EN
3.Insert the versatile plastic base into the pole. Align the holes of the pole with the holes of the plastic base.
4.Secure the plastic base by inserting the screw and screwing it tightly into the holes of the plastic base and pole.
IMPORTANT The sensor should be positioned in an open area away from trees or other obstructions.
5.Hammer pole (cone end down) into the ground at the desired spot until versatile plastic base is level with the ground.
TIP Place a block of wood between the pole and the hammer to prevent damage to the pole.
To mount the wind sensor:
13 |
14 |
13.Insert the wind vane into the attachment bracket.
14.Screw aluminium pole firmly into place.
IMPORTANT For best results, point the wind vane North.
Securing the assembled remote unit:
6 |
7 |
8 
9
15.Insert the 2 rectangular base legs through the holes of the versatile base and hammer down.
16.Using the string, tie a knot on the eye pins. Hammer each eye pin into the ground at a 90° angle.
6.Assemble middle pole on top of the bottom one.
7.Using two screws, fix it firmly into place.
8.Assemble top pole on top of the middle one.
9.Using two screws, fix it firmly into place.
11
10
10.Slide the vertical attachment bracket on top of the top pole.
11.Using two screws, fix it firmly into place.
To mount the temperature / humidity sensor:
12
12. Slide outdoor sensor onto vertical attachment
bracket.
6
IMPORTANT Using the fasteners, tighten the string. To tighten, pull fastener down.
To loosen, thread the string up through the fastener eyelets.
ALTERNATIVE SET UP: REMOTE WIND SENSOR ON EXISTING POLE
3
1
2
1.Secure the plastic base onto existing pole with U- bolts, washers and bolts.
2.Insert the horizontal attachment bracket into the base.
3.Using a screw, fix firmly into place.