Clock and Calendar

SENSOR DATA TRANSMISSION

Data is sent from the sensor(s) every 60 Seconds. The

reception icon shown in the Outdoor Temperature Area

indicates the status.

ICON

DESCRIPTION

Main unit is searching for

sensors.

At least 1 channel has been

found.

Sensor 1 is sending data. (The

number shows which sensor is

selected.)

--- shows in Temp

The selected sensor cannot be

found. Search for the sensor or

Area

check batteries.

SELECT SENSOR CHANNEL

Press CHANNEL on the main unit, to switch between

sensors 1-5.

The house icon shows the selected remote sensor.

To auto-scan between sensors, press and hold CHANNEL for 2 seconds. Each sensor's data will be displayed for 3 seconds.

To end auto-scan, press CHANNEL or MEMORY.

SEARCH FOR SENSOR

To search for a Thermo sensor, simultaneously press and hold CHANNEL and MEMORY for 2 seconds.

NOTE If the sensor is still not found, check the batteries.

This product tracks the time and date based on radio- controlled signals from the RTHR328N remote sensor, or manual settings that you enter.

RADIO-CONTROLLED CLOCK

The time and date are automatically updated by radio- controlled clock signals from official time-keeping organizations in Frankfurt (Germany) and Rugby (England) unless you disable this feature. The signals are collected by the remote sensor (RTHR328N) whenever it is within 1500 km (932 miles) of a signal.

Initial reception takes 2-10 minutes, and is initiated when you first set up the unit, and whenever you press RESET. Once complete, the reception icon will stop blinking.

The reception icon shown in the Clock Area indicates 2 factors:

•Connection between the main unit and the sensor

that collects RF signals ( )

BAR289 ENG R7 OP

Black

•RF signal reception ( )

How these signals work together:

ICON

MEANING

The unit has contact with the remote sensor and has synchronized the time.

The unit has contact with the remote sensor but the time has not been synchronized.

The unit has lost contact with the remote sensor but the time is synchronized.

The unit has lost contact with the remote sensor and the time is not synchronized.

The unit cannot reach the remote sensor.

NOTE To force a manual search for the RF clock reception, press and hold SEARCH on the sensor (RTHR328N).

TURN RADIO-CONTROLLED CLOCK ON / OFF

If you wish to manually set the clock, you must first disable the radio-controlled feature. To do this, make sure you are not in Setting Mode, then press and hold DOWN on the main unit for 2 seconds. To enable it, hold UP for 2 seconds.

•When the RF clock is enabled this icon will appear on the display.

•When the RF clock is disabled this icon will NOT appear on the display.

SET CLOCK

You only need to do this if you have disabled the radio- controlled clock, or if you are too far from a RF signal.

1.Press and hold MODE / LIGHT for 2 seconds to enter Setting Mode.

2.The setting will blink to indicate it can now be changed.

3.Press UP or DOWN to change the setting.

4.Press MODE / LIGHT to confirm the setting and move to the next one. The order of the settings is: time zone hour offset (+ / -23 hours), 12 / 24 hour format, hour, minute, year, date / month format, month, date, display language and hourly chime (ON / OFF).

8/20/04, 11:00 PM