SET UP Base Station, Clock Reception | Oregon Scientific WMR100NA

SET UP BASE STATION

NOTE Install batteries in the remote sensor before the base station matching the polarities (+ and -).

For continuous use, please install the AC adapter. The batteries are for back-up use only.

NOTE Make sure the adapter is not obstructed and is easily accessible to the unit.

NOTE The base station and adapter should not be exposed to wet conditions. No objects ﬁlled with liquid, such as vases, should be placed on the base station and adapter.

Install the base station batteries (4 x UM-3 / AA) matching the polarity + and -. Press RESET after each battery change.

NOTE Do not use rechargeable batteries. It is recommended that you use alkaline batteries with this product for longer performance.

NOTE Batteries should not be exposed to excessive heat such as sunshine or ﬁre.

The battery icon indicator		may appear in the
following areas:

AREA	MEANING

	Battery in the base station is
Weather Forecast Area	low.	will show when AC
	adapter is disconnected.

	The displayed channel
Temperature / Heat	indicates the outdoor
Index / Wind Chill Area	sensor for which battery
	is low.

Wind Speed / Wind	Battery in the wind
Direction Area	sensor is low.

UVI / Barometer /	Battery in the UV / Rain
Rainfall Area	sensor is low.

BASE STATION

CHANGE DISPLAY / SETTING

To change the display and settings, use the following buttons on the rotating dial: SELECT, MEMORY /

ON / OFF, MODE and ALARM.

In addition, the UNIT and SEARCH buttons located at the bottom of the base station allows pre-setting of the remote sensor channels and the measurement units for display.

TIP To exit from the setting mode, push any button. Alternatively, the base station will automatically exit after 30 seconds.

CLOCK RECEPTION

This product is designed to synchronize its calendar clock automatically once it is brought within range of a radio signal:

WMR100N:

•EU: DCF-77 signal: within 1500 km (932 miles) of Frankfurt, Germany.

•UK: MSF-60 signal: within 1500 km (932 miles) of Anthorn, England.

WMR100NA:

•WWVB-60 signal: within 3200km (2000 miles) of Fort Collins Colorado.

WMR100N only - slide the EU / UK switch to the appropriate setting based on your location. Press RESET whenever you change the selected setting.

The reception icon will blink when it is searching for a signal. If the radio signal is weak it can take up to 24 hours to get a valid signal reception.

indicates the status of the clock reception signal.

ICON MEANING

Time is synchronized. Receiving signal is strong

Time is not synchronized. Receiving signal is weak

To enable (and force a signal search) / disable the clock radio reception (clock synchronization):

1.Press SELECT to navigate to the Clock / Calendar / Alarm Area. will show next to the Area.

2.Press and hold SEARCH.

appears when it is enabled.