as follows from the original date of pur- chase.

1YEAR - Parts and Labor, when used for Household purposes.

60DAYS - Parts and Labor, when used for Commercial, Professional, or Income Pro- ducing purposes.

30DAYS - Parts and Labor, if used for rental purposes.

This warranty is not transferable and does not cover damage or liability caused by im- proper handling, improper maintenance, or the use of accessories and/or attachments not specifically recommended by ELEC- TROLUX HOME PRODUCTS, INC., for this chain saw. Additionally, this warranty does not cover damage caused by improper han- dling, improper maintenance, or if the saw is altered in any way which in our judgement af- fects its condition or operation. This warranty does not cover tune--up, spark plugs, filters, starter ropes, starter springs, chain sharpen- ing, bars, chains, and other parts which wear and require replacement with reasonable use during the warranty period. This warran-

ty does not cover predelivery set--up, instal- lation of guide bar and chain, and normal ad- justments explained in the instruction manual such as carburetor adjustments and chain tension adjustments. This warranty does not cover transportation costs.

THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.

NO CLAIMS FOR CONSEQUENTIAL OR OTHER DAMAGES WILL BE ALLOWED, AND THERE ARE NO OTHER EXPRESS WARRANTIES EXCEPT THOSE EXPRESS- LY STIPULATED HEREIN.

SOME STATES DO NOT ALLOW LIMITA- TIONS ON HOW LONG AN IMPLIED WAR- RANTY LASTS OR THE EXCLUSION OR LIMITATIONS OF INCIDENTAL OR CONSE- QUENTIAL DAMAGES, SO THE ABOVE LIMITATIONS OR EXCLUSION MAY NOT APPLY TO YOU.

The policy of ELECTROLUX HOME PRO- DUCTS, INC., is to continuously improve its products. Therefore, ELECTROLUX HOME PRODUCTS, INC., reserves the right to change, modify, or discontinue models, de- signs, specifications, and accessories of all products at any time without notice or obliga- tion to any purchaser.

16

Image 16
Contents English Español Français 16/04Safety Rules Identification of SymbolsPlan Ahead Operate Your SAW Safely Maintain Your SAW in Good Working OrderHandle Fuel with Caution KickbackKickback Safety Features Reduce the Chance of KickbackMaintain Control Avoid Obstructions Clear The Working AreaChain Brake and CKA Angle Computed kickback angle CKA TableAssembly Inside view Chain Brake Adjustment located on Chain BrakeAttaching the BAR & Chain If not Chain Brake NutsAdjusting the tension Chain Tension Including units with chain already installedChecking the tension CuttersON/STOP Switch Know Your SAWThrottle Trigger Throttle LockoutStarting Fueling EngineBAR and Chain Lubrication Important Points to RememberStarting a Warm Engine Cutting MethodsImportant Points Felling Large Trees Tree Felling TechniquesNotch CUT and Felling the Tree Bucking Using a LOG or Support Stand Cutting a Fallen TreeTypes of Cutting Used for Bucking Bucking Without a SupportService PruningLimbing and Pruning Important Points LimbingCleaning the air filter Carburetor AdjustmentBAR Maintenance Inspect Muffler and Spark Arresting ScreenNeed ASSISTANCE? Load Adjustment Engine Limited WarrantyEmpty fuel tank and refill with Ligations The U. S. Environmental Electrolux Home PRODUCTS, INCIntermediate 125 hours Extended 300 hours

2250, 2450, 2550, 2550 SE, 2555 specifications

The Poulan Pro chainsaw series, including the models 2250, 2450, 2550, 2550 SE, and 2555, represents a solid choice for both professionals and hobbyists in need of reliable cutting performance. Each model comes with distinct characteristics while sharing common technological innovations that define their functionality and efficiency.

The Poulan 2250 is designed for durability and ease of use. Weighing in at a manageable size, this chainsaw features a 50cc engine that delivers impressive power for a variety of cutting tasks. One of its standout features is the automatic oiler, which ensures that the chain is always lubricated, reducing wear and enhancing performance over time.

Next in line is the Poulan 2450, which further builds on the strengths of its predecessor. This model boasts a larger cutting capacity, facilitating challenges posed by thicker materials. It incorporates an easy-start system often appreciated by users who want to avoid the frustration of hard starts, making it a great option for regular maintenance tasks around the yard.

The Poulan 2550 exhibits an even greater commitment to power and efficiency. With a robust 45cc engine, this model effectively combines cutting power with manageable weight. It features an air filter system that promotes longer intervals between cleaning, making it easier for users to maintain the chainsaw in pristine working condition.

The Poulan 2550 SE takes the versatility up a notch. This model is equipped with an ergonomic design that reduces operator fatigue, especially during extended use. It also includes a specialized vibration dampening system, ensuring a more comfortable experience while cutting, which is particularly beneficial for professionals who rely on their equipment for hours on end.

Lastly, the Poulan 2555 combines all the best features from its predecessors while integrating advanced technologies to enhance user experience. This model is designed for straightforward maintenance, featuring tool-less access to the air filter and spark plug, making it easy for users to perform routine upkeep. Additionally, the 2555 is built with a powerful engine that delivers high torque, enabling efficient cutting of tougher materials.

Overall, the Poulan Pro chainsaw series embodies a tradition of reliability and innovation, suitable for a range of users, from casual gardeners to professional landscapers. With features like automatic oilers, ergonomic designs, and advanced air filtration systems, these chainsaws are tailored to meet the demands of various cutting applications, ensuring that users can tackle their tasks with confidence and ease.