Rhino Mounts GK6072 manual Maintenance

Page 86

MAINTENANCE

1

FIGURE 8

2 4

3

5

3/4"

10 LBS.

Locknut

Flatwasher

Spacer

FlatwasherBolt

MAINTENANCE

BELT ADJUSTMENT PROCEDURE (All Models except 11')

Adjust the tension in the drive belts, item1, properly so that they deflect 3/4" when a force of approximately 10 lb. is applied as indicated.

Tighten drive belts by loosening nut, items 2 & 5, and turn nut, item 3 against the anchor plate until proper tension is reached. DO NOT OVERTIGHTEN. Tighten jam nut, item 4., and nut item 2. And retighten item 5. FIG. 8.

Replace the belt safety shields using wing nuts.

BELT INSTALLATION (All Model except 11')

NOTE: Always replace belts as matched set of two.

To replace drive belts (1), remove belt shields and loosen nuts (2, and 3). Loosen and remove nut (5). Disassemble tensioning idler noting location of all loose parts.Loosen front pair of gearbox mount retaining bolts. Remove rear gearbox mount retaining bolts. Note location of shim washers if present so they can be reinstalled later. This allows gearbox mount to be raised so belts can be inserted and removed between top of deck and gearbox shaft. Once belts are in place on large drive sheave, reinstall and tighten gearbox retaining hardware. Locate rear of gearbox mount at same elevation as it was, before being removed. Reassemble tensioning idler with belt between idler and bracket. Route belts as shown in layout and tension per adjustment procedure.

GK6072 08/01

Maintenance Section 5-6

© 2004 Alamo Group Inc.

Image 86
Contents GK6072 To the OWNER/OPERATOR/DEALER Safety Training Makes the Difference Page Table of Contents Page Safety Section Safety Peligro ¡LEA EL InstructivoFalling off can result in serious injury or death Following rules Drugs or alcohol. SG-27 GK6072 08/01 Alamo Group Inc Wait a minute...Save a life Stop Mowing if Passersbyare Within 100 Yards Unless Parts Information See Your SERVIS-RHINO Dealer14A QTY Level DescriptionNot Shown Page Safety Federal Laws and Regulations Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Exceed Horsepower Recommendations Dealer SET-UP Instructions Frame AttachmentStandard Position Extended Position Caster Wheel Attachments Page Operation Section Operation Attaching Mower to Tractor Lift TypeStarting & Stopping Cutter Cutting Height AdjustmentDriveline Attachment to Tractor Detaching and Storing Cutting SpeedCutting Tips Driveline Length Check Procedure Before Operating or Transporting this MowerDriveline Length Front Gauge Wheel Interference CheckProblem Possible Cause Remedy StreakingDamaged Belt Maintenance Section Description Frequency Lubrication InformationLubrication Fitting Location Gearbox Gauge Wheel AssembliesDriveline Lubrication Blade Spindle LubricationBlade Sharpening Blade InstallationBlade Servicing Blade RemovalMaintenance Storage Proper Torque for FastenersMaintenance Servicing Driveline Shields Figure SERVIS-RHINO To the OWNER/OPERATOR/DEALER GK60/72-OMWPL-08/01 00767471C Printed U.S.A RHINO-SERVIS SERVIS-RHINOWARRANTY Registration Information Page Dealer Copy Page Customer Copy