Poulan 952711924, 115270726, PP250PT Seasonal Storage, Fuel System, Engine, Other, Porting

Page 19

STORAGE

WARNING: Perform the following steps after each use:

SAllow engine to cool before storing or trans-

porting.

SStore unit and fuel in a well ventilated area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc.

SStore unit with all guards in place. Position unit so that any sharp object cannot acci-

dentally cause injury.

SStore unit and fuel well out of the reach of children.

SEASONAL STORAGE

Prepare unit for storage at end of season or if it will not be used for 30 days or more.

If your unit is to be stored for a period of time: S Clean the entire unit before lengthy

storage.

SStore in a clean dry area.

SLightly oil external metal surfaces.

FUEL SYSTEM

Under FUELING ENGINE in the OPERA- TION section of this manual, see message la- beled IMPORTANT regarding the use of ga- sohol in your engine.

Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to the gasoline in the fuel tank or fuel storage container. Fol- low the mix instructions found on stabilizer container. Run engine at least 5 minutes after adding stabilizer.

HELPFUL TIP

During storage of your gas/ oil mixture, the oil will sepa- rate from the gas.

We recommend that you shake the gas can weekly to insure proper blending of the gas and oil.

ENGINE

SRemove spark plug and pour 1 teaspoon of 40:1, 2-cycle engine oil (air cooled) through the spark plug opening. Slowly pull the

starter rope 8 to 10 times to distribute oil.

SReplace spark plug with new one of recom-

mended type and heat range.

SClean air filter.

S Check entire unit for loose screws, nuts, and bolts. Replace any damaged, broken, or worn parts.

SAt the beginning of the next season, use only fresh fuel having the proper gasoline to oil ratio.

OTHER

SDo not store gasoline from one season to

another.

SReplace your gasoline can if it starts to rust.

19

Image 19
Contents Manual de Instrucciones Manuel d’Instructions Identification of Safety Symbols Identification of Safety Symbols Operate Your Pruner Safely Safety RulesChain when the engine is running Plan AheadReduce the Chance Kickback Maintain Your Pruner in Good Working OrderHandle Fuel with Caution KickbackLine Trimmer Safety Kickback Safety FeaturesFor Optional Attachments Running or when cutting blade is moving Edger SafetyBLOWER/VACUUM Safety Brushcutter SafetyHedge Trimmer Safety Cultivator SafetySnow Thrower Safety Other hidden hazards AssemblyInstalling Pruner ATTACH- Ment Tools RequiredAdjusting the Assist Handle Shoulder Strap AssemblyTo Relocate Shoulder Strap Clamp Operation Starting a Cold Engine HOW to Stop Your UnitHOW to Start Your Unit BAR and Chain LubricationRemoving Pruner Attachment or Other Optional ATTACH- Ments Installing Optional ATTACH- MentsInstalling Attachment Hanger Operating the CouplerPruning Technique Pruning Important PointsFoot Maintenance Service and Adjustments To Sharpen Chain Chain ReplacementTo Replace Chain Carburetor Idle Speed Adjustment Chain AdjustmentOther Seasonal StorageFuel System EngineSee Fueling Engine in Operation Limited WarrantyTroubleshooting Table Cause Remedy Empty fuel tank and refill withLigations The U.S. Environmental Statesville RoadPlacement and Repair of Emission