Rhino Mounts GK6072 manual Driveline Length, Front Gauge Wheel Interference Check

Page 78

OPERATION

OPERATION

DRIVELINE LENGTH

Raise mower to full transport or until driveline just hits deck at front. If distance between colored tape and outer shield tube is 1-9/16 or less, drive tubes should be shortened per Figure 4. Always maintain 1-9/16 clearance when operated in shortest working position. shorten inner and outer guard tubes equally. Shorten inner and outer sliding profiles by the same amount that the shield tubes were shortened. Round off all sharp edges and remove burrs. Grease sliding profiles. FIGURE 3.

1-9/16"

FIGURE 3

Lower mower to lowest position possible. Check distance from colored tape to end outer shield tube. Driveline tube engagement must always exceed 12 inches. If not consult dealer to obtain longer driveline.

FRONT GAUGE WHEEL INTERFERENCE CHECK

Do not operate mower until this interference check has been performed. If you change tractors, you must perform the check for that mounting.

Raise mower with tractor hydraulics to maximum height of tractor lift.

Pivot both front gauge wheels forward and check that there is clearance between gauge wheels and tractor tires.

If there is interference, you must move hitch pin to extended position (See assembly section). Move tractor tires inward to obtain clearance or lower mower until clearance exists. Set 3-Point quadrant stop so mower cannot be raised beyond set point. FIGURE 4.

 

Figure 4 - Front Gauge Wheel Clearance

GK6072 08/01

Operation Section 4-6

© 2004 Alamo Group Inc.

Image 78
Contents GK6072 To the OWNER/OPERATOR/DEALER Safety Training Makes the Difference Page Table of Contents Page Safety Section Safety Peligro ¡LEA EL InstructivoFalling off can result in serious injury or death Following rules Drugs or alcohol. SG-27 GK6072 08/01 Alamo Group Inc Wait a minute...Save a life Stop Mowing if Passersbyare Within 100 Yards Unless Parts Information See Your SERVIS-RHINO Dealer14A QTY Level DescriptionNot Shown Page Safety Federal Laws and Regulations Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Exceed Horsepower Recommendations Dealer SET-UP Instructions Frame AttachmentStandard Position Extended Position Caster Wheel Attachments Page Operation Section Operation Attaching Mower to Tractor Lift TypeCutting Height Adjustment Driveline Attachment to TractorStarting & Stopping Cutter Cutting Speed Cutting TipsDetaching and Storing Driveline Length Check Procedure Before Operating or Transporting this MowerDriveline Length Front Gauge Wheel Interference CheckProblem Possible Cause Remedy StreakingDamaged Belt Maintenance Section Lubrication Information Lubrication Fitting LocationDescription Frequency Gearbox Gauge Wheel AssembliesDriveline Lubrication Blade Spindle LubricationBlade Sharpening Blade InstallationBlade Servicing Blade RemovalMaintenance Storage Proper Torque for FastenersMaintenance Servicing Driveline Shields Figure SERVIS-RHINO To the OWNER/OPERATOR/DEALER GK60/72-OMWPL-08/01 00767471C Printed U.S.A RHINO-SERVIS SERVIS-RHINOWARRANTY Registration Information Page Dealer Copy Page Customer Copy