Rhino Mounts GK6072 manual Servicing Driveline Shields Figure

Page 89

MAINTENANCE

SERVICING DRIVELINE SHIELDS (Figure 11)

1.Remove locking screw #1.

2.Twist shield tube in relation to cone to align white tab with slot in cone.

3.Pull on shield tube to remove complete shield from assembly.

4.Shield Bearing is split and can be removed by pulling ends apart. Note positioning of bearing before removing.

5.To replace flex cone on shield tube, cut old cone off with knife. Remove chain assembly. Heat collar of the new one in a water bath (approx 80 deg. C or 176 deg. F) and pull cone over end of shield tube. Rotate shield cone to align notches in shield tube end with slots in cone. Reattach chain assembly.

6.To reassembly shield, insert over profile tube, align tabs on shield bearing with slots in shield, insert tabs into slots and twist cone in relation to shield tube so that bearing tabs are located between slots in shield cone. Reinstall locking screw.

1

FIGURE 11

GK6072 08/01

Maintenance Section 5-9

© 2004 Alamo Group Inc.

MAINTENANCE

Image 89

Contents GK6072 To the OWNER/OPERATOR/DEALER Safety Training Makes the Difference Page Table of Contents Page Safety Section Safety ¡LEA EL Instructivo PeligroFalling off can result in serious injury or death Following rules Drugs or alcohol. SG-27 GK6072 08/01 Alamo Group Inc Wait a minute...Save a life Stop Mowing if Passersbyare Within 100 Yards Unless See Your SERVIS-RHINO Dealer Parts InformationQTY Level Description 14ANot Shown Page Safety Federal Laws and Regulations Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Frame Attachment Exceed Horsepower Recommendations Dealer SET-UP InstructionsStandard Position Extended Position Caster Wheel Attachments Page Operation Section Attaching Mower to Tractor Lift Type OperationStarting & Stopping Cutter Cutting Height AdjustmentDriveline Attachment to Tractor Detaching and Storing Cutting SpeedCutting Tips Before Operating or Transporting this Mower Driveline Length Check ProcedureFront Gauge Wheel Interference Check Driveline LengthStreaking Problem Possible Cause RemedyDamaged Belt Maintenance Section Description Frequency Lubrication InformationLubrication Fitting Location Gauge Wheel Assemblies GearboxBlade Spindle Lubrication Driveline LubricationBlade Servicing Blade InstallationBlade Sharpening Blade RemovalMaintenance Proper Torque for Fasteners StorageMaintenance Servicing Driveline Shields Figure SERVIS-RHINO To the OWNER/OPERATOR/DEALER GK60/72-OMWPL-08/01 00767471C Printed U.S.A RHINO-SERVIS SERVIS-RHINOWARRANTY Registration Information Page Dealer Copy Page Customer Copy