GETTING STARTED
BATTERIES
Batteries are supplied with this product:
• | Main unit | 4 x | (AA) 1.5V |
• | Remote control | 2 x | (AAA) 1.5V |
• | Remote sensor | 2 x | (AA) 1.5V |
Insert batteries before first use, matching the polarity as shown in the battery compartment. For best results, install batteries in the remote sensor before the main unit. Press RESET after each battery change.
To install the main unit batteries:
To install the remote control batteries:
SENSOR SET UP
1.Open the battery compartment with a small Phillips screwdriver and insert the batteries matching the polarity (+ and
2.Set the channel by pressing the CHANNEL button to the required number. If you are using more than one sensor, select a different channel for each sensor.
3.Slide the EU / UK switch to the setting which best suits your location.
4.Press RESET.
5.Place the sensor near the main unit.
6.Press SEARCH to manually initiate signal sending between the sensor and the main unit. The reception icon on the main unit will blink for approximately 3 minutes while it is searching for the sensor. (Refer to the "Sensor Data Transmission" section for more information.)
7.Press the °C / °F button to select the setting you want.
8.Close the remote sensor battery compartment.
9.Secure the sensor in the desired location using the wall mount or table stand.
EN
NOTE Do not use rechargeable batteries.
shows when batteries are low.
UNIT | LOCATION |
|
|
Main | Clock / Alarm / Calendar Area |
|
|
Remote Sensor | Outdoor Temperature Area |
|
|
NOTE It is recommended that you use alkaline batteries with this product for longer performance.
REMOTE SENSOR (RTHR328N)
This product is shipped with the RTHR328N Remote Sensor. The main unit can collect data from up to 5 sensors.
The THGR328N and THR228N sensors are also compatible with this weather station. (Additional sensors are sold separately. Contact your local stockist for more information.)
The RTHR328N sensor collects temperature readings and signals from official
BAR289 ENG R7 OP | 5 |
Black
5
To fold out the stand:
1 |
2 |
For best results:
•Insert the batteries and select the unit, channel, and radio signal format before you mount the sensor.
•Place the sensor out of direct sunlight and moisture.
•Do not place the sensor more than 30 metres (100 feet) from the main (indoor) unit.
•Position the sensor so that it faces the main (indoor) unit, minimizing obstructions such as doors, walls, and furniture.
•Place the sensor in a location with a clear view to the sky, away from metallic or electronic objects.
•Position the sensor close to the main unit during cold winter months as
NOTE The transmission range may vary and is subject to the receiving range of the main unit.
You may need to experiment with various locations to get the best results.
8/20/04, 11:00 PM