Scag Power Equipment MAG manual Tilting the Mower Deck, Mower Cutting Height Gauge

Page 18

4

3

2

1

 

 

 

 

 

 

Figure 4-11 Mower Cutting Height Gauge

Section 4

4.15 TILTING THE MOWER DECK

CAUTION:

Do not tilt the deck with the mower blades rotating. Engage the blade brake before tilting the deck. Bodily injury or damage to the mower or property could result.

1.Stop the traveling movement of the mower and engage the blade brake.

2.Use the deck tilt control switch on the instrument panel

to raise the deck.

3.Before lowering the deck, observe that there are no objects under the deck. Remove any objects then, activate the deck tilt switch to lower the deck.

16

Image 18
Contents Operators Manual Remember Your Mower is only AS Safe AS the Operator Introduction Direction ReferenceServicing the Engine and Drive Train Components Signal Words Before Operation ConsiderationsOperation Considerations Maintenance Considerations Safety and Instructional Decals Keep Clear Contact can InjureEngine ElectricalTractor Cutter Deck Weights and DimensionsTractor Contd Hydraulic SystemOperating Instructions Controls and Instrument IdentificationLevers Safety Interlock System Operator Comfort Adjustments Diesel Engine BREAK-INStarting the Diesel Engine Seat Adjustment Adjusting Ground Speed and DirectionEngaging the Mower Hillside OperationStopping After OperationAdjusting Cutting Height Moving Mower with the Engine StoppedRecommendations for Mowing Tilting the Mower Deck 11 Mower Cutting Height GaugeTroubleshooting Cutting Conditions Condition Cause CureTroubleshooting Troubleshooting Parking Brake Adjustment FORWARD/REVERSE Neutral AdjustmentThrottle Control Linkage Adjustment FAN Belt AdjustmentCutter Brake Linkage Cutter Drive Belt Adjustments Pump Drive Belt AdjustmentElectric Clutch Drive Belt Adjustment Alternator Belt AdjustmentCutter Deck Adjustments Belt AlignmentBlade Cutting Height Adjustment 11 Measuring Cutting Edge HeightMAG-61, MAG-72 Cutter Deck Ref. Part Mag Mag Number Description Descripton MAG-61, MAG-72 Deck Support MAG-61, MAG-72 Cutter Deck Support Rider Frame Part Number Description Engine Deck Engine Deck RADIATOR/OIL Cooler RADIATOR/OILCOOLER Muffler and AIR Cleaner Ref. Part No. Number Description Deck Drive System Part Number Description Pump and FAN Drive Systems Part Ref. Part Number Description No. Number Instrument Panel Ref. Number Description Wiring Harness and Electrical Components Switch, Ignition Cutter Brake Linkage Grip, Clutch Lever Parking Brake Linkage 48093 Grip, Handle 45716 Throttle Linkage 481243 FORWARD/REVERSE Linkage Bolt, Neutral Adjustment, 3/8-24 x 6-3/4 Fuel Tank and Lines 46933 Hydraulic Circuits Ref. Part Number Description Control Panel Heavy Duty Commercial Grease Fitting Lubrication Chart Page Engine Tractor Contd Limited WARRANTY-COMMERCIAL Equipment 1996